Leather,sunroof.20's,navigation,b/u Camera,heat/vent Seats,4x4,flexfuel on 2040-cars

Auto blog

Toyota fears supplier pressure in Australia with GM pull out

With Ford and General Motors both announcing an end to production in Australia, the country's auto industry is in a bad way. With the exit of two big players, there's increased concern that a third Australian manufacturer, Toyota, will be forced out, as well.
"We are saddened to learn of GM Holden's decision. This will place unprecedented pressure on the local supplier network and our ability to build cars in Australia," Toyota Australia said in a statement. The GM closure of Holden production will be the direct end to 2,900 jobs, but will also force a dramatic reduction in the size of the country's supplier network, as there will simply be fewer cars to build.
In the same statement, Toyota Australia said it would work with suppliers and local government to figure out whether continuing production Down Under was even feasible. According to Automotive News, a representative for the Australian Manufacturing Workers' Union told reporters it was "highly likely" that Toyota would also close up shop within the next few years.

Thanks to smaller engines, vehicle dependability falls for first time in 16 years

As automakers have made engines smaller and smaller to improve fuel economy, problems in those vehicles have gotten bigger and bigger. That's the synopsis of a J.D. Power vehicle-dependability study, which found that dependability dropped for the first time in 16 years, largely because the proliferation of four-cylinder engines is causing the vehicles to be less reliable. Specifically, the number of problems per 100 vehicles (or what J.D. Power calls PP100) during the past 12 months for 2011 model-year vehicles rose six percent from the year-earlier figures for 2010 model-year cars. Singling out four-cylinder vehicles revealed about a 10-percent increase in problems during the past year. This issues largely related to engine hesitation, rough transmission shifting and lack of power, signaling the inability of vehicle makers to iron out some of the problems in their smaller engines as they strove for better fuel economy. Six- and five-cylinder engines proved far more reliable. Among car brands, BMW's Mini sub-brand came out as least reliable, with 185 problems per 100 vehicles during the past year. Toyota's Lexus badge was easily the most reliable, with just 68 problems per 100 vehicles. Coming in second place was Mercedes-Benz. The overall average was 133. Check out J.D. Power's press release below. J.D. Power Reports: Increased Engine and Transmission Problems Contribute to Decline in Vehicle Dependability for The First Time in More Than 15 Years General Motors Company Receives Eight Segment Awards, While Toyota Motor Corporation Garners Seven and Honda Motor Company Earns Six WESTLAKE VILLAGE, Calif.: o Owners of 3-year-old vehicles (2011 model year) report more problems than did owners of 3-year-old vehicles last year, according to the J.D. Power 2014 U.S. Vehicle Dependability StudySM (VDS) released today. The study, now in its 25th year, examines problems experienced during the past 12 months by original owners of 2011 model-year vehicles. Overall dependability is determined by the number of problems experienced per 100 vehicles (PP100), with a lower score reflecting higher quality. The study finds that overall vehicle dependability averages 133 PP100, a 6 percent increase in problems from 126 PP100 in 2013. This marks the first time since the 1998 study that the average number of problems has increased. "Until this year, we have seen a continual improvement in vehicle dependability," said David Sargent, vice president of global automotive at J.D.

Mazda's new Mexican plant capacity rises to 230,000

After the turmoil of last year, 2013 is getting off to a much better start for Mazda. The company has issued a release indicating that the forthcoming plant in Salamanca, Mexico has had its production capacity raised even though it isn't scheduled to go online until March 2014. The original plans called for a 140,000-unit capacity, 90,000 of that allotted for the Mazda2 and Mazda3, the remaining 50,000 for a small car Mazda would build for Toyota that would be based on the Mazda2. The new plans call for raising that by 90,000 units to a total of 230,000 units within two years, by the end of March 2016, and it looks like it will all go toward Mazda production to satisfy growing demand for Skyactiv vehciles. The Mexican plant's opening will be the return of Mazda manufacturing to North America, after Mazda6 production was moved back to Japan last year.
More good news for the company is that it projects 10 billion yen ($114 million) in net income for the financial year that will end in March. That would be a welcome turnaround from the 100-billion-yen loss in the previous financial year, part of a series of three annual losses in a four-year span.
You'll find the press release with the factory update below.