2000 Pontiac Grand Prix Gtp Coupe 2-door 3.8l Daytona 500 Pace Car on 2040-cars

Auto blog

Junkyard Gem: 1986 Pontiac Fiero GT

If you like affordable, mid-engined two-seaters, the 1980s were your decade. Fiat (and, a bit later, Bertone) offered the X1/9, Toyota sold MR2s, and even General Motors got into the act by creating the Fiero. Available from the 1984 through 1988 model years, the Pontiac Fiero showed plenty of promise but ended up being mostly disappointing, in some ways echoing the career of the Chevy Corvair of a couple of decades earlier. Today's Junkyard Gem is a once-spiffy 1986 Fiero GT, found in a self-service yard near Denver, Colorado. After a long and painful development period stretching all the way back to John DeLorean's XP-833 Banshee (which ended up being a major influence behind the original Opel GT), the Fiero finally debuted in 1983 as a 1984 model. The top-of-the-model-range GT appeared the following year. The Fiero was built as a notchback coupe and as a fastback, with all the GTs being the latter type. I couldn't get the engine lid open, but this car would have left the assembly line (in Pontiac, Michigan) with a 2.8-liter V6 rated at 140 horsepower. This car has a five-speed manual transmission, making it a credible rival for Toyota's MR2.  The 1986 MR2 was less powerful than the Fiero GT (112 horsepower versus 140), but also scaled in significantly lighter (2,459 pounds against the Pontiac's 2,780 pounds). The MR2 also cost less, priced at $11,298 while the Fiero GT cost $12,875 (that's about $30,540 and $34,805, respectively, in inflation-adjusted 2022 dollars). Meanwhile, the $6,998 Honda Civic CRX two-seater lured away many potential Fiero buyers despite being a front-engined/front-wheel-drive car, and the $7,186 Ford EXP/Mercury LN7 also put a dent in Fiero sales. I can't find a price for the 1986 Bertone X1/9, but it cost a hard-to-believe $13,990 in 1984. GM still was using five-digit odometers in many vehicles by the middle 1980s, but this Fiero has a six-digit unit and thus we can see that it nearly achieved 150,000 miles during its driving career. The 1984-1987 Fiero suffered from a parts-bin suspension design, with the front suspension borrowed from the Chevrolet Chevette and the entire rear transaxle/suspension assembly lifted from the front end of the Chevrolet Citation. For the 1988 model year, GM finally spent the money to design an improved Fiero-specific suspension … and then promptly put a halt to production.

GM Design shows what could have been and what might be

We periodically like to check in with GM Design's Instagram account to see what they're cooking up. Even better is when we catch a glimpse of an alternate history of what legendary designers from The General's past were thinking, though those ideas may not have made it into production. This week, for example, the account posted some illustrations from George Camp, whose career at GM spanned nearly four decades, from 1963 to 2001. One of the renderings is of what appears to be a 1971-72 Pontiac GTO Judge, but with two headlights instead of the production unit's quad beams. The rear departs from the canonical version most dramatically, with a massive integrated wing. Other bits that didn't make the production cut include large side vents, a gill-like side marker and rectangular intakes below the headlights that wouldn't be out of place on a modern design today. Amazingly, from what we can make out of the date, it appears that the drawing was done sometime in 1965, which makes it quite prescient.           View this post on Instagram                       A post shared by GM Design (@generalmotorsdesign) There's also a very aerodynamic interpretation of a Corvette ZR-1. To our eyes it splits the difference between the 1986 Corvette Indy concept and a fourth-generation F-body Pontiac Firebird, so perhaps parts of Camp's work on this sketch did make it into physical form. There's also a radical sports car concept from May 1970 that resembles the Mazda RX-500 concept from the same year, a Syd Mead-looking Cadillac coupe, and an Oldsmobile with a cool take on the company's trademark waterfall grille and elements of the Colonnade Cutlass at the rear. Other recent posts include a FJ Cruiser-like off-road EV, a sleek coupe with the Chevy corporate grille, and a rendering of a Silverado-esque pickup that looks far better than the current production version.           View this post on Instagram                       A post shared by GM Design (@generalmotorsdesign) It's pretty easy to lose hours in the account, but it's always fascinating to see GM's visions of what could have been and what might be. Related Video:

Junkyard Gem: 1989 Pontiac Sunbird SE Coupe

General Motors built the fantastically successful J-Body cars starting at the dawn of the 1980s and continuing well into our current century, on five continents. The Pontiac Division's version of the J started out being called the J2000 and the 2000, then got the Sunbird name originally used on the Pontiac-ized Chevy Monza starting in 1983. Here's a once-slick-looking 1989 Sunbird SE Coupe, found at a Minneapolis-area boneyard way back in 2016. The best-known of all the J-Body cars, here, was the Chevrolet Cavalier, but Pontiac far outdid even the most blinged-up Cavalier Z24 when it came to elaborate taillights. Because this is Minnesota, the car is a patchwork of various layers of junkyard-obtained rusty body parts. One fender has TURBO badges from a Sunbird GT. The other side has the correct engine badges for this model. That engine is a 2.0-liter, single-overhead-cam straight-four from an engine family originally developed for the Opel Kadett D. This one was rated at 96 horsepower when new. This one has the automatic transmission, so it wouldn't have been very much fun to drive. Check out that cool parking brake handle, though! And, hey, is that a full can of Colorado Cool-Aid in the foot well? You'd think a proper Minnesota Pontiac would at least be full of Grain Belt cans. It appears that Higley Ford in Windom, Minn., had this car on the lot at some point. Windom is closer to Sioux Falls than to Minneapolis. This final mileage total looks good for a car living in Tinworm Country. Pontiac built this generation of Sunbird from the 1988 through 1994 model years, though it was really just a facelift of the first-generation cars. Starting in 1995, the Pontiac J-Body became the Sunfire, and production continued until the J platform itself got the axe in 2005. This content is hosted by a third party. To view it, please update your privacy preferences. Manage Settings. In the 90s, fun will become the exclusive province of the rich. To which the Sunbird driver replies, "Bullish!" Related Video: This content is hosted by a third party. To view it, please update your privacy preferences. Manage Settings.