Laramie Limited Diesel New 6.7l Nav Cd 4x4 Black Monotone Paint Dually on 2040-cars

Auto blog

Who sold the most heavy-duty pickups in 2012? PickupTrucks.com investigates

Domestic manufacturers enjoyed a good year for heavy-duty pickup sales in 2012. PickupTrucks.com has taken a close look at exactly how those sales broke down between each manufacturer and between three-quarter and one-ton pickups. Ford sold some 67,786 F-250 Super Duty models last year with the Chevrolet Silverado 2500 HD falling just behind at 56,359 units. The Ram 2500 HD came in third at 41,918, while the GMC Sierra 2500 HD earned itself fourth place with 27,616 deliveries. While Ford held onto the top spot in the one-ton market, Ram easily nailed down second place by selling more 3500 HD models last year than General Motors sold Silverado 3500 HD and Sierra 3500 HD trucks combined.
So, did GM manage to sell more trucks than Ford with its two brands? Very nearly. Ford sold a total of 119,338 heavy-duty pickups to GM's 111,555. Ram, meanwhile, moved a distant 77,583. But perhaps more interesting is the diesel take rate in this segment. PickupTrucks.com says 80 percent of all domestic one-ton trucks roll from the dealer lot with a turbo-diesel under the hood. Head over to the site for a closer look at the breakdown.

2014 Ram Promaster reporting for duty

We already knew Chrysler would be getting its own version of the Fiat Ducato for use as the 2014 Ram Promaster, but it was just a question of when and what changes would be made. Well now we know. Though far from conventional-looking, the new Promaster should give Chrysler a fullsize van that is more competitive than the old Ram Van and more affordable than the Mercedes-based Dodge Sprinter.
Chrysler says it made numerous changes to transform the Ducato into the US-friendly Promaster, and the biggest changes were made to the powertrains. Standard equipment on the Promaster 1500 is the widespread 3.6-liter Pentastar V6 rated at 280 horsepower and 260 pound-feet of torque paired, which, paired with a six-speed automatic transmission, offers a gross combined weight rating (GCWR) of 11,500 pounds. Other models will get the 3.0-liter diesel inline four-cylinder producing 174 hp and 295 lb-ft of torque, giving this version a GCWR of 12,500 pounds, and this engine is mated to a six-speed automated manual transmission.

Chrysler says its 8-speed transmissions will save 700 million gallons

Chrysler Group's TorqueFlite eight-speed transmission could be earning some serious green bragging rights if the company's projections are correct. The recently widely proliferated automatic gearbox, which is now in more than a million vehicles around the world, is poised to save drivers an estimated 700+ million gallons of fuel over the vehicles' lifetimes (an expected cost savings of $2.5 billion). In addition, Chrysler expects a reduction in CO2 emissions by more than six million metric tons. According to Chrysler, and depending on the vehicle, the TorqueFlite can improve fuel economy. The TorqueFlite autobox features particularly close ratios from fifth to eighth gear (see the press release below for the specific numbers), and uses low-viscosity fluid that doesn't need to be replaced. Transmission software adapts to the driving situation to optimize efficiency based on driver behavior, temperature, grade, stability control, and longitudinal and lateral acceleration. The TorqueFlite is capable of handling a variety of duties. As evidenced by the wide range of vehicles Chrysler Group has seen fit to equip with the eight-speed transmission, the TorqueFlite is capable of handling a variety of duties. Since its 2012 introduction, the TorqueFlite has gone from performing cog-swapping duties in Dodge Charger and Chrysler 300 models equipped with the 3.6-liter Pentastar V6 to changing gears in vehicles such as the Pentastar- and Hemi-powered Dodge Durango, Jeep Grand Cherokee and even the Ram 1500 EcoDiesel. For the 2015 model year, the eight-speed is finding its way into even more vehicles with the addition of a third version. In addition to the American-made TorqueFlite 845RE and 8HP70, the new 8HP90 will be manufactured in Saarbrucken, Germany. The 8HP90 is designed for higher torque loads, making it ideal for high-performance vehicles like the 2015 Dodge Challenger SRT Hellcat. The already-in-use 8HP70 will expand its duties to be used in 2015 Hemi models such as the Dodge Charger, Challenger, and Challenger SRT8. You can see the list of those benchmarks in Chrysler's press release below.