2009 Ford Fusion Sel Sedan 4-door 3.0l on 2040-cars

Auto blog

Aluminum lightweighting does, in fact, save fuel

When the best-selling US truck sheds the equivalent weight of three football fullbacks by shifting to aluminum, folks start paying attention. Oak Ridge National Laboratory took a closer look at whether the reduced fuel consumption from a lighter aluminum body makes up for the fact that producing aluminum is far more energy intensive than steel. And the results of the study are pretty encouraging. In a nutshell, the energy needed to produce a vehicle's raw materials accounts for about 10 percent of a typical vehicle's carbon footprint during its total lifecycle, and that number is up from six percent because of advancements in fuel economy (fuel use is down to about 68 percent of total emissions from about 75 percent). Still, even with that higher material-extraction share, the fuel-efficiency gains from aluminum compared to steel will offset the additional vehicle-extraction energy in just 12,000 miles of driving, according to the study. That means that, from an environmental standpoint, aluminum vehicles are playing with the house's money after just one year on the road. Aluminum-sheet construction got topical real quickly earlier this year when Ford said the 2015 F-150 pickup truck would go to a 93-percent aluminum body construction. In addition to aluminum being less corrosive than steel, that change caused the F-150 to shed 700 pounds from its curb weight. And it looks like the Explorer and Expedition SUVs may go on an aluminum diet next. Take a look at SAE International's synopsis of the Oak Ridge Lab's study below. Life Cycle Energy and Environmental Assessment of Aluminum-Intensive Vehicle Design Advanced lightweight materials are increasingly being incorporated into new vehicle designs by automakers to enhance performance and assist in complying with increasing requirements of corporate average fuel economy standards. To assess the primary energy and carbon dioxide equivalent (CO2e) implications of vehicle designs utilizing these materials, this study examines the potential life cycle impacts of two lightweight material alternative vehicle designs, i.e., steel and aluminum of a typical passenger vehicle operated today in North America. LCA for three common alternative lightweight vehicle designs are evaluated: current production ("Baseline"), an advanced high strength steel and aluminum design ("LWSV"), and an aluminum-intensive design (AIV).

NHTSA advances investigation of Ford Crown Victoria headlights

The National Highway Traffic Safety Administration is opening a preliminary evaluation into reports of suddenly failing headlights on 517,945 examples of the 2003-2005 Ford Crown Victoria and Mercury Grand Marquis. The government started looking into this problem in April when the North Carolina Consumers Council filed a defect petition with the agency. Now, the inquiry has moved to the next step. According to NHTSA's documentation (as a PDF), it examined its own database and worked with Ford to come up with a total of 3,609 complaints of the front lighting control module suddenly failing. When this happens, drivers lose the low-beam headlights, but the high-beams can be used by holding the stalk. Sometimes turning the switch off and on fixes the issue. Additionally, there are 15 allegations of crashes, and one reported shoulder injury. NHTSA's preliminary evaluations "evaluate the scope, frequency, and consequence of the alleged defect" and don't necessarily lead to a recall. NHTSA looked into this problem once before in 2008 and 2009 and decided that a recall wasn't necessary. Ford also extended the warranty on the front lighting control module for these vehicles. INVESTIGATION Subject : Loss of headlights Date Investigation Opened: AUG 10, 2015 Date Investigation Closed: Open NHTSA Action Number: PE15028 Component(s): EXTERIOR LIGHTING All Products Associated with this Investigation Vehicle Make Model Model Year(s) FORD CROWN VICTORIA 2003-2005 MERCURY GRAND MARQUIS 2003-2005 Details Manufacturer: Ford Motor Company SUMMARY: After receiving a defect petition (DP15002) concerning the loss of headlights and other exterior lighting in model year (MY) 2003-2005 Ford Crown Victoria and Mercury Grand Marquis vehicles, the Office of Defects Investigation (ODI) analyzed Vehicle Owner Questionnaire (VOQ) complaints received from consumers and identified a total of 605 reports (for all submission dates) alleging headlight failure. The complaints indicate failures of both low beam headlights typically while driving, a defect condition that was evaluated under a prior ODI investigation (PE08066). Most consumer VOQs indicate that the headlights failed suddenly and without warning leaving the driver with no forward lighting, however some report the headlights flickered or dimmed prior to turning off. In some cases drivers were able to turn the headlights back on after a period of time while others reported the headlights would not come back on at all.

Trump tells Detroit 3 CEOs he wants more US jobs, calls environmentalists 'out of control'

As expected, President Donald J. Trump met with top executives from FCA, Ford, and General Motors this morning as part of a larger push to generate jobs in America. "I want new plants to be built here for cars sold here!", Trump said in a tweet ahead of the meeting. Not everything said in the meeting was made public, but the President later tweeted that he had a "Great meeting with automobile industry leaders." FCA CEO Sergio Marchionne, Ford chief Mark Fields, and GM's Mary Barra all echoed the positive vibes after the meeting. In a statement, Barra called the discussion "very constructive and wide-ranging," adding that it focused on "policies that support a strong and competitive economy and auto industry," and "that supports the environment and safety." That's noteworthy, because Trump is reported to have said "I am to a large extent an environmentalist. I believe in it, but it's out of control." Fields, speaking to reporters after the meeting, said, "We're excited about working together with the president and his administration on tax policies, on regulation and on trade to really create a renaissance in American manufacturing." The Ford CEO was specifically talking about Trump's withdraw from the Trans-Pacific Partnership. "We've repeatedly said that the mother of all trade barriers is currency manipulation, and TPP failed in meaningfully dealing with that, and we appreciate the president's courage to walk away from a bad trade deal," he said. Marchionne focused on American manufacturing in his statement after the meeting. "I appreciate the President's focus on making the US a great place to do business. We look forward to working with President Trump and members of Congress to strengthen American manufacturing." Perhaps equally as interesting as what was said and who was invited are what wasn't said and who wasn't invited. Trump has been very vocal about his distaste for US automakers' plants in Mexico, but no mention was made of the North American Free Trade Agreement by Trump or any of the Detroit CEOs after the meeting. We also have to wonder if Trump plans to meet with representatives from German, Japanese, and Korean automakers that have made massive investments into American plants and produce a large number of cars in this country. Related Video: News Source: Reuters, General Motors, Fiat Chrysler Automotive, Donald J.