Fwd 3.5l V6 Sunroof Leather & Heated Seats Cd Changer W/aux Certified Warran on 2040-cars

Auto blog

Nissan recalling 909k vehicles globally over accelerator issue

Nissan is issuing a massive recall that will see the Japanese automaker repair 908,900 vehicles worldwide, with nearly 100,000 of the affected models in the United States. While an official recall notice from Nissan or the National Highway Traffic Safety Administration is not yet available, Reuters has been able to confirm the recall with Nissan.
Nissan's recall is kind of the opposite of the Toyota unintended acceleration, in that it covers a lack of acceleration. According to the report, a sensor in the gas pedal can develop faults, leading to a sluggish acceleration or an outright stall regardless of how much throttle the driver dials in. The huge recall covers mostly Japanese domestic models like the Serena, X-Trail, Lafesta and Fuga, which make up for 764,800 of the 908,900 faulty vehicles. However, 98,300 Infiniti M sedans are being recalled in the US, although it's unclear at this time which model years and trims are affected. The remaining vehicles are found in Europe and Oceania, according to Nissan spokesman Chris Keefe.
No injuries or accidents have been reported due to the faults. The 90-minute repair will see techs replace the accelerator pedal and tweak the engine control programs. We'll update this story as soon as Nissan or NHTSA makes an official statement.

Infiniti's new VC-T changes the rules of small turbocharged engines

The upcoming Infiniti QX50 crossover does not get our pulse racing, no matter how shapely the QX Sport Inspiration concept that previews it may be. No midsize SUV does, to be fair. But it has something special under the hood – the world's first production variable-compression-ratio engine. That means the QX50's 2.0-liter turbo four, which makes 268 horsepower and 288 pound-feet of torque, will have up to 27 percent better fuel economy. Here's how it works. The trend of moving to smaller, turbocharged engines carries with it one big falsehood. Under low load when the turbo isn't needed, these engines are less efficient than an equivalent engine without a turbo because of the low compression ratio the turbo requires. That is, if you never need the extra power, you're wasting fuel. Turbocharged (and supercharged) engines use a lower compression ratio to prevent detonation. When you force extra air in a cylinder and mix it with fuel, it's more likely to prematurely go boom. Lowering the compression ratio prevents this problem, but it's less efficient. Infiniti's VC-T promises the best of both worlds, with a compression ratio that ranges from 8.0:1 for high-power turbo needs to a 14.0:1 ratio for fuel-sipping efficiency. At its heart the VC-T engine is a simple idea, but it's complicated to explain. Consider yourself warned. The photo below from Infiniti serves as a good visual overview. For the truly nerdy, this patent application covers the mechanical concept. Instead of having the pistons connected to the crankshaft, Infiniti's engine has a pivot arm with a connection on each end. One end connects to the piston, the other connects to a second lower shaft, which is controlled by an actuator arm. At any given time the engine's pistons move up and down according to the lobes on the crankshaft. But the actuator arm can change the angle of the pivot arm up and down. That is, the pistons still move in the same motion with the same stroke, but phase the entire stroke up or down. Move the pivot up and there's less room at the top, which means a higher compression ratio. Move the pivot down and the compression ratio goes down, too. As an added bonus, the lower shaft eliminates the need for counter-rotating balance shafts. Infiniti says this system works constantly and can vary the compression ratio to any number between 8:1 and 14:1. It also uses electronic variable valve timing on the intake valves to switch into Atkinson-cycle combustion for greater efficiency.

UAW calls on US State Department to help with Nissan plant

The United Auto Workers is calling for reinforcements in its ongoing battle with Nissan at the manufacturer's Canton, MS factory, where the Altima, Armada, Titan and NV (and eventually, the next Murano) are built. The union has been attempting to organize the employees at the factory for several years, but it's been largely unsuccessful.
Now, Reuters is reporting that the UAW is teaming with the IndustriALL Global Union and requesting intervention by the US State Department, with both groups accusing Nissan of using "threats, intimidation and fear" to keep the 5,600 workers at the facility from organizing. The two unions say this violates the guidelines of the Organization for Economic Cooperation and Development, an international organization dedicated to stimulating economic growth.
The UAW and IndustriALL are asking the State Department's National Contact Point to serve as mediator with Nissan, to make sure things play out fairly. Speaking to Reuters, though, there's at least one Michigan-based labor adviser that's skeptical of the move.