Toyota Tacoma 4wd Double Lb V6 At Very Low Mileage! on 2040-cars

Auto blog

Toyota finds 10% MPG improvement in hybrid PCU

Keeping up its from-all-angles approach to efficiency, Toyota has found yet another way to eke out up to ten percent more precious MPGs in its hybrid vehicles, this time electronically. The automaker has announced the development of new silicon carbide (SiC) power semiconductors for use in power control units, which it will begin testing on Japanese roads within the next year. The PCU using the silicon carbide compound offers less electrical resistance, which improves efficiency when passing current between the battery and electric motor. It also loses less power after shutting off, and can operate at a higher frequency. The net power loss of the new PCU is just one-tenth of the current silicone-only version (the latter accounting for 20 percent of total electrical power loss in today's hybrids). The result, so far, is a claimed five-percent improvement in fuel economy in test vehicles, with the potential of ten percent by the time the new SiC power semiconductor comes to market. Additionally, the carbide wafers allow for smaller a power module, coil and capacitor, thus allowing the entire PCU to be 80 percent smaller (see the side-by-side comparison in the accompanying photo, which you can click to enlarge). We've got a while to wait before we start to see the carbide technology to start making a real-world impact. Toyota aims to begin using the SiC units in 2020. By then, with improvements in the company's other key efficiency factors - engine technology and aerodynamics - cars like the Prius will likely see significant gains in fuel economy. Read more in the press release below. Toyota Develops 'Diamond-like' Computer Chips to Boost Hybrid Mileage May 20, 2014 Toyota City, Japan – Toyota is using one of the hardest materials in nature after diamonds to develop a semiconductor chip it hopes will improve the fuel efficiency of its hybrids, such as the Prius, by as much at 10 percent. The company and its partners announced today that they have developed a silicon carbide (SiC) power semiconductor for use in automotive power control units. Toyota plans to begin test-driving vehicles with the technology on public roads in Japan within a year. The chips, made from carbide - one of the hardest materials in nature, theoretically have superior characteristics such as one-tenth the electrical power loss and 10 times the drive frequency. Toyota said the chips would also allow it to reduce the size of current automotive power control units by 80 percent.

More head-up displays are coming to a dashboard near you

With the exception of Apple products — $1,000 for a freakin' smartphone? — one great thing about tech is you typically get more for your money with each passing year. This is particularly true with automotive tech: Features like driver assists and surround-view cameras that were once exclusively available in luxury vehicles now come standard even on some economy cars. The same thing is slowly happening with head-up displays (HUD). For example, the 10-inch HUD in the 2018 Toyota Camry is one of the largest and best HUDs I've seen in any car. And a big improvement on the much smaller HUD in the latest Toyota Prius. Mazda is another mainstream brand that offers HUDs in several of its vehicles. But instead of embedding expensive components in the dash and using a special windshield, the HUDs in the Mazda3 and Mazda6 use a thin plastic lens that folds down when not in use. MINI has a similar solution, but this low-cost approach has limits in terms of size and position of the images compared to traditional HUDs that use the windshield as a screen. We're also starting to see similar lens-based aftermarket options that can be added to any car. Last year I tested a portable HUD called Navdy that taps into a car's OBD-II port to provide info on speed and RPM and uses built-in GPS and Google Maps to show the surrounding area, display speed limits and route you to your destination. Navdy also connects to an Android or iOS smartphone via Bluetooth to display data from phone calls, texts and music playing on a connected device, and it's simple to use and easily visible in almost any lighting condition. While Navdy is still available online, late last year the company ran into financial difficulties, and product support has been halted. I recently tested a new portable HUD called Hudly that's not quite fully baked and falls short of Navdy because it doesn't tap into an OBD-II port. Since a companion smartphone app for Hudly isn't scheduled to launch until next month, for now it only mirrors what's on a smartphone. So it can be used for nav and other apps, and its features are very limited. Between automakers adding HUDs in more reasonably priced cars and the aftermarket filling in the gaps for existing vehicle owners with add-ons, the technology is becoming more prevalent and affordable. And it's also getting better.

Toyota offered $146.5 million to build Lexus ES in Kentucky

Toyota posted a media advisory yesterday saying that Akio Toyoda, president of Toyota, and Jim Lentz, CEO of Toyota North America, would be making a production announcement tomorrow in New York City, and Automotive News reports that the automaker will be announcing a plan to domestically produce the Lexus ES. According to the report, numerous plants are competing to build the ES in North America, and the State of Kentucky has offered the automaker up to $146.5 million to build the luxury sedan at the Georgetown, KY assembly plant.
If Georgetown gets the ES, which has been built in Japan since its debut in 1989, it would be built alongside the Toyota Camry, which is somewhat ironic since in our review of the 2013 Lexus ES350, we wrote that this ES finally says "goodbye to its Camry roots." In order to get the whole amount offered, the article states that Toyota would have to invest $531.2 million and hire 570 full-time workers at the plant, which doesn't sound all that unreasonable since the plant would require an additional 50,000 units of annual production, not to mention the fact that the Georgetown facility is already at its capacity for building the Camry.