2019 Toyota 4runner Limited on 2040-cars

Auto blog

Toyota develops new pre-collision system with steering assist

A number of automakers are working on developing fully autonomous cars, but it looks like the groundwork for such technologies will likely show up first as semi-autonomous systems for both safety and convenience. Following recent announcements from Nissan and Ford in this area, Toyota has now released information for some of its advanced semi-autonomous technologies that could be offered in production cars over the next few years.
On the safety front, Toyota's new pre-collision system with pedestrian-avoidance steering assist is aimed at protecting the folks who aren't in the car. This system combines visual and audible alerts with automatic brake assist and automatic steering. If warnings don't get the driver to slow down, the brake assist kicks in if a collision is very likely, but if that is still not able to avoid the impending collision (and if there is enough room to do so), the car can automatically steer itself around the pedestrian. This sounds most beneficial for last-second dangers such as a person accidently stepping out into the road in front of a car. Toyota hopes to have this technology available to customers by 2015.
The Japanese automaker is also testing a suite of technologies called Automated Highway Driving Assist (AHDA). The key part of this is a new adaptive cruise control system that uses vehicle-to-vehicle (V2V) communications rather than a radar-based system. This cooperative-adaptive cruise control allows vehicles to communicate their acceleration and deceleration data with other cars, which Toyota says this helps to improve fuel efficiency and traffic flow. Also a part of AHDA is the Lane Trace Control feature, which sounds like a next-gen lane keep assist. This system uses cameras, radar and a computer to keep the vehicle in a "smooth driving line" by being able to change steering angle, engine torque and braking force. Toyota says this technology could be in place by the "mid-2010s."

Toyota vows to fix poor Camry crash test result that irked Consumer Reports

Many Toyota vehicles haven't been performing well in the Insurance Institute for Highway Safety's (IIHS) small overlap frontal crash test, and the Camry is one of them. The 2012 and 2013 Camry both received "Poor" ratings, IIHS' lowest rating, in the test, which spurred Consumer Reports to take the car off its "Recommended" list. In response to the low ratings in the small overlap frontal test, and in a bid to maintain its best-seller status, Toyota will make changes to the Camry to improve its IIHS safety rating and to enhance its design, The Detroit News reports.
The Camry performed well in the moderate overlap frontal, side, roof strength and head restraints and seats crash tests, receiving "Good" ratings, IIHS' highest rating, in all four tests. That was enough for IIHS to award it a Top Safety Pick rating, just not TSP+.
Bill Fay, head of Toyota's US division, reportedly says, "It's still a five-star car. It still does very well in all the IIHS tests. It did not in [the small overlap frontal crash test], and we're busy making the necessary adjustments so that we can address that."

Toyota recalls 337,000 RAV4s and HS250h models for tie rod failure

UPDATE: The post has been updated with additional information from NHTSA. The Basics: Toyota is recalling 337,000 2006-2011 model year Toyota RAV4 crossovers built between October 31, 2005 and September 7, 2010 as well as 2010 model year Lexus HS250h cars built between July 6, 2009 and August 26, 2010. The Problem: When either an affected RAV4 or HS250h is given an alignment and the tie rod adjustment nut on the rear control arm isn't tightened properly, the threads on the tie rod can start to rust. If this happens, the nut may break off and throw off the alignment drastically and suddenly. This isn't a case of the car simply pulling to one side, either. This would seriously upset the balance of the car and could cause the driver to lose control and crash. This is also the third time these vehicles have been recalled for the same issue. Injuries/Deaths: It's unknown if this control arm issue has resulted in any injuries or deaths. Autoblog reached out to Toyota for more information, but a company representative told us that the company isn't able to discuss injuries or deaths caused by this issue (if any) at this time. Based on information from NHTSA documents, it does not appear that any crashes, injuries or deaths have been attributed to the defect addressed in the current recall. The Fix: The dealer will completely replace the rear suspension assemblies at no cost to the owner. The tie rods and nuts will also be coated in epoxy to prevent future rusting from occurring. According to Car and Driver, the previous recalls involved tightening nuts, coating decent tie rods in epoxy and completely replacing rusted ones. The car magazine reports that further complaints were filed and the company is now replacing all components regardless of condition. If you own one: Toyota will notify owners of affected cars by mail. Owners can also check whether their cars are affected by entering the VIN at safercar.gov/vin. Owners with questions can also reach Toyota customer service at 1-800-331-4331 or Lexus customer service at 1-800-255-3987. Related Video: Featured Gallery 2012 Toyota RAV4 View 16 Photos News Source: Car and Driver, Toyota, National Highway Traffic Safety AdministrationImage Credit: Toyota Recalls Lexus Toyota Safety lexus hs 250h lexus hs250h