2021 Ram 1500 Warlock on 2040-cars

Auto blog

Ram recalling 65k trucks for rear-axle heat treating

A problem with the rear axle has promoted Fiat Chrysler Automobiles to recall a selection of Ram trucks. The campaign affects 2015-16 Ram 1500 series trucks – specifically those manufactured between June 17 and September 28, 2015. All told, that amounts to over 65,760 units across the United States. The issue stems, according to the statements below, from the rear axle shaft. Some of those trucks may have not had those axle shafts properly heat-treated, which could cause them to fracture and separate from the wheel. And that, it should go without saying, could lead to a crash. FCA states that most of the vehicles in question are in dealer hands, but while the manufacturer says it is aware of one accident to have resulted from the issue, no injuries have been reported. The owners of the affected vehicles will be notified to bring their trucks in to their local dealership to have them inspected. If necessary, the dealership with replace the rear axle assembly. This recall follows three prior (but unrelated) ones, also issued for Ram pickups, that between them affected well over a million units. Related Video: RECALL Subject : Incorrectly Heat Treated Rear Axle Shaft Report Receipt Date: OCT 15, 2015 NHTSA Campaign Number: 15V661000 Component(s): POWER TRAIN Potential Number of Units Affected: 65,760 Manufacturer: Chrysler (FCA US LLC) SUMMARY: Chrysler (FCA US LLC) is recalling certain model year 2015-2016 Ram 1500 trucks manufactured June 17, 2015, to September 28, 2015. The affected vehicles may have been built with rear axles that were incorrectly heat treated. CONSEQUENCE: If the rear axle shaft was not properly heated treated, it may fracture and a wheel separation could occur, increasing the risk of a crash. REMEDY: Chrysler will notify owners, and dealers will inspect the vehicles and replace the axle assemblies, as necessary, free of charge. The manufacturer has not yet provided a notification schedule. Owners may contact Chrysler customer service at 1-800-853-1403. Chrysler's number for this recall is R59. NOTES: Owners may also contact the National Highway Traffic Safety Administration Vehicle Safety Hotline at 1-888-327-4236 (TTY 1-800-424-9153), or go to www.safercar.gov. ### Statement: Heat-treating October 27, 2015 , Auburn Hills, Mich. - FCA US LLC is voluntarily recalling an estimated 65,760 U.S.-market trucks – most of which are in dealer hands – to inspect and replace, as required, their rear axle shafts or rear axles.

Here's how I averaged 31.5 mpg in a Ram HFE EcoDiesel

Few things could be more American than a bright red Ram pickup parked in front of Mount Rushmore. To get there and back on a single tank of fuel from the nearest major city, however, requires a collaboration of international proportions. This particular Ram is a 1500 HFE EcoDiesel, festooned with badges indicating the presence of an Italian turbodiesel V6 mated to a German eight-speed automatic. Some Rams are even built in Mexico, but this one only boasted a 27 percent Mexican parts content. A rather global truck, this one. It is the sum of its parts, but those bits and pieces were curated by a team of engineers in Michigan. At the risk of hipstering its history, the Ram HFE (High Fuel Efficiency) package was truly custom-tailored for one purpose: Achieving an EPA-rated 29 mpg on the highway, which is 1 mpg better than a standard Ram 1500 EcoDiesel. It did just that. No, it did better than that, but more on that in a minute. The Ram has stuck with its "son of big rig" styling for nearly 25 years; opting for the EcoDiesel V6 means you can fill up next to Peterbilts. My goal was to bypass truck stops entirely. I left Denver early in the morning and aimed to enjoy lunch with Washington, Jefferson, Roosevelt, and Lincoln looking over my shoulder before heading home for dinner. Mt. Rushmore is about 370 miles away from the northernmost truck stop within Denver, where I filled the Ram HFE's tank and headed northbound on Interstate 25 toward Wyoming and a series of smaller highways that roughly follow an old stagecoach route from Cheyenne to what is now Mt. Rushmore in South Dakota. The Ram was such a fuel miser that I could have driven an extra 50 miles each way and still avoided the pumps. It's beautifully stark country: the kind of desolate place where the FM radio does a lot of seeking; that's all the audio I had on board because the Ram HFE is decidedly lacking in comfort and convenience features. To get to an EPA-estimated 29 mpg highway figure, Ram engineers had to goals: To strip weight and improve aerodynamics. In the wind tunnel, the medium-size 4x2 Quad Cab with 20-inch wheels and the Ram Express trim level's one-piece front bumper proved the most aerodynamic configuration of the many flavors of Ram available. Interestingly, testing revealed that adding full-length tubular side steps and a tri-fold tonneau cover normally offered in the Mopar accessories catalog aid aerodynamics.

Fiat Chrysler expands Takata airbag recall to 3.3M vehicles

Fiat Chrysler Automobiles is expanding its recall of vehicles equipped with Takata airbags, moving beyond Florida, Hawaii, Puerto Rico and the US Virgin Islands to the greater US, as well as Mexico, Canada and beyond. The affected vehicles, some 3.3 million in total, were built between 2004 and 2007, with many models, including the Dodge Ram 1500, 2500 and 3500, Durango and the Chrysler 300, having been affected by Chrysler's previous recall. Despite the somewhat alarming nature that comes with a recall of this many vehicles, it seems that Chrysler is moving more out of an abundance of caution (and federal pressure) than anything else, saying: "Neither FCA US, nor Takata Corporation, the supplier, has identified a defect in this population of inflators. These components also are distinct from Takata inflators cited in fatalities involving other auto makers. More than 1,000 laboratory tests have been performed on these components. All deployed as intended, but FCA US continues to study the suspect inflators, which are not used in the Company's current production vehicles." Owners of affected vehicles will be notified and asked to report to dealers for a free replacement driver's side airbag. Scroll down for the official press release from FCA. Statement: Global Air-Bag Inflator Replacement December 19, 2014 , Auburn Hills, Mich. - FCA US LLC will replace driver's-side air-bag inflators in an estimated 3.3 million older-model vehicles worldwide, in an expansion of an ongoing regional field action. Neither FCA US, nor Takata Corporation, the supplier, has identified a defect in this population of inflators. These components also are distinct from Takata inflators cited in fatalities involving other auto makers. More than 1,000 laboratory tests have been performed on these components. All deployed as intended, but FCA US continues to study the suspect inflators, which are not used in the Company's current production vehicles. Outside of Florida, one of the areas covered by the original action, no FCA US vehicle has been linked to an air-bag deployment of the type that has raised public concern. Nevertheless, the Company is replacing the Takata components tied to that concern. FCA US is aware of one related injury involving one of its vehicles, an older-model sedan. It occurred in a southern Florida region marked by persistent, high, absolute humidity – a condition believed to be a contributing factor in the air-bag deployments under investigation.