2014 Ram 1500 Slt on 2040-cars

Auto blog

Chrysler says its 8-speed transmissions will save 700 million gallons

Chrysler Group's TorqueFlite eight-speed transmission could be earning some serious green bragging rights if the company's projections are correct. The recently widely proliferated automatic gearbox, which is now in more than a million vehicles around the world, is poised to save drivers an estimated 700+ million gallons of fuel over the vehicles' lifetimes (an expected cost savings of $2.5 billion). In addition, Chrysler expects a reduction in CO2 emissions by more than six million metric tons. According to Chrysler, and depending on the vehicle, the TorqueFlite can improve fuel economy. The TorqueFlite autobox features particularly close ratios from fifth to eighth gear (see the press release below for the specific numbers), and uses low-viscosity fluid that doesn't need to be replaced. Transmission software adapts to the driving situation to optimize efficiency based on driver behavior, temperature, grade, stability control, and longitudinal and lateral acceleration. The TorqueFlite is capable of handling a variety of duties. As evidenced by the wide range of vehicles Chrysler Group has seen fit to equip with the eight-speed transmission, the TorqueFlite is capable of handling a variety of duties. Since its 2012 introduction, the TorqueFlite has gone from performing cog-swapping duties in Dodge Charger and Chrysler 300 models equipped with the 3.6-liter Pentastar V6 to changing gears in vehicles such as the Pentastar- and Hemi-powered Dodge Durango, Jeep Grand Cherokee and even the Ram 1500 EcoDiesel. For the 2015 model year, the eight-speed is finding its way into even more vehicles with the addition of a third version. In addition to the American-made TorqueFlite 845RE and 8HP70, the new 8HP90 will be manufactured in Saarbrucken, Germany. The 8HP90 is designed for higher torque loads, making it ideal for high-performance vehicles like the 2015 Dodge Challenger SRT Hellcat. The already-in-use 8HP70 will expand its duties to be used in 2015 Hemi models such as the Dodge Charger, Challenger, and Challenger SRT8. You can see the list of those benchmarks in Chrysler's press release below.

Ward's reveals annual 10 Best Engines list for 2013

Ward's Auto has released its annual 10 Best Engines award winners. The 2013 list covers the full width and breadth of the internal combustion spectrum, from a spate of efficient four-cylinders to the most powerful production V8 on the planet. As always, the entries must be available in a production vehicle in the first quarter of 2013 with an MSRP of less than $55,000. The supercharged 3.0-liter V6 from the Audi S5 held on for the fourth consecutive year, and BMW earned two spots on the list with its turbo 2.0-liter four-cylinder and turbo 3.0-liter inline-six.
Ford pulled in two awards for its 2.0-liter EcoBoost four-cylinder and and the supercharged 5.8-liter V8 from the Shelby GT500. Honda matched BMW and Ford with two wins of its own. Wards awarded the 2.4-liter four-cylinder from the Honda Accord Sport as well as the 3.5-liter V6 from the Honda Accord. Chrysler, General Motors and Subaru each garnered a spot on the list as well for the 3.6-liter V6 in the Ram 1500, the turbo 2.0-liter four-cylinder in the Cadillac ATS and the 2.0-liter four-cylinder the Subaru BRZ, respectively. You can read the full press release below for more information.

Chrysler recalling 280k Dodge Ram 1500 pickups over axle seizures

Following a June investigation by the National Highway Traffic Safety Administration, Fiat Chrysler Automobiles will be recalling 280,000 Dodge Ram pickups from model year 2005. The issue, NHTSA told The Detroit News, centered on a loose pinion nut, which could cause the rear axle to seize and, potentially, the driveshaft to detach. The affected vehicles were built between January of 2004 and August of 2005, while of the 280,000 trucks, only 257,000 were sold in the US market. According to The News, the recall will begin on February 13, and will see owners report to dealerships to have "a retention feature" added to the pinion nut.