6.7l I6 Diesel Laramie Leather Navigation Camera Alpine Tow Running Boards 4x4 on 2040-cars

Auto blog

Chrysler recalls AWD 300, Charger, Ram 1500 over ZF transmission

What do the Chrysler 300, Dodge Charger and Ram 1500 all have in common? Yes, they're all Chrysler products, and two of them are based on the same platform. And we're sure you could find more similarities between them all, but the common trait we're looking at here is that, while they all come standard in rear-drive form, they're also available with all-wheel drive. And it's the transmission in those models that's the subject of the latest recall notice issued by the National Highway Traffic Safety Administration.
The output shaft on the eight-speed automatic transmission supplied by ZF to Chrysler for the AWD versions of the 300, Charger and Ram 1500 is apparently prone to fracture. That in the end could leave the vehicle without power and could, according to the NHTSA investigation, increase the chance of a crash. The vehicle could also roll away if even if left in Park without the handbrake applied.
That's why Chrysler is calling in 4,194 examples of those three models from the 2013 model year. Dealers will be responsible for inspecting the transmissions and, where necessary, replace the entire unit. See the full recall notice below for all the details.

FCA recalls 2 million Ram trucks over airbag issues

Airbag issues have prompted Fiat Chrysler Automobiles to issue another pair of recalls. The two separate issues both affect Ram pickups, one campaign stemming from oversensitive sensors, the other from a wiring harness. Between them, the problems affect an estimated combined total of some 2 million units. The first recall affects 2013-15 Ram 1500, 2500, and 3500 trucks, specifically four-door models, manufactured between June 20, 2012, and January 26, 2015. The calibration of the side impact sensor in those affected units may to be too sensitive. As a result, if the door is slammed too hard, the side-curtain airbag and seatbelt pre-tensioner may inadvertently activate. FCA reports that this issue affects an estimated 667,406 units in the United States, plus 153,011 in Canada, a further 8,272 in Mexico, and another 14,847 in markets outside of North America, amounting (in Chrysler's estimation) to less than 0.005 percent of those vehicles produced. The automaker says it is aware of two minor injuries (but no accidents) that may have resulted from the glitch, and is taking action to have the Occupant Restraint Control module recalibrated in the affected units. The second issue also affects Ram pickups, including 1500, 2500, 3500, 4500, and 5500-series models from the 2012 to 2014 model years, built between January 18, 2011, and October 7, 2014, and fitted with the optional Electronic Vehicle Information Center. The problem here stems from a wiring harness in the steering wheel that may rub against a retainer spring in the air bag control module, which in turn could cause an electrical short and deploy the driver's side air bag unexpectedly. In the United States alone, the issue is estimated to affect 1,060,531 units, which will need to be inspected and, where necessary, have their steering wheel wiring harnesses secured, with protective caps added to the ends of the airbag retainer spring. These do not represent the first issues we've seen from Fiat Chrysler in recent days. The automaker recently issued a recall for approximately 1.4 million vehicles to have their Uconnect software updated to prevent hacking. A few days ago it also announced a recall for 350,000 Dodge Journey (and Fiat Freemont) crossovers to secure loose engine covers. And the National Highway Traffic Safety Administration is expected to issue Fiat Chrysler Automobiles a $105-million fine for mishandling other recent recalls and safety issues.

Ram Truck digs in with Laramie Longhorn-inspired Case backhoe

Some combinations seem natural immediately like chocolate and peanut butter, but others take a little more consideration before they begin make sense. That is exactly the situation with the new partnership between Ram and heavy equipment-maker Case to build a one-of-a-kind Ram 3500 with a matching, customized Case 580 Super N Wide Track Backhoe. The unique combo is currently on display at the CONEXPO-CON/AGG 2014 show in Las Vegas, NV, and afterwards will go on tour for the rest of the year at Ram- and Case-sponsored events.
While it is undoubtedly odd to see a modified backhoe, it almost gets cool when you se the interior. Both vehicles the same two-tone gold and black paint scheme, and the backhoe's cab has been refinished to match the truck with shades of brown leather, Laramie badges and chrome trim. If you have to be in a backhoe, this one looks like the one to choose. Plus, this might be the first backhoe ever with chrome wheels.
The truck that the backhoe is attached to a Ram 3500 Laramie Longhorn Crew Cab 4x4 with a 6.7-liter Cummins Turbo Diesel with 850 foot-pounds of torque, plus an improved transfer case and heavy-duty transmission. Like its matching heavy equipment friend, the truck is also supposed to offer a mix of luxury and working ability. Scroll down for the full press release on this very curious combo.