2012 St Crew 4x4 Longbed Uconnect Voice Command Cummins Diesel on 2040-cars

Auto blog

Pickup prices rising at 2x industry average

We've said it before, but bears repeating: Pickup trucks are the financial engines of America's automakers. Good thing, then, that the segment is in rude health - in fact, Automotive News is suggesting that pickup truck sales are arguably healthier than they were pre-recession, even though the segment's volume is still significantly down from where it was before the bottom fell out of the US economy. That's because per-unit profits on full-size trucks are skyrocketing, outpacing the industry's average price increases by more than double since 2005. According to data from Edmunds, the average transaction price of a full-size pickup is now $39,915 - a heady increase over the $31,059 average price in 2005 - a gain of over 8 percent after inflation is factored in.
Just how important are trucks to automakers' bottom lines? Automotive News quotes a Morgan Stanley analyst as saying the Ford F-Series is responsible for 90 percent of the company's 2012 profits, and General Motors isn't far behind, with the Chevrolet Silverado and GMC Sierra twins chipping in about two-thirds of the automaker's earnings.
Automotive News points out that Detroit's automakers now have the money to invest in modernizing their full-size truck offerings, in part because they don't have the same overhead and legacy costs that pushed General Motors and Chrysler into bankruptcy. Certainly, the pickup segment has seen a lot of innovations as of late, including turbocharged V6s, coil-spring rear suspensions and active aero. Those improvements in important areas like fuel economy and ride comfort have given existing pickup buyers new reasons to upgrade. In addition, automakers are piling on the tech and luxury goodies, creating more and more high-content, high-profit models like the Ford F-150 King Ranch, Ram 1500 Laramie Longhorn and Chevrolet Silverado High Country (shown).

Chrysler recalling 382k Ram HD diesel pickups, 184k SUVs

Between GM's ignition switches and Takata's airbags, it's been a big year for recalls, but they keep rolling in. The latest comes from Chrysler, which has announced a pair of recalls for certain heavy-duty pickups and SUVs.
The first issue revolves around the 6.7-liter Cummins diesel engine available in the 2010-2014 Ram HD trucks, including 2500 and 3500 series pickups as well as 4500 and 5500 series chassis cabs. In the affected units, "a terminal connector near the fuel heater may be subject to friction-induced corrosion," according to the first of the two announcements from Chrysler below.
The problem could result in overheating and fuel leakage. Chrysler launched its investigation following cases of overheating, none of which actually started a fire, much less an injury or accident. As a precautionary measure, however, Chrysler is instructing service technicians to replace the terminals on an estimated 381,876 Ram units around the world - the vast majority of those (314,704) registered in the US, another 59,432 in Canada, 1,803 in Mexico and 5,937 abroad.

Ram flubs ProMaster cargo capacity

The Ram ProMaster is going to look a little smaller on the inside, at least by way of its specification sheets, despite the sheet metal staying the same.
When Ram originally published the cargo capacity for its van, it simply did a direct conversion from the European rating of 15 cubic meters to 530 cubic feet. However, that didn't take into account the standard way internal measurements are calculated for the US. While the trucks have been on sale since October, the automaker just noticed the problem, and it's working on a revised figure. According to Automotive News, the new carrying ability for the ProMaster is likely between 450 and 475 cubic feet.
The difference stems from two standards for measuring capacity. In Europe, the entire internal area is determined and then obstacles like seats are subtracted from it. That means areas where freight could never go, like on top of seat backs, gets included in the figure. In the US, only the area where goods could actually fit is included, which leads to lower specs with no actual change in space.