2014 Ram 3500 Laramie on 2040-cars

Auto blog

2014 Ram Promaster recalled over brake hoses

It's barely been a year since Chrysler brought the Fiat Ducato over to these United States as the Ram Promaster, but already it's being subjected to its second recall - both of them revolving around essential controls that are critical to the vehicle's operation.
The first came less than a month ago, when the National Highway Traffic Safety Administration issued a recall for nearly 10,000 of the vans due to a sticky accelerator pedal. Now Chrysler has issued a second recall to deal with the brake hose.
This second recall affects some 6,800 units of the ProMaster, half of which Chrysler says are on dealer lots. The automaker is instructing dealers to inspect both the vehicles it has in stock and to bring in customer vehicles to perform the same check, to ensure that the brake hose was properly installed in the first place. If not, the brake hose will be replaced.

Chrysler recalling 2009-2010 Ram 1500, Dodge Dakota pickups over axle pinion nut

Chrysler is issuing a recall for the 2009 and 2010 Ram 1500 and Dodge Dakota pickup trucks due to improper installation of the rear axle pinion nut. According to the National Highway Traffic Safety Administration, a total of 44,300 trucks are affected by the recall, and there have been 12 confirmed incidents including one crash.
The issue on both trucks is that the pinion nut is loosening on some trucks due to a lack of thread adhesive, and it is causing the rear axle to lock up resulting in loss of vehicle control. NHTSA's recall notice says that eight incidents occurred at speeds over 35 miles per hour and most also exhibited driveshaft failures as well since the loss of the pinion nut would cause the gear to separate from the driveshaft. In one complaint, the driveshaft separated from the rear axle and punctured the gas tank.
Chrysler will begin sending out recall notices to affected owners in November, but scroll down to see the official NHTSA notice.

Ram goes all-in on SAE J2807 tow ratings [w/video]

Thanks to the Society of Automotive Engineers (SAE), when car shoppers look at horsepower and torque figures on vehicles, they know that all the automakers are calculating them the same way. However, that isn't the case when it comes to truck buyers and max towing capacity ratings because each company figures the value differently. That practice finally changes with the SAE's standardized J2807 system, though, and Ram Truck is the first one to apply the new test procedure to its entire light- and heavy-duty pickup range.
All models of the Ram 1500, 2500 and 3500 use the new, standardized rating for the 2015 model year, but buyers might not notice too much difference. According to the company, in 99 percent of cases the max towing weights are unchanged or even improve slightly from last year. That's a strong result compared to the 2015 Chevrolet Silverado and GMC Sierra that are seeing few increases but mostly decreases under the new testing procedure.
"For too long, an uneven playing field existed and towing capacities went unchecked. We're happy to be the only pickup truck manufacturer to align with the SAE J2807 towing standard across our pickup truck lineup," said Mike Cairns, director of Ram Truck engineering, in the company's announcement of the new specs.