2004 Pontiac Grand Prix Gt1 Sedan 4-door 3.8l on 2040-cars

Auto blog

Junkyard Gem: 1986 Pontiac Fiero GT

If you like affordable, mid-engined two-seaters, the 1980s were your decade. Fiat (and, a bit later, Bertone) offered the X1/9, Toyota sold MR2s, and even General Motors got into the act by creating the Fiero. Available from the 1984 through 1988 model years, the Pontiac Fiero showed plenty of promise but ended up being mostly disappointing, in some ways echoing the career of the Chevy Corvair of a couple of decades earlier. Today's Junkyard Gem is a once-spiffy 1986 Fiero GT, found in a self-service yard near Denver, Colorado. After a long and painful development period stretching all the way back to John DeLorean's XP-833 Banshee (which ended up being a major influence behind the original Opel GT), the Fiero finally debuted in 1983 as a 1984 model. The top-of-the-model-range GT appeared the following year. The Fiero was built as a notchback coupe and as a fastback, with all the GTs being the latter type. I couldn't get the engine lid open, but this car would have left the assembly line (in Pontiac, Michigan) with a 2.8-liter V6 rated at 140 horsepower. This car has a five-speed manual transmission, making it a credible rival for Toyota's MR2.  The 1986 MR2 was less powerful than the Fiero GT (112 horsepower versus 140), but also scaled in significantly lighter (2,459 pounds against the Pontiac's 2,780 pounds). The MR2 also cost less, priced at $11,298 while the Fiero GT cost $12,875 (that's about $30,540 and $34,805, respectively, in inflation-adjusted 2022 dollars). Meanwhile, the $6,998 Honda Civic CRX two-seater lured away many potential Fiero buyers despite being a front-engined/front-wheel-drive car, and the $7,186 Ford EXP/Mercury LN7 also put a dent in Fiero sales. I can't find a price for the 1986 Bertone X1/9, but it cost a hard-to-believe $13,990 in 1984. GM still was using five-digit odometers in many vehicles by the middle 1980s, but this Fiero has a six-digit unit and thus we can see that it nearly achieved 150,000 miles during its driving career. The 1984-1987 Fiero suffered from a parts-bin suspension design, with the front suspension borrowed from the Chevrolet Chevette and the entire rear transaxle/suspension assembly lifted from the front end of the Chevrolet Citation. For the 1988 model year, GM finally spent the money to design an improved Fiero-specific suspension … and then promptly put a halt to production.

This junkyard '91 Grand Am is as hooptie as it gets

I spend a lot of time in junkyards. A lot of time. With all this experience, I have learned to recognize a perfect hooptie when I see one, a car whose final owner got every last bit of use out of it when its value was hovering right about at scrap value. This 1991 Pontiac Grand Am that I spotted in a San Francisco Bay Area self-service wrecking yard a few days ago, from the final model year for the third-generation Grand Am, checks all the hooptie boxes just right. First of all, it's a low-option coupe with the wretched and unloved GM Iron Duke engine, a rattly, gnashy, thrashy 2.5-liter four-cylinder kludged together using off-the-shelf parts from the Pontiac 301-cubic-inch V8 during the darkest years of the Malaise Era and used in cars whose buyers just didn't care. Most of the paint has been burned off by 25 years of harsh California sun, but the car spent sufficient time in a damp, shady spot for lichens to build up here and there. There are skeletons-with-sombreros stencils sprayed here and there, plus a big moonshine-guzzling skeleton mural painted on the hood. Goodbye, property values! Still, someone felt some affection for this car, giving it the name "Good Ol' Snakey" and painting that name on the decklid. We can assume that the Iron Duke was a bit loose by this time, probably leaving a serpentine trail of blue smoke behind the car at all times. So, the combination of cheapness, ugliness, menace, and who-gives-a-damn functionality make this Grand Am an excellent example of a pure hooptie. Within a couple of months, it will be crushed, shredded, shipped out of the Port of Oakland, and reborn in China as refrigerators and Geely Emgrands. Somewhere in Northern California, though, a few of Ol' Smokey's friends will remember this car fondly.

This classic Firebird restomod swallowed a Prius

It takes an unusual eye to look at a 1967 Pontiac Firebird and see the Toyota Prius hidden inside. But that's just the kind of eye that a creative mechanic known online as "Bill the Engineer" has. Bill is updating his old Firebird into a true classic for the 21st century and has documenting the changes over at Priuschat and EcoModder. The TL,DR version of the story: he's replacing the worn-out powertrain with the gas-electric hybrid one from a Prius V, because it turns out the two vehicles have almost exactly the same wheelbase. Bill, who's from Columbus, Ohio and doesn't want his full name used, said in his posts on the conversion project that he's made many memories with this vehicle since buying it back in 1979. Since then, a few moves, a few decades, and some time in storage meant that the car would no longer function as he wanted it to. As he wrote, "when it comes to mice in the vehicles IT IS WAR." His solution is to make new memories and making a greener vehicle, and so we wanted to ask him how things have been going. Bill's been traveling a bit recently, but told AutoblogGreen that he's now figuring out the next steps for this amazing and complicated project. "I always plan things out before I do them," he said. That's the only way something like this can work. ABG: I think we have to start with what gave you the inspiration for this project. Was it simply that you had the two cars and wanted to see them merged into one cool mashup, or was it something else? "One day my wife wondered out loud if the car could be converted into a hybrid... The rest is history." Bill: I have been the owner of my 1967 Firebird convertible since 1979 when I bought it for $750.00. I drove it for years and made many memories. Afterward it was in storage for many years during which time mice at their way into the car and trashed the interior and wiring. I started working on a conventional restoration but always ran into major problems with hidden corrosion, electrical issues and an engine on its last legs. The car was never going to be as nice as I wanted going the conventional route. One day my wife wondered out loud if the car could be converted into a hybrid like our two daily driver Prii. That got me thinking about how it could be done. The rest is history... ABG: It looks like you started in late 2014. Have things gone well since then, or has it been one hassle after another? What has been the biggest setback, and what were the biggest victories?