2002 Pontiac Trans Am Collectors Edition #1521 40k Miles 6 Speed Original Stock on 2040-cars

Auto blog

'67 Chevy Corvair convertible vs. '86 Pontiac Fiero in cult classic showdown

Every few a decades, the folks running General Motors lose their minds briefly try to market a car that public doesn't see coming and often aren't ready for. In the '60s there was the rear-engine, air-cooled Chevrolet Corvair, then the mid-engine Pontiac Fiero in the '80s and the completely bizarre Chevy SSR in the 2000s. What all of these had in common was that they bucked the trend for American models of their era, for better or worse. The latest episode of Generation Gap tasked the hosts with finding two cult classic vehicles to choose between; they came come up with two of these quirky products from The General.
On the classic side, there's a 1967 Chevy Corvair Monza convertible. Being from later in the production run, it wears slightly more aerodynamic styling than the earlier, boxier examples. Hanging out back is an air-cooled, 2.7-liter flat-six pumping out a robust 95 horsepower. In the other corner is the somewhat more modern 1986 Pontiac Fiero SE with a mid-mounted, 2.5-liter "Iron Duke" four-cylinder, an engine nearly ubiquitous in GM cars of the '80s.
Judging by when they were new, the Corvair was far more successful than the Fiero with over 1.8 million sold. Of course, Ralph Nader's book Unsafe at Any Speed kind of poisoned the well, even if the poor safety reputation wasn't entirely deserved. The Fiero on the other hand only lasted for a few model years before shuffling off, but it eventually got its own performance boost with the V6 version and rather attractive GT models. Check them both out in the video and tell us in Comments which you want in your garage.

GM knew about fatal Chevy ignition problem decade before recall

Well, this is not good for General Motors. Following a report last week that GM was recalling 778,000 Chevrolet Cobalt and Pontiac G5 compacts over concerns that the ignition could switch out of the "run" position without warning, USA Today reports that the Detroit-based behemoth knew about the issue, which affected 2005 to 2007 Cobalts (the Cobalt shown above and in the gallery is from 2010) and 2007 Pontiac G5s, all the way back in 2004.
The information comes from a deposition in a civil lawsuit against GM, obtained by USA Today, which claims that a GM engineer experienced the issue while the then-new model was undergoing testing. The issue was "solved" when a technical service bulletin was issued in 2005, informing dealers to install a snap-on key cover on the cars of customers who complained about the issue. According to the Cobalt's program engineering manager, Gary Altman, the cover was an "improvement, it was not a fix to the issue."
The case where the depositions were made was from 2010, and involved Brooke Melton, a 29-year-old pediatric nurse in Georgia who was killed on her birthday. At the time, police claimed she was going too fast on a wet, rural road, although it later came out through the black box that her car's ignition had come out of the "run" position at least three seconds before the accident (the max amount of time a black box records before a wreck), disabling her airbags, power steering and anti-lock brakes. According to USA Today, police said Melton was "traveling too fast for the roadway conditions," although it's impossible to know if she'd have been in the wreck, which injured the occupants of another vehicle, had her 2005 Chevy not shut off. GM settled the Melton family's case, although the details remain confidential.

CNN chronicles young girl building Pontiac Fiero

At fourteen years of age, Kathryn DiMaria has already done what many self-proclaimed gearheads won't even attempt in their lifetimes. The Dearborn, Michigan teen is rebuilding a car from the ground up.
The intrepid youngster asked her parents when she was just twelve to start a Pontiac Fiero project, even offering to pony up all the funds herself. Father, Jerry DiMaria only expected the project to last a few months, but two years later, Kathryn is still at it. In this CNN video, the two are at Maker Faire (a DIY festival) rebuilding a 3.4-liter V6 engine out of a Chevrolet Camaro to replace the 2.8-liter mill found in the Fiero.
The whole family hast pitched in, with Kathryn's mother teaching her how to sew in order to complete the interior, father Jerry providing much of the technical know-how, and even her sister is chronicling Kathryn's progress through photos. Jerry even started a thread in a Fiero forum which has been live for two years and is now 22 pages long. Of the project, one forum member wrote, "welcome to the madness."