1999 Ford Lightning Svt on 2040-cars

Auto blog

Ford dealers offered discounts on tools to fix aluminum

With the introduction of the aluminum-bodied 2015 Ford F-150 (and the likely use of aluminum in future Ford products), Ford is looking to help its dealerships reduce costs related to repairing this more labor-intensive material. Automotive News is reporting that Ford dealers with body shops will require an estimated $30,000 to $50,000 in equipment and training to work on aluminum, and to help alleviate the financial burden of the new F-150, Ford has announced a special 20-percent discount on this equipment.
Dealers will be able to save up to $10,000 on tools such as welders, air-filtration systems and rivet guns and to create aluminum-specific work stations. The new F-150 goes on sale in the fourth quarter, and dealers have until October 31 to take advantage of this deal, according to the report.

Lincoln recycling tree fibers into new MKX armrest

Want to hug a tree, or at least a really small part of one. Then set your arm down on one of those armrests in the 2014 Lincoln MKX crossover. The US automaker is working with Weyerhaeuser and Johnson Controls on a tree-based, cellulose-reinforced polypropylene material used in the component that connects the armrest to the floor console, Wards Auto says. With properties similar to plastic, the tree-based material replaces fiberglass and is about six percent lighter. No big deal for now, but if the material starts getting used for things like battery trays and interior storage covers, that loss in weight may eventually start adding up enough to boost fuel economy a bit, providing a green double bonus. Lincoln parent Ford, which isn't saying how much more (or less?) it costs to use the new material, established its Biomaterials and Plastics Research team in 2001. In 2007, the company began using soy-based foam in car seats used for models such as the Lincoln Navigator and Ford Mustang and has since broadened biomaterials use to components like floormats and cupholder inserts. Ford also used recycled plastic bottles from the 2012 North America International Auto Show for seats in the Focus Electric.

How Ford made its 2015 Ford Mustang safer for toupee wearers [w/video]

Ford is ready to tell the story of its 2015 Mustang Convertible, the can't-miss bits being the easier, quicker and quieter roof operation, a more robust roof build for a coupe-like cabin noise, more trunk space, better visibility and reduced in-cabin buffeting. The top release system has been completely redesigned with a single, center-mounted latch on the windshield frame instead of the dual latches of before. The driver can now release the roof without having to lean over into the passenger space, after which the top goes down fully automatically with the press of a button. Ford doesn't say how long it takes to stow, but it's apparently done in half as much time as before, so figure around 8 seconds.
The roof uses a five-bow structure, with the fabric outer and full inner headliner sandwiching ten millimeters of insulation. Detailing work on the top has eliminated "unsightly folds" in the corners when the roof is up and made it more compact when down; its Z-fold assembly is 6.7 inches lower than before at its highest point when put down. Ford says the new electric drive internals make less noise when in operation, and the fully-finished droptop look is achieved with snap-in caps that flank the rear seating and stow in the trunk when not in use (the outgoing Mustang's top was higher and the front when folded and always looked like it was catching air and creating drag).
The compact roof and newly independent rear suspension setup in back means liberated trunk space, 11.4 cubic feet ready to swallow golf bags and tourist swag. You can read a lot more about it in the press release below, check it out in the short video of running footage and learn about the aerodynamic improvements made to the entire Mustang lineup that decrease drag and increase fuel economy.