2000 Chevy Malibu Ls on 2040-cars

Auto blog

Driving Granatelli's turbine-powered 1978 Chevy Corvette [w/video]

With its curvy snout and feminine haunches, the third-gen Chevrolet Corvette looks like a dreamy – if dated – exemplar of Sports Car Fantasy 101 when viewed through modern eyes. This particular specimen circa '78, clad in silver and black paint with red pinstripes, appears to be a well-preserved example from the era. Apart from its low-profile Pirellis, slightly raised and slotted hood, spacious stance and a certain hand-painted descriptor alongside its crossed flag logos, you'd never guess there's a Space-Age propulsion unit powering this Coke bottle-bodied ride. Climb inside, and you're presented with aircraft gauges and big, colorful square buttons in the center panel. It takes a push of the "Ignitor" button, a tap of the starter button, and a slide of a T-handle for this nearly 40-year-old sports car to start sounding like Gulfstream G650 ready for takeoff. Yep, you're sitting in an 880-horsepower, turbine-powered Corvette, the only one of its kind in the world. Welcome to the whoosh. What The...? Built by Vince Granatelli, son of Indy 500 guru Andy Granatelli, this curious Corvette came into being by cramming a Pratt & Whitney ST6N-74 gas turbine engine into the donor car's lengthy front end. The same type of Jet A-burning mill powered Granatelli Senior's STP-sponsored racecar at the 1967 Indianapolis 500, where it famously led most of the 198 of 200 laps until a $6 transmission bearing failed, knocking it out of the race. The idea of turbine power usurping internal combustion was so threatening that Indy's governing body restricted turbine performance into obsolescence thereafter. A turbine-powered Corvette sounds excessive because it is. But there are also things about this 880-horsepower, 1,161-pound-feet monster that might surprise you. While it smacks of futurist exoticism and cost a then-dizzying $37,000 in 1967, the Canadian-built powerplant uses 80 percent fewer parts than an internal combustion V8 and will run on virtually anything combustible – whiskey, diesel, even Chanel No. 5. Though it's triple the length of a V8, the Pratt & Whitney beast weighs only 285 pounds. It's also one hell of a robust workhorse, typically serving as an auxiliary power unit for commercial aircraft or a generator in oil fields, where it can run for tens of thousands of consecutive hours before needing an overhaul. To adapt the Chevrolet for jet duty, the nose section was gutted and a sub-frame was built to compensate for the loosey-goosey front end.

2014 Chevrolet Malibu gets more torque, more room and inspiration from the Impala

The 2014 Chevrolet Malibu, having stared at the Impala across the showroom floor for a year, gets nips and tucks all over inspired by its larger brother. The 2.5-liter four-cylinder in the base car will get a stop-start system and 23 city miles per gallon, 35 highway, each number representing a one-mpg improvement over the 2013 car. Output is 196 horsepower and 186 pound-feet of torque.
Opt for the 2.0-liter turbo and, while power holds steady at 259 hp, torque goes up by 14 percent to a striking 295 lb-ft (a figure Chevy calls best in the class). The final details include newly programmed transmission shift points and faster shifts, for better engaging and enjoying the added power.
Looks-wise, the grille's been reshaped to be more in line with the new Chevrolet look, a narrower upper grille hovering over a larger lower grille.

EcoCar2 is on the hunt for a better, cleaner Chevy Malibu [w/video]

The students spent three years transforming an ordinary Chevy Malibu into a revolutionary vehicle. Not far from the building where General Motors once invented the Chevy Volt, a dozen or so college students are standing on the blacktop alongside a test track, watching a professional driver push the limits of a plug-in hybrid car they've built that's far more radical. These students, from Colorado State University, have spent the past three years transforming an ordinary Chevy Malibu into a revolutionary vehicle. At first glance, it still looks like a regular sedan. But under the hood, they've installed a hybrid powertrain that contains both hydrogen and electric power sources. Even by the standards of the Department of Energy competition they're participating in, it's an outlier. That's exactly what they had in mind. "We didn't want to come here and tell them how to build a better Volt," said Tom Bradley, faculty adviser for the Colorado State team. "They already know how to do that. We can tell them how to think about these possibilities in a whole new way." After three years of work, it all comes down to this. The Colorado State team was one of 15 that came to GM's Milford Proving Grounds last week for the final stretch of the EcoCar2 competition, which challenges regular college students who have no automotive experience to do nothing less than reinvent the American car. The teams have come from across North America, and include schools like Ohio State and Virginia Tech that have a long history of participating in similar competitions, and schools like the University of Washington and Embry-Riddle Aeronautical University that are here for the first time. After three years of work, it all comes down to this. The teams have operated 24 hours a day for almost two weeks here at the Proving Grounds, running a gamut of tests that include a 310-point safety inspection, emissions and energy-consumption tests and road tests, in which professional GM drivers ensure they're road worthy. The winning team will be announced tonight in Washington D.C. Revolutionary cars, ordinary package While other green-car competitions encourage extreme designs, this one comes with a somewhat constraining twist: Yes, students must improve fuel economy and reduce emissions, but in the end, they still have to have a car that would appeal to mainstream customers. In practical terms, that means they must keep conveniences like air conditioning and trunk space.