2dr Coupe S Low Miles Manual Gasoline 3.4l Flat 6 Cyl Meteor Grey Metallic on 2040-cars

Auto blog

NHTSA closes probe into 2011 Porsche 911 coolant leaks

The National Highway Traffic Safety Administration has announced that it will end its investigation into rapid coolant loss in 24,635 Porsche 911s built between 2001 and 2011. The models affected included the standard 911, GT2, GT3 and Turbo, as well as their variants (GT2 RS, GT3 RS and Turbo S).
NHTSA was investigating for "rapid coolant loss caused by coolant pipe-fitting failure, allegedly resulting in vehicle disablement and/or loss of vehicle control due to reduced traction for the affected vehicle or following traffic," according to the regulators website. "Most of the leak complaints did not appear to involve complete separation of the fittings and many were detected when the vehicle was parked," said NHTSA's statement.
There were 63 complaints and 336 warranty claims, although the investigation was initiated after ten complaints from customers. There have been no reports of crashes or injuries attributed to rapid coolant loss.

Porsche Cayenne, Panamera production halted by flooding

If you recently ordered a Porsche Cayenne or a Panamera, delivery may take a little longer than originally expected. Automotive News reports that production of both models has been temporarily halted at the Porsche assembly plant in Leipzig, Germany as the result of supply shortages caused by flooding in the nearby Czech Republic. The reason for the stoppage is that the body of the Cayenne - currently Porsche's best-selling model - is produced at a Volkswagen plant in the Czech city of Bratislava and shipped by train to Leipzig.
The report does not indicate why Panamera production has been stopped - that the five-door's body is made at a separate location in Hanover, Germany. However pre-assembly will continue on these models. At full capacity, the Leipzig plant can produce about 450 vehicles per day, and it isn't clear how long this weather-related stoppage will last.

Jack Olsen built a Porsche 911 to drive every day and conquer Willow Springs

Almost two years ago we wrote about the 12-Gauge Garage Jack Olsen built to house his multifarious Porsche 911 - its 1972 bodywork hides four decades of Porsche parts, like the transaxle from a 1977 911 and the engine from 1995 911, for example. It weighs 2,400 pounds and has 272 horsepower, and Olsen uses it daily driving and for track days, the latter excursions featuring homemade, bolt-on aero parts. German magazine Auto Bild stopped by Olsen's house to look in on the Porsche called "Black Beauty II," and we get a few more details about the mods he's made, like swapping out for fiberglass body panels and welding Fuchs wheel centers to wider Corvette barrels so he could run different tires. Most importantly, though, Olsen divulges his passion for lowering his lap time at Willow Springs. Randy Pobst set the lap record for a production car around the 2.5-mile Big Willow track in a Porsche 918 Spyder at 1:23.54 during a Motor Trend test (the outright record, according to Willow Springs, is held by Michael Andretti at 1:06.050 in a CART car). Further down the list, Steve Millen drove a 415-hp 911 GT3 RS around the same track in 1:33.14 - a car 600 pounds heavier than Olsen's. Over the past 14 years of tinkering with his car, Olsen says his data shows his lap time is now down to 1:26.88, achieved on the day of filming the Auto Bild video. That time would put him in between the 1:26 flat posted by Dominik Farnbacher in a 608-hp Dodge Viper SRT-10 ACR and the 1:28.93 put up by Pobst in a 400-hp, 991-series 911. You can hear Olsen tell it in his own words in the video.