1969 Pontiac Gto Convertible on 2040-cars

Auto blog

GM recalls 61k more vehicles in three campaigns

Following a stop-delivery order for its new midsize trucks and a rash of recent recalls, General Motors is issuing three more campaigns covering 60,575 vehicles in North America with 57,182 of them in the US. As of October 1, the automaker has issued a total of 74 recalls (see the ridiculously long chart to the right) this year covering 26,495,070 units in the US.
The largest campaign covers 46,873 examples in the US of the 2008-2009 Pontiac G8 and 2011-2013 Chevrolet Caprice Police Patrol Vehicle imported from Australia. It's possible for the driver's knee to hit the key and make it move from the "Run" to "ACC" position while driving. GM says its Holden division is developing a fixed-blade key that's supposed to fix the problem by only allowing it to rotate toward the "On" position. There has been one crash caused by this fault but no injuries or fatalities.
The second recall is for 10,005 units of the 2004-2007 Cadillac CTS-V and 2006-2007 Cadillac STS-V because "the fuel pump module electrical terminal may overheat." This can cause a flange to melt and allow the pump to leak fuel. GM specifies that the remedy for the CTS-V is replacing the fuel module and fuel tank jumper harness, but it doesn't specify how the STS-V is being repaired.

'We're not a hedge fund': Porsche plans to curtail speculators and flippers

A sizable number of speculators view cars as an investment. Rare or unusual models are quickly snapped up and either parked for years or flipped for a profit. Cars from automakers like Porsche and Ferrari are more prone than others, and at least some people behind these models are getting a bit tired of it. While it's difficult to police what goes on after you sell a car, Porsche has some plans that might curtail the problem before it starts. Andreas Preuninger, the head of GT road-car development and the man behind the new 911 GT3, spoke to Car and Driver at a recent event. "I personally like to see my cars being used," he said. "That's what we build them for. They are just too good to be left to stand and collect dust." One recent example of this rampant speculation is the 911 R. While the special manual-only model sold for $185,950 when new, used versions were selling for nearly $1.3 million just months after it went on sale. While the car is a masterpiece and an instant classic, a good number will be parked and simply used as art and not the rolling testaments to the man/machine interface they were intended to be. The concern over valuations has become so fierce that some owners are upset that Porsche is offering the new 911 GT3 with a manual transmission, fearing that it may hurt the value of the 911 R. "When I said we're not a hedge fund, I'm talking to those people who are yelling at us for offering the manual transmission similar to the R," Preuninger said. "But if there are people wanting to buy cars like that, then as a company we should try to fulfill that, to meet that demand." It seems Porsche is keeping a close eye on who is flipping cars. Since there is often far more demand than supply with certain models, the German automaker has a name for every car before it's built. Buyers with bad reputations might not even make the wait list. Related Video:

Gordon Murray, F1-driven production and .. the Pontiac Fiero

Gordon Murray's design and engineering chops are unquestionable. But does his carmaking approach owe something to the short-lived Pontiac Fiero, a scrappy little car program that emerged from GM against serious resistance? Murray had a Formula One career that ran from 1969 to 1991, with stints at Brabham ('69 to '86) and McLaren ('87-'91), that resulted in several shelves' worth of trophies for the cars he was instrumental in designing. He moved on to McLaren Cars, the consumer side of things, where, during his tenure from 1991 to 2004, he helped design the McLaren F1 and the Mercedes-Benz SLR McLaren, two cars that took learnings from his two decades in Formula One. What do all of these cars have in common? Three things: They are light. They were built in limited numbers. And they were (and are) exceedingly expensive—when the McLaren F1 debuted in 1994, it stickered at $815,000. Murray went on to establish Gordon Murray Design in 2007. GMD has created some interesting concept vehicles, such as the diminutive T.25 city car (94.5 inches long, 51.1 inches wide and 55.1 inches high), and the OX, a lightweight truck for the developing world that packs like an IKEA shelf and is working toward realization through a worthy crowdfunding campaign established by the Global Vehicle Trust. Now he has created a vehicle manufacturing company, Gordon Murray Automotive, that will use manufacturing methods that he developed under the moniker "iStream." Unlike a unibody, there are the "iFrame," a cage-like construction made with metallic components, and the "iPanels," which are composite. The panels aren't simply a decorative skin; they actually provide structure to the vehicle. Presumably this has something of the F1 monocoque about it. Going back to the three elements, (1) this arrangement results in a vehicle that can be comparatively light; (2) Murray has indicated that his manufacturing company will be doing limited-run production; and (3) to launch Gordon Murray Automotive they are going to be building a flagship model, about which Murray said, "With our first new car, we will demonstrate a return to the design and engineering principles that have made the McLaren F1 such an icon." Which seems to imply that it will be on the pricey side. According to the company's verbiage, "iStream forges an entirely new production method that defies conventionality with its Formula One-derived construction and materials technologies." It also sounds a whole lot like ...