Barry Auto Repair / Wilmette, Illinois

Rating: ☆

Auto Repair & Service

Address: 3019 W Montrose Ave, Wilmette

Postal code: 60618

Phone: (773) 478-3041

Rebuild, repair, re-manufacture, replace virtually any American-made carburetor.

Is your carb or T.B.I. dirty, gummed up, clogged, leaky, damaged, worn out? Are linkages loose, binding, wobbly, bent, worn, missing? Are any casting pieces cracked, broken, warped, stripped, melted or missing? We can either repair, rebuild, remanufacture, or replace virtually any domestic. We completely dismantle, thoroughly clean and inspect, repair or replace components as needed on virtually any American made modern, vintage, collector, classic, antique, or hi-performance car, truck, van, motor home, boat, industrial/agricultural equipment, military, gasoline or propane carburetor or throttle body injector hi-performance Holley, single or double pump governed / non-governed hi-performance carburetors can be re-jetted, re-valved, etc. We are a Holley distributor for these Holley brands: Annihilator, Flow Tech, Hooker Headers, Lunaticams/pistons, NOS, Weiand, electric fuel pumps available 12 volt and six volt injectors cleaned and flow-pattern checked. Each carb comes rebuilt with new gaskets, new needle & seat if possible. Approximately one or two day turnaround time to thoroughly redo your original unit or call to see if we have your model ready to exchange. O.E.M re-coloring on request. We specialize in re-bushing worn throttle shafts, especially on quadrajets and T.B.I. units to eliminate those erratic idling, sticking throttle and vacuum leak problems, rebuild kits, individual gaskets, replacement floats, TPS, MCS, idle solenoids, dash pots, vacuum choke pull offs, coil-in-manifold chokes, hot air choke caps, electric choke caps, and choke conversion setups, EGR valves, TVS call re-set float and choke, new internal fuel filter if applicable, and new mounting base gasket, (special application spacer plates and gaskets O.E.M or stock compatible replacement, we have thousands of cores for whole or parts sourcing. Hundreds of new old stock carbs also call also available). GM electronic feedback carbs come with new throttle position sensor and mixture control solenoid. All adjustments are set to original factory specs. Just properly re-install with new base gasket supplied, and re-adjust idle after warm-up. Failed emissions test? We diagnose & correct pollution test failures, any American made vehicle--Oldsmobile 307 "y" v-8 our specialty, many emissions systems components in stock, call for your application. C made gasoline or propane carburetor of the 20th century.