1948 Gmc Other on 2040-cars

Auto blog

2015 Chevy Silverado, GMC Sierra can tow up to 12,000 pounds

Think back to the launch of the 2014 Chevrolet Silverado. At the time, General Motors happily trumpeted that its fullsize pickup could tow up to 11,500 pounds when properly equipped - impressive stuff, no doubt. But now, revised tow rating practices have been put into place, called SAE J2807. And with these new methods of testing, GM can now officially rate both the Silverado and its GMC Sierra twin as being able to tow up to 12,000 pounds.
Of course, not all Silverado and Sierra models are capable of this feat. In fact, because of SAE J2807, most of the truck models have actually had decreases in tow ratings from the 2014 to 2015 model year. For example, a 2014 Silverado Crew Cab with the 5.3-liter V8, 5.7-foot box and 3.73 rear axle was rated at 11,200 pounds in 2014, but has since been reduced to 10,800 in 2015. Same goes for the Sierra.
But for 2015, both the Silverado and Sierra can be had with a more powerful 6.2-liter V8, as well as a Max Trailering Package that includes a 9.76-inch rear axle, heavy-duty rear springs, revised shock tuning, improved cooling and a new trailer brake controller. There are also four- and seven-pin, bumper-mounted connectors, a trailer hitch (duh), and a G80 locking rear differential. This configuration, with either model, is the only way you can actually tow 12,000 pounds.

2020 GMC Acadia AT4 priced just a little more than the SLT trim

Cars Direct has seen the order guide pricing the 2020 Acadia AT4 at $42,495 after destination; that means a $41,300 MSRP plus $1,195 for shipping and handling. GMC has left a lot of pricing room between the rugged, all-wheel drive AT4 and the dressed-up, top-shelf Acadia Denali with AWD, the latter costing $49,495, a $7,000 difference. The spread's blown out some by what appears to be an $800 increase for the 2020 Acadia Denali with all-wheel drive. The 2019 model costs $48,695. On the other hand, it looks like the 200 Acadia SLT trim has gone down in price. Cars Direct says that model will run $41,995, which is $300 less than the 2019 version that goes for $42,295 after destination. The new price leaves a $500 gap between the SLT-1 model with all-wheel drive and the AT4 trim, a figure that's a no-brainer to justify for any buyers trying to get a more butch curb appeal.     The Acadia AT4 package comes standard with all-wheel drive and the 3.6-liter V6 with 310 horsepower and 271 pound-feet of torque, puts black chrome on the grille, and nabs a set of exclusive 17-inch wheels on all-terrain tires. The other two engines in the lineup are a new turbocharged 2.0-liter four-cylinder with 230 horsepower and 258 pound-feet of torque, and cylinder deactivation. That motor will be the standard kit on the SLT and Denali trim levels, supplanting the 3.6-liter that's standard on the 2019 models. The entry-level engine carries over, a naturally aspirated 2.5-liter four-cylinder making 193 horsepower and 188 pound-feet of torque.

Even if GM does close all 5 of those plants, it'll still have too many

DETROIT — General Motors' monumental announcement on Monday that it will close three car assembly plants and two powertrain plants in North America and slash its workforce will only partially close the gap between capacity and demand for the automaker's sedans, according to a Reuters analysis of industry production and capacity data. Sales of traditional passenger cars in North America have been declining for the past six years and are still withering. After GM ends production next year at factories in Michigan, Ohio and Ontario, it will still have four U.S. passenger-car plants — all operating at less than 50 percent of rated capacity, according to figures supplied by LMC Automotive. In comparison, Detroit-based rivals Ford and Fiat Chrysler Automobiles will have one car plant each in North America after 2019. The Detroit Three are facing rapidly dwindling demand for traditional passenger cars from U.S. consumers, many of whom have shifted to crossovers and trucks. Passenger cars accounted for 48 percent of retail light-vehicle sales in the United States in 2014, according to market researchers at J.D. Power and Associates. This year, sedans will account for less than a third of light vehicle sales. That shift in turn has left most North American car plants operating far below their rated capacities, while many SUV and truck plants are running on overtime. The collapse in passenger-car demand is a challenge for nearly all automakers in the United States, including Japan's Toyota and Honda, which have the top-selling models in the compact and midsize car segments. Toyota executives said last month they are evaluating the company's U.S. model lineup. But Toyota also plans to build compact Corolla sedans at a new $1.6 billion factory it is building in Alabama with partner Mazda. The obstacles facing GM in its plans to close more auto factories became apparent on Tuesday as U.S. President Donald Trump threatened to block payment of government electric vehicle subsidies to GM. While it is not certain that Trump unilaterally has the power to do that, he made it clear he intends to use his office to pressure the company to keep open a small car plant in Ohio that GM says will stop building vehicles in March.