2002 Nissan Xterra Passanger Runing Board on 2040-cars
San Diego, California, United States
Fuel Type:GAS
Engine:3.3L 3275CC V6 GAS SOHC Naturally Aspirated
Vehicle Title:Clear
Number of Cylinders: 6
Make: Nissan
Model: Xterra
Trim: SE Sport Utility 4-Door
Mileage: 12,000
Drive Type: 4WD
02 xterra running board in very good shape, passanger side
Nissan Xterra for Sale
- 4x4, auto, 6 cylinder, clean carfax, low miles!(US $6,199.00)
- Nissan xterra s 2011 - no reserve - low miles - factory warranty - 4wd 4x4
- 2001 nissan xterra se sport utility 4-door 3.3l sell as parts only - frame bent
- We finance! s 4x4 4.0l v6 6 speed manual alloys cd carfax certified unbeatable!(US $7,900.00)
- 2003 nissan xterra se 1-owner low miles very clean!!(US $9,900.00)
- One owner clean car-fax local trade in low reserve great deal
Auto Services in California
Yoshi Car Specialist Inc ★★★★★
WReX Performance - Subaru Service & Repair ★★★★★
Windshield Pros ★★★★★
Western Collision Works ★★★★★
West Coast Tint and Screens ★★★★★
West Coast Auto Glass ★★★★★
Auto blog
Renault planning a Tata Nano rival. Again.
Wed, 28 Nov 2012Four years ago, Renault confirmed that it would partner with India's Bajaj Auto to develop a rival to the Tata Nano. At the time, as everyone waited for the Tata Nano to arrive, you could have used a Richter scale to measure the tremors the executive suites of any automaker with an interest in the low end of emerging markets. Then the Nano, still the cheapest car in the world, didn't sell so well - at the end of last year its sales were just six percent of its most conservative projections - and everyone seemed content to let Tata spend the money to figure out if there really was a market for the cheapest car in the world.
Renault believes there is, kind of. Automotive News Europe reports that it will partner with Nissan to build two low-priced cars for emerging markets, one for €3,000 ($3,888 U.S.) and another for €5,000 ($6,400 U.S.). The price of the least expensive offering is nearly $1,400 more than a Nano, which costs $2,500, and that can't be considered a small sum in comparison. But one of the hindsight knocks on the Nano has been that even in emerging markets buyers don't want a car whose biggest lure is that it is cheap; they'd rather give their aspirations a bit more of a workout.
Renault's offerings are scheduled to hit the non-Western market in late 2014, which is coincidentally the same year that will see the return of the budget-minded and emerging-market-specific Datsun nameplate. They'll be built in Renault facilities in Chennai, India, with no mention made of Bajaj this time around.
Nissan Juke-R pitted against Bugatti Veyron in brilliantly odd drag race
Mon, 10 Jun 2013The Nissan Juke-R must've been a tough car to build a business case for, yet the madcap little crossover with the heart of a GT-R is now a production reality. Admittedly, we should probably assign some quotes around "production," since the vehicle is being built on a one-by-one on-demand basis at extraordinary cost - at an estimated price of well over $600,000, it has little in common with the already bonkers everyday Juke. We're just happy it exists at all.
With 545 horsepower, we also didn't figure it needed more power. But that apparently hasn't stopped the tuning community, which probably only had to adapt performance adders designed for the GT-R to the mechanically similar CUV. Thus, we end up with this mile-long drag race, which pits a Bugatti Veyron against a Juke-R prepared by an outfit called Shpilli Villi Engineering with a claimed 700 horsepower. That's still well down on horsepower versus the legendary quad-turbo supercar, but the much smaller Nissan also figures to be a lot lighter while boasting similar all-wheel-drive traction. We don't have much more information to go on other than this video, and it doesn't appear that both drivers necessarily got their best runs in, but it certainly makes for jaw-dropping watching. Check it out by scrolling below.
Daimler and Nissan to build luxury cars at new plant in Mexico
Thu, 05 Sep 2013A few years back, when Daimler was looking for a partner to spread the cost of development of small cars, it agreed to collaborate with Nissan on future products, such as vehicle platforms and drivetrains. The latest development in the collaboration concerns the assembly of small luxury cars for Infiniti and Mercedes-Benz at a Nissan plant in Mexico, two unnamed sources told Reuters.
The plant in question, Aguascalientes, is a $2 billion project that will open later this year next to an existing Nissan factory. The upcoming Infiniti Q30 four-door hatchback is expected to be built there, possibly alongside the Mercedes GLA-Class, which is one of several candidates Mercedes is considering to build at this facility, Reuters reports. The GLA will debut at the Frankfurt Motor Show this month, and initial production of the model will take place in Germany. The Q30 could follow a similar path, with assembly starting at Nissan's Sunderland plant in the UK, and then expanding to Aguascalientes later on.
The underlying platform of the Q30 and GLA, codenamed New Generation Compact Car (NGCC), was developed by Daimler. The Q30 would be the first Infiniti produced under the automakers' agreement. Last year, Nissan agreed to make engines that would find their way into Mercedes and Infiniti vehicles.