2012 Ram 1500 St on 2040-cars

Auto blog

Chrysler says its 8-speed transmissions will save 700 million gallons

Chrysler Group's TorqueFlite eight-speed transmission could be earning some serious green bragging rights if the company's projections are correct. The recently widely proliferated automatic gearbox, which is now in more than a million vehicles around the world, is poised to save drivers an estimated 700+ million gallons of fuel over the vehicles' lifetimes (an expected cost savings of $2.5 billion). In addition, Chrysler expects a reduction in CO2 emissions by more than six million metric tons. According to Chrysler, and depending on the vehicle, the TorqueFlite can improve fuel economy. The TorqueFlite autobox features particularly close ratios from fifth to eighth gear (see the press release below for the specific numbers), and uses low-viscosity fluid that doesn't need to be replaced. Transmission software adapts to the driving situation to optimize efficiency based on driver behavior, temperature, grade, stability control, and longitudinal and lateral acceleration. The TorqueFlite is capable of handling a variety of duties. As evidenced by the wide range of vehicles Chrysler Group has seen fit to equip with the eight-speed transmission, the TorqueFlite is capable of handling a variety of duties. Since its 2012 introduction, the TorqueFlite has gone from performing cog-swapping duties in Dodge Charger and Chrysler 300 models equipped with the 3.6-liter Pentastar V6 to changing gears in vehicles such as the Pentastar- and Hemi-powered Dodge Durango, Jeep Grand Cherokee and even the Ram 1500 EcoDiesel. For the 2015 model year, the eight-speed is finding its way into even more vehicles with the addition of a third version. In addition to the American-made TorqueFlite 845RE and 8HP70, the new 8HP90 will be manufactured in Saarbrucken, Germany. The 8HP90 is designed for higher torque loads, making it ideal for high-performance vehicles like the 2015 Dodge Challenger SRT Hellcat. The already-in-use 8HP70 will expand its duties to be used in 2015 Hemi models such as the Dodge Charger, Challenger, and Challenger SRT8. You can see the list of those benchmarks in Chrysler's press release below.

Ram recalling 65k trucks for rear-axle heat treating

A problem with the rear axle has promoted Fiat Chrysler Automobiles to recall a selection of Ram trucks. The campaign affects 2015-16 Ram 1500 series trucks – specifically those manufactured between June 17 and September 28, 2015. All told, that amounts to over 65,760 units across the United States. The issue stems, according to the statements below, from the rear axle shaft. Some of those trucks may have not had those axle shafts properly heat-treated, which could cause them to fracture and separate from the wheel. And that, it should go without saying, could lead to a crash. FCA states that most of the vehicles in question are in dealer hands, but while the manufacturer says it is aware of one accident to have resulted from the issue, no injuries have been reported. The owners of the affected vehicles will be notified to bring their trucks in to their local dealership to have them inspected. If necessary, the dealership with replace the rear axle assembly. This recall follows three prior (but unrelated) ones, also issued for Ram pickups, that between them affected well over a million units. Related Video: RECALL Subject : Incorrectly Heat Treated Rear Axle Shaft Report Receipt Date: OCT 15, 2015 NHTSA Campaign Number: 15V661000 Component(s): POWER TRAIN Potential Number of Units Affected: 65,760 Manufacturer: Chrysler (FCA US LLC) SUMMARY: Chrysler (FCA US LLC) is recalling certain model year 2015-2016 Ram 1500 trucks manufactured June 17, 2015, to September 28, 2015. The affected vehicles may have been built with rear axles that were incorrectly heat treated. CONSEQUENCE: If the rear axle shaft was not properly heated treated, it may fracture and a wheel separation could occur, increasing the risk of a crash. REMEDY: Chrysler will notify owners, and dealers will inspect the vehicles and replace the axle assemblies, as necessary, free of charge. The manufacturer has not yet provided a notification schedule. Owners may contact Chrysler customer service at 1-800-853-1403. Chrysler's number for this recall is R59. NOTES: Owners may also contact the National Highway Traffic Safety Administration Vehicle Safety Hotline at 1-888-327-4236 (TTY 1-800-424-9153), or go to www.safercar.gov. ### Statement: Heat-treating October 27, 2015 , Auburn Hills, Mich. - FCA US LLC is voluntarily recalling an estimated 65,760 U.S.-market trucks – most of which are in dealer hands – to inspect and replace, as required, their rear axle shafts or rear axles.

Chrysler readying 20 Moparized vehicles for SEMA

The Las Vegas Convention Center has plenty of space for aftermarket companies and automakers to show off their wares, and it looks like Chrysler is taking advantage of the spacious floor plan. At next month's SEMA Show, Chrysler will have a full 20 cars from its six brands decked out with Mopar gear.
As a hint of what is to come, Chrysler released a handful of teaser sketches showing glimpses of modified Jeep Cherokee, Ram 1500, Fiat 500L and Chrysler 300 concept vehicles. The automaker will also use the venue to show off a new line of Jeep Performance Parts offered by the all-new Mopar Off-Road Division. In addition to the images, Chrysler also issued a brief press release - posted below - breaking down some of the "industry-first features" that Mopar has offered in recent years.