Slt Diesel 6.7l Power Door Locks Power Windows Am/fm Stereo & Cd Player Compass on 2040-cars

Auto blog

Ram recalling 65k trucks for rear-axle heat treating

A problem with the rear axle has promoted Fiat Chrysler Automobiles to recall a selection of Ram trucks. The campaign affects 2015-16 Ram 1500 series trucks – specifically those manufactured between June 17 and September 28, 2015. All told, that amounts to over 65,760 units across the United States. The issue stems, according to the statements below, from the rear axle shaft. Some of those trucks may have not had those axle shafts properly heat-treated, which could cause them to fracture and separate from the wheel. And that, it should go without saying, could lead to a crash. FCA states that most of the vehicles in question are in dealer hands, but while the manufacturer says it is aware of one accident to have resulted from the issue, no injuries have been reported. The owners of the affected vehicles will be notified to bring their trucks in to their local dealership to have them inspected. If necessary, the dealership with replace the rear axle assembly. This recall follows three prior (but unrelated) ones, also issued for Ram pickups, that between them affected well over a million units. Related Video: RECALL Subject : Incorrectly Heat Treated Rear Axle Shaft Report Receipt Date: OCT 15, 2015 NHTSA Campaign Number: 15V661000 Component(s): POWER TRAIN Potential Number of Units Affected: 65,760 Manufacturer: Chrysler (FCA US LLC) SUMMARY: Chrysler (FCA US LLC) is recalling certain model year 2015-2016 Ram 1500 trucks manufactured June 17, 2015, to September 28, 2015. The affected vehicles may have been built with rear axles that were incorrectly heat treated. CONSEQUENCE: If the rear axle shaft was not properly heated treated, it may fracture and a wheel separation could occur, increasing the risk of a crash. REMEDY: Chrysler will notify owners, and dealers will inspect the vehicles and replace the axle assemblies, as necessary, free of charge. The manufacturer has not yet provided a notification schedule. Owners may contact Chrysler customer service at 1-800-853-1403. Chrysler's number for this recall is R59. NOTES: Owners may also contact the National Highway Traffic Safety Administration Vehicle Safety Hotline at 1-888-327-4236 (TTY 1-800-424-9153), or go to www.safercar.gov. ### Statement: Heat-treating October 27, 2015 , Auburn Hills, Mich. - FCA US LLC is voluntarily recalling an estimated 65,760 U.S.-market trucks – most of which are in dealer hands – to inspect and replace, as required, their rear axle shafts or rear axles.

Chrysler recalling 67k trucks with manual transmissions

Earlier this month, Chrysler announced the recall of some 280,000 pickup trucks over concerns that their axles could seize up. Now the automaker has announced an entirely separate recall of another 66,819 trucks over the springs that could break in the clutch ignition interlock switch. The recall affects Dodge Ram 1500, 2500 and 3500 pickups, as well as the Dodge Dakota and Mitsubishi Raider. The issue is relevant only to those trucks fitted with manual transmissions, from the 2006 and 2007 model years and manufactured between July 1, 2005, and July 31, 2006. Since a broken spring could, according to statements issued by the National Highway Traffic Safety Administration and FCA US LLC (previously known as the Chrysler Group) prevent the vehicle from starting, or cause it to move unintentionally once the ignition kicks over, the automaker will begin notifying owners of the affected vehicles just before Valentine's Day to bring their trucks into their local dealers to have the clutch ignition interlock switch replaced. FCA emphasizes, however, that the unintended movement would only occur "in rare cases" and only "if recommended starting procedures are not followed." Only one such case is known to have occurred, but it did regrettably result in a fatality. Statement: Clutch Ignition Interlock Switch December 29, 2014 , Auburn Hills, Mich. - FCA US LLC is launching a voluntary global recall of an estimated 66,819 older-model pickup trucks equipped with manual transmissions. The Company will replace their clutch ignition interlock switches at no charge to customers. An investigation by FCA US engineers discovered switches in certain model-year 2006 and 2007 pickups may be equipped with spring wire that differs from wire used in previous switches. The alternate wire may break and, as a result, the vehicles may not start. In rare cases, a vehicle may – if recommended starting procedures are not followed – exhibit unintended movement when its ignition key is turned. The Company is aware of one fatality related to this campaign. It stemmed from the single known accident involving this population of vehicles. The recall covers certain Dodge Dakota, Dodge Ram 1500, 2500, 3500 and Mitsubishi Raider pickups. Switches with the alternate wire were not used in any vehicles produced before July of 2005, or after June of 2006. The Dakota and Raider are no longer in production.

Recharge Wrap-up: Child Tesla driver hits baby in Chinese mall, Ram adds new CNG offering

A five-year-old child in a China shopping mall started a Tesla Model S at a display and hit a baby in a stroller. The baby fell out of the stroller and was unhurt, according to the report. A reporter from a local newspaper arrived at the scene to find the other Model S on display still powered on, this one with another child in the driver's seat. The cars had wooden blocks under the brake pedals and stickers warning the public not to touch the touchscreen. Police have opened an investigation into the incident. Read more and see all the photos at Car News China. Ram will add a new compressed natural gas pickup truck to its lineup. The new offering, which is smaller and less expensive than the current CNG pickup (pictured), will be available as a regular cab two-door with two-wheel drive and a long bed. Ram has sold 1,000 of the current 2500 CNG four-door 4x4 offering since going on sale in 2012. Ram believes the new offering will expand sales to fleet operators looking for a less-expensive truck. Read more at Automotive News. New methods of harvesting energy are being explored for automobiles. By now we're all familiar with regenerative braking, but thermoelectric harvesting from the motor, range extender or possibly even the exhaust could come to cars soon. Energy harvesting shock absorbers and exhaust turbines are also viable. Wind turbines could generate electricity while the car is parked, and piezoelectric energy harvesting could run minor electrical systems while the car is in motion. Enough energy harvesting could allow cars to use much smaller engines, and could extend the range of electric vehicles. Read more at Energy Harvesting Journal.