1975 Volkswagen Bus/vanagon on 2040-cars

Auto blog

Skoda launching two new CNG-powered vehicles in Europe in June

Skoda's second- and third-ever production compressed natural gas (CNG) vehicles aren't exactly speed burners, but they are efficient. The Czech automaker, which is owned by Volkswagen, will introduce its Octavia G-TEC and Octavia Combi G-TEC models to most of Europe next month. Skoda's first CNG model was the Citigo, which debuted in 2012. The Octavia models will have a turbocharged 1.4-liter engine that will deliver about 109 horsepower. Quickness isn't these cars' virtue, as their 0-60 mile per hour acceleration time will be almost 11 seconds. But they can go as far as 826 miles on their tanks of gas and CNG, enough to go from Prague to Rome in one shot, in case anyone was curious. Or nuts. The move by Skoda makes sense, as the CNG market in Europe has long been far further along than it is on this side of the pond, where CNG has primarily been used to move delivery trucks, but it's now available in pickups form Chrysler, Ford and General Motors as well as passenger cars from Chevy and Honda. The Skoda Citigo has moved almost 2,000 units since its debut, with 1,300 vehicles sold last year alone. That car can go as far as 385 miles on CNG and gasoline combined, which is impressive but not quite as bladder busting as the Octavia models. Check out Skoda's press release below. SKODA continues its CNG offensive with the new SKODA Octavia G-TEC Launch of the new SKODA Octavia G-TEC and new Octavia Combi G-TEC in June First SKODA Octavia with natural gas drive as standard; 97 g CO2/km High-performance technology: bivalent turbo engine 1.4 TSI/81 kW The ultimate in fuel economy: up to 1,330 km with natural gas and petrol SKODA Citigo G-TEC has enjoyed market success since 2012; only 79 g CO2/km Natural gas is the environmentally-friendly, cost-effective alternative Mlada Boleslav, 19 May 2014 – Expanding its environmentally-friendly model range, SKODA is renewing its emphasis on compressed natural gas vehicles. The new SKODA Octavia G-TEC and the new SKODA Octavia Combi G-TEC will be given their market premiere in June. This will increase the brand's CNG range to three models. Since the end of 2012, the little natural gas-drive Citigo has been successfully touring the European markets. "With the new Octavia G-TEC and the Octavia Combi G-TEC, our model range is becoming even more environmentally-friendly," says Dr Frank Welsch, SKODA Board Member for Technical Development.

Volkswagen lays off 500 Chattanooga workers

The redesigned Volkswagen Passat has been a decent seller since its debut in 2011, but sales have apparently dropped off enough that the automaker is trimming some of the employees from its Chattanooga, TN assembly plant. According to Automotive News, Volkswagen will be cutting shifts and laying off 500 contracted workers in response to slowing sales.
Currently, the plant has three teams running 10-hour shifts Monday through Saturday, but starting May 13, this will be reduced down to two teams running 10-hour shifts Monday through Thursday. This will be done to reduce dealer inventory (the article says that VW dealers, on average, have a 97-day supply of Passats) and production capacity (currently running at an annual pace of 170,000 units, which is more than the 150,000 annual units the plant was planned to produce).
This, of course, isn't saying that the Passat has been a failure since VW added 200 full-time employees to the plant in February 2012 to keep up with increased demand. The AN article says that automakers frequently overstaff plants during the launch of a new product - or in this case, a new product and a new plant - but eventually reduce the workers as things run smoother and more efficiently.

Rising aluminum costs cut into Ford's profit

When Ford reports fourth-quarter results on Wednesday afternoon, it is expected to fret that rising metals costs have cut into profits, even as rivals say they have the problem under control. Aluminum prices have risen 20 percent in the last year and nearly 11 percent since Dec. 11. Steel prices have risen just over 9 percent in the last year. Ford uses more aluminum in its vehicles than its rivals. Aluminum is lighter but far more expensive than steel, closing at $2,229 per tonne on Tuesday. U.S. steel futures closed at $677 per ton (0.91 metric tonnes). Republican U.S. President Donald Trump's administration is weighing whether to impose tariffs on imported steel and aluminum, which could push prices even higher. Ford gave a disappointing earnings estimate for 2017 and 2018 last week, saying the higher costs for steel, aluminum and other metals, as well as currency volatility, could cost the company $1.6 billion in 2018. Ford shares took a dive after the announcement. Ford Chief Financial Officer Bob Shanks told analysts at a conference in Detroit last week that while the company benefited from low commodity prices in 2016, rising steel prices were now the main cause of higher costs, followed by aluminum. Shanks said the automaker at times relies on foreign currencies as a "natural hedge" for some commodities but those are now going in the opposite direction, so they are not working. A Ford spokesman added that the automaker also uses a mix of contracts, hedges and indexed buying. Industry analysts point to the spike in aluminum versus steel prices as a plausible reason for Ford's problems, especially since it uses far more of the expensive metal than other major automakers. "When you look at Ford in the context of the other automakers, aluminum drives a lot of their volume and I think that is the cause" of their rising costs, said Jeff Schuster, senior vice president of forecasting at auto consultancy LMC Automotive. Other major automakers say rising commodity costs are not much of a problem. At last week's Detroit auto show, Fiat Chrysler Automobiles NV's Chief Executive Officer Sergio Marchionne reiterated its earnings guidance for 2018 and held forth on a number of topics, but did not mention metals prices. General Motors Co gave a well-received profit outlook last week and did not mention the subject. "We view changes in raw material costs as something that is manageable," a GM spokesman said in an email.