2020 Ram 2500 Power Wagon on 2040-cars

Auto blog

Ram recalling 65k trucks for rear-axle heat treating

A problem with the rear axle has promoted Fiat Chrysler Automobiles to recall a selection of Ram trucks. The campaign affects 2015-16 Ram 1500 series trucks – specifically those manufactured between June 17 and September 28, 2015. All told, that amounts to over 65,760 units across the United States. The issue stems, according to the statements below, from the rear axle shaft. Some of those trucks may have not had those axle shafts properly heat-treated, which could cause them to fracture and separate from the wheel. And that, it should go without saying, could lead to a crash. FCA states that most of the vehicles in question are in dealer hands, but while the manufacturer says it is aware of one accident to have resulted from the issue, no injuries have been reported. The owners of the affected vehicles will be notified to bring their trucks in to their local dealership to have them inspected. If necessary, the dealership with replace the rear axle assembly. This recall follows three prior (but unrelated) ones, also issued for Ram pickups, that between them affected well over a million units. Related Video: RECALL Subject : Incorrectly Heat Treated Rear Axle Shaft Report Receipt Date: OCT 15, 2015 NHTSA Campaign Number: 15V661000 Component(s): POWER TRAIN Potential Number of Units Affected: 65,760 Manufacturer: Chrysler (FCA US LLC) SUMMARY: Chrysler (FCA US LLC) is recalling certain model year 2015-2016 Ram 1500 trucks manufactured June 17, 2015, to September 28, 2015. The affected vehicles may have been built with rear axles that were incorrectly heat treated. CONSEQUENCE: If the rear axle shaft was not properly heated treated, it may fracture and a wheel separation could occur, increasing the risk of a crash. REMEDY: Chrysler will notify owners, and dealers will inspect the vehicles and replace the axle assemblies, as necessary, free of charge. The manufacturer has not yet provided a notification schedule. Owners may contact Chrysler customer service at 1-800-853-1403. Chrysler's number for this recall is R59. NOTES: Owners may also contact the National Highway Traffic Safety Administration Vehicle Safety Hotline at 1-888-327-4236 (TTY 1-800-424-9153), or go to www.safercar.gov. ### Statement: Heat-treating October 27, 2015 , Auburn Hills, Mich. - FCA US LLC is voluntarily recalling an estimated 65,760 U.S.-market trucks – most of which are in dealer hands – to inspect and replace, as required, their rear axle shafts or rear axles.

Chrysler recalling 67k trucks with manual transmissions

Earlier this month, Chrysler announced the recall of some 280,000 pickup trucks over concerns that their axles could seize up. Now the automaker has announced an entirely separate recall of another 66,819 trucks over the springs that could break in the clutch ignition interlock switch. The recall affects Dodge Ram 1500, 2500 and 3500 pickups, as well as the Dodge Dakota and Mitsubishi Raider. The issue is relevant only to those trucks fitted with manual transmissions, from the 2006 and 2007 model years and manufactured between July 1, 2005, and July 31, 2006. Since a broken spring could, according to statements issued by the National Highway Traffic Safety Administration and FCA US LLC (previously known as the Chrysler Group) prevent the vehicle from starting, or cause it to move unintentionally once the ignition kicks over, the automaker will begin notifying owners of the affected vehicles just before Valentine's Day to bring their trucks into their local dealers to have the clutch ignition interlock switch replaced. FCA emphasizes, however, that the unintended movement would only occur "in rare cases" and only "if recommended starting procedures are not followed." Only one such case is known to have occurred, but it did regrettably result in a fatality. Statement: Clutch Ignition Interlock Switch December 29, 2014 , Auburn Hills, Mich. - FCA US LLC is launching a voluntary global recall of an estimated 66,819 older-model pickup trucks equipped with manual transmissions. The Company will replace their clutch ignition interlock switches at no charge to customers. An investigation by FCA US engineers discovered switches in certain model-year 2006 and 2007 pickups may be equipped with spring wire that differs from wire used in previous switches. The alternate wire may break and, as a result, the vehicles may not start. In rare cases, a vehicle may – if recommended starting procedures are not followed – exhibit unintended movement when its ignition key is turned. The Company is aware of one fatality related to this campaign. It stemmed from the single known accident involving this population of vehicles. The recall covers certain Dodge Dakota, Dodge Ram 1500, 2500, 3500 and Mitsubishi Raider pickups. Switches with the alternate wire were not used in any vehicles produced before July of 2005, or after June of 2006. The Dakota and Raider are no longer in production.

Peugeot E-Boxer seems like it would make a nice electric Ram ProMaster

Though electric cars, and especially pickup trucks, are the hot zero-emissions battlefield, there's another sector that's heating up: commercial vans. Startups such as Rivian and Bollinger have announced plans for vans, and Ford has shown a prototype of an electric Transit. It seems Stellantis is slightly ahead of the curve, though, as it has revealed details of its electric vans with the Peugeot E-Boxer. And the reason you should care is that the E-Boxer and gas-powered Boxer are nearly identical to the American-market Ram ProMaster and Italian Fiat Ducato. Powering the E-Boxer is a single electric motor at the front. It's not particularly powerful with just 122 ponies, but it has a more respectable 192 pound-feet of torque. Top speed is limited to 68 mph, which would probably need to be raised if these vans were offered in the U.S. Supplying power is one of two available battery packs: The shorter models get a 37-kWh battery that is rated for 124 miles of range on the WLTP cycle; longer models get a 70-kWh battery rated by WLTP for 211 miles. Those numbers would likely be lower in American EPA testing. While the range isn't incredible, enormous range likely isn't as important for delivery vans that might operate locally. These vans also come with DC fast charging in case more range is needed quickly. Though not quick, the Peugeot E-Boxer doesn't sacrifice on practicality. No cargo space is sacrificed for the electric powertrain, so you can fit just as much into one as a similarly configured gas model. Payload capacity is comparable to the gas vans, even the V6 ProMaster, too, with a maximum of 4,167 pounds. This number does vary based on configuration, just like cargo space. Peugeot will offer it in four different lengths with three roof heights as well as chassis and cutaway cab models. So it's just as configurable as the regular version. With some adjustment to how quick the E-Boxer can go, it would seem like it could be offered in the U.S. and beat some competitors to the punch. It's all built on the existing Ram ProMaster platform that we get here. And electric power would seem appealing to businesses that need delivery vans: lower fuel and maintenance costs. Time will tell if Stellantis sees things the same way. Related Video: This content is hosted by a third party. To view it, please update your privacy preferences. Manage Settings. 2018 Volkswagen California Review