Toyota Matrix Xrs 6 Speed Manual on 2040-cars

Auto blog

2018 Ford Expedition vs other big SUVs: How it compares on paper

With our Alex Kierstein rightly impressed in his first-drive review of the new 2018 Ford Expedition, we decided to dig a little deeper into the numbers, and we came up with the spreadsheet below to highlight how the new 2018 Expedition compares on paper to its main full-size SUV competitors: the 2018 Chevy Tahoe and Suburban (and therefore the 2018 GMC Yukon), 2018 Toyota Sequoia and 2018 Nissan Armada. We also threw in the new, even bigger 2018 Chevrolet Traverse since, as you'll see, its massive dimensions should put it on the radar for anyone who needs loads of passenger and cargo space but doesn't care as much about towing. A few notes about the chart above. First, the 6.2-liter V8 that's included with the new-for-2018 Tahoe RST trim level is the standard engine on the GMC Yukon Denali. You can apply most of the Tahoe's numbers to the entire Yukon and Yukon XL lineup. Second, though we highlighted categories where the Traverse led, we also highlighted the runner-up full-size SUV, since this was ultimately about that segment. Traverse numbers are broadly applicable to the new Buick Enclave. Related Video: Chevrolet Ford GMC Nissan Toyota SUV Comparison consumer ford expedition gmc yukon chevy traverse toyota sequoia nissan armada chevrolet tahoe ford expedition max

How Toyota's 100-year textile history influenced FCV hydrogen fuel cell car

Turns out, Toyota had a surprising ace in the hole when it came to building the new fuel tanks for the FCV hydrogen fuel cell car, which is coming next year. Well before Toyota became the Toyota Motor Company, it was the Toyota Industries Corporation and it made textile looms. This is important because the main structure of the hydrogen tank is wound carbon fiber. When Toyota set out to increase the strength of the tanks to hold hydrogen stored at 10,000 psi (up from 5,000 in the previous tanks), it was able to draw on its 100-year-old history as it designed its car of the future. "A lot of that textile experience came back when we did the tank wrapping." – Justin Ward "We have a lot of experience with textiles," Justin Ward told AutoblogGreen at the 21st World Congress on Intelligent Transport Systems (ITS) in Detroit this week, "and a lot of that textile experience came back when we did the tank wrapping." On top of being able to hold the higher-pressure hydrogen, Toyota's first attempt to build its own hydrogen tank was six times faster than the industry standard, so it saved time and money as well as working better. The company will also be able to inspect its own tanks. Ward is the general manager of powertrain system control at the Toyota Technical Center and hydrogen vehicles are something he knows a lot about. The reason for the stronger, 10,000-psi tanks is because the 5,000-psi tanks only offered around 180-200 miles of range, even with four tanks in the early $129,000 FCHV Highlander hydrogen prototypes. The FCV only has two, but they will able to deliver the 300-mile range that customers told Toyota they wanted. Dropping the number of tanks not only obviously reduced the cost for the tanks themselves but also the number of valves and hoses and other components you need. Despite the benefits of higher compression, going much higher doesn't make sense. 10,000 psi is the "natural progression," Ward said, because "you start to bump up against compression inefficiencies." Think of an air compressor. When hydrogen is produced at a wastewater treatment plant or a reforming site, Ward said, is it at around ambient pressure (14 psi). That has to be raised, using compressors, all the way to 10,000 psi. "That takes energy," Ward said, "and every doubling of pressure adds another doubling of energy needed, so it starts to add up pretty fast if you go too high." Component specifications are also fine at 10,00 psi, but more difficult at higher levels.

2015 Toyota Yaris to start at $14,845* and look like this

Toyota released a new Yaris in Europe and its Vitz clone in Japan a few months ago, so we knew it would only be a matter of time before it would launch the new hatchback here in North America. And that time has come.
The new, more distinctive 2015 Yaris features far more aggressive exterior styling, a look set apart by that large lower air dam and X-motif front end. It rides on a retuned suspension hooked up to an altogether more rigid chassis, and Toyota promises it will ride more quietly and comfortably than the model it replaces. Inside the new model has additional soft-touch materials in a more comfortable cabin equipped with everything from a 6.1-inch touchscreen display to nine airbags.
The 2015 Yaris comes in both three- and five-door bodystyles, and three trim levels that seek to eliminate the need for options packages. In fact the only option to speak of is a dealer-installed nav system. Power comes from a modest 1.5-liter four with variable valve timing, dual overhead cams and sixteen valves, sending 106 horsepower and 103 pound-feet of torque through either a five-speed manual or four-speed automatic.