1976 Pontiac Firebird Formula Coupe 2-door 6.6l on 2040-cars
Mission Viejo, California, United States
Pontiac Firebird for Sale
- 455hp 01 ws6. 11k in parts, fast car with beefed up drivetrain. clean and fast!!(US $12,500.00)
- 1967 pontiac firebird with 428/375hp yh code engine, solid complete project car(US $5,500.00)
- 1979 pontiac firebird esprit coupe 2-door 5.7l(US $5,200.00)
- 1968 pontiac firebird restoration needs to be completed. arizona car. very solid
- 1967 firebird sprint repowered w/sbc 283 high perf engine
- 1999 pontiac trans am
Auto Services in California
Zenith Wire Wheel Co ★★★★★
Yucca Auto Body ★★★★★
World Famous 4x4 ★★★★★
Woody`s & Auto Body ★★★★★
Williams Auto Care Center ★★★★★
Wheels N Motion ★★★★★
Auto blog
Junkyard Gem: 2004 Pontiac Vibe GT
Fri, Jun 26 2020The New United Motor Manufacturing plant in Fremont, California, built Toyota-derived machinery — badged as Toyotas, Chevrolets, Geos, and Pontiacs— from 1984 through 2010, and some of the very last vehicles that left the assembly line were Pontiac Vibes. The Vibe, sibling to the Toyota Matrix, mostly served as a ho-hum transportation appliance and/or fleet car, but a factory-hot-rod GT version could be purchased. Today's Junkyard Gem is one of those rare GTs, complete with the nearly unheard-of six-speed manual transmission, found in a self-service yard in northeastern Colorado. The regular Vibe had 123 or 130 horsepower, depending on the number of driven wheels, but the Vibe GT got the same 1.8-liter 2ZZ engine that went into the Celica GT-S. 180 horsepower, which was enough to make the 2,800-pound Vibe GT keep up with the 3,108-pound/215-horse Chrysler PT Cruiser Turbo that year. Sadly, no race series pitting Vibe GTs against PT Cruiser Turbos and Chevy HHR SSs on road courses ever materializedÂ… but it's not too late. The Vibe GT has something you couldn't get in a PT Cruiser or Chevy HHR, though: a six-speed manual transmission as standard equipment. In fact, the six-speed was the only transmission offered in the early Vibe GTs (an automatic became an option later on). You'll find plenty of three-pedal econoboxes from this era, because they were significantly cheaper than their slushbox-equipped counterparts, but the Vibe GT had plenty of competition from sportier-looking cars with manual transmissions in 2004. Not many were sold. This car is covered with nasty dents from golf-ball-sized hail (all too common in High Plains Colorado), so it may have been an insurance total that nobody wanted at auction. Sold in Wyoming, will be crushed in an adjacent state. This content is hosted by a third party. To view it, please update your privacy preferences. Manage Settings. Fuel for the soul. This content is hosted by a third party. To view it, please update your privacy preferences. Manage Settings. The kids, they were crazy about the Vibe (well, maybe not). This content is hosted by a third party. To view it, please update your privacy preferences. Manage Settings. Toyota had right-hand-drive Matrixes brought over to Japan from Canada, but a NUMMI-built version of the Vibe could be purchased there for a few years as well. This was the Voltz, and its advertising seems notably frantic even by the standards of Japanese car commercials.
GM recalling 778,000 Cobalts and G5s, six deaths reported
Thu, 13 Feb 2014General Motors has announced that it will be recalling 778,562 compact cars after six people were killed in accidents, partially due to the airbags' failure to deploy. An issue with the ignition switch is causing the airbag issues, as well as causing the engine and other components to shut off without warning. The recall covers the 2005 to 2007 model year Chevrolet Cobalt and 2007 Pontiac G5. (Note that the Cobalt pictured above is a 2009 model.)
According to a report from Automotive News, a number of factors can cause the ignition to switch out of the run position, including weights on the key ring, rough or bumpy roads or other "jarring" events. Any of these situations could lead to some vehicle components not functioning properly.
There have been five fatal front-impact crashes that took the lives of six people, although as a GM spokesman noted, all five of the crashes happened off road and at high speed. In each of these cases, though, the lack of airbags wasn't the only lethal factor - alcohol and failure to wear a seat belt also played a role. Outside of the fatal accidents, there have been 17 other crashes where airbags didn't deploy. It's unclear if any of these crashes were caused by the engine shutting off.
Gordon Murray, F1-driven production and .. the Pontiac Fiero
Tue, Oct 31 2017Gordon Murray's design and engineering chops are unquestionable. But does his carmaking approach owe something to the short-lived Pontiac Fiero, a scrappy little car program that emerged from GM against serious resistance? Murray had a Formula One career that ran from 1969 to 1991, with stints at Brabham ('69 to '86) and McLaren ('87-'91), that resulted in several shelves' worth of trophies for the cars he was instrumental in designing. He moved on to McLaren Cars, the consumer side of things, where, during his tenure from 1991 to 2004, he helped design the McLaren F1 and the Mercedes-Benz SLR McLaren, two cars that took learnings from his two decades in Formula One. What do all of these cars have in common? Three things: They are light. They were built in limited numbers. And they were (and are) exceedingly expensive—when the McLaren F1 debuted in 1994, it stickered at $815,000. Murray went on to establish Gordon Murray Design in 2007. GMD has created some interesting concept vehicles, such as the diminutive T.25 city car (94.5 inches long, 51.1 inches wide and 55.1 inches high), and the OX, a lightweight truck for the developing world that packs like an IKEA shelf and is working toward realization through a worthy crowdfunding campaign established by the Global Vehicle Trust. Now he has created a vehicle manufacturing company, Gordon Murray Automotive, that will use manufacturing methods that he developed under the moniker "iStream." Unlike a unibody, there are the "iFrame," a cage-like construction made with metallic components, and the "iPanels," which are composite. The panels aren't simply a decorative skin; they actually provide structure to the vehicle. Presumably this has something of the F1 monocoque about it. Going back to the three elements, (1) this arrangement results in a vehicle that can be comparatively light; (2) Murray has indicated that his manufacturing company will be doing limited-run production; and (3) to launch Gordon Murray Automotive they are going to be building a flagship model, about which Murray said, "With our first new car, we will demonstrate a return to the design and engineering principles that have made the McLaren F1 such an icon." Which seems to imply that it will be on the pricey side. According to the company's verbiage, "iStream forges an entirely new production method that defies conventionality with its Formula One-derived construction and materials technologies." It also sounds a whole lot like ...