2001 Nissan Altima Gxe Sedan 4-door 2.4l on 2040-cars

Auto blog

Can a car be lifted using rubber bands?

It's quite amazing what it takes to lift a car. We already know the feat can be accomplished using just a pair of phone books, but what about rubber bands? To the Internet! A video series appropriately titled "Will It Lift" attempted to find out by using a massive crane and a Nissan Micra weighing less than 1,800 pounds.
Doing a little math, the trio determined that it would take 180 rubber bands to support the car. A metal bar was placed through the window openings and another was place atop the car, and then attached together using the rubber bands and hooked to the crane. Now these aren't any special rubber bands or anything. They're just eight-millimeters thick, but the stunt is testing the rubber bands' power in numbers.
We're not going to spoil it for you, so scroll down to check out the video of the stunt.

DC fast charging not as damaging to EV batteries as expected

As convenient as DC fast charging is, there have been lots of warnings that repeated dumping of so many electrons into an electric vehicle's battery pack in such a short time would reduce the battery's life. While everyone agrees that DC fast charging does have some effect on battery life, it may not be as bad as previously expected. Over on SimanaitisSays, Dennis Simanaitis, writes about a recent presentation by Matt Shirk of the Idaho National Laboratory (INL) called DC Fast, Wireless, And Conductive Charging Evaluation Projects (PDF) that describes an ongoing test of four 2012 Nissan Leaf EVs that are being charged in two pairs of two. One pair only recharges from 50-kW DC fast chargers, which the other two sip from 3.3-kW Level 2 chargers exclusively. Otherwise, the cars are operated pretty much the same: climate is automatically set to 72 degrees, are driven on public roads around Phoenix, AZ and have the same set of dedicated drivers is rotated through the four cars. "Degradation depends more on the miles traveled than on the nature of recharging." What's most interesting are the charts on page seven of Shirk's presentation (click the image above to enlarge), which show the energy capacity of each of the four vehicles. When they were new, the four batteries were each tested to measure their energy capacity and given a 0 capacity loss baseline. They were then tested at 10,000, 20,000, 30,000 and 40,000 miles, and at each point, the DC-only EVs had roughly the same amount of battery loss as the Level 2 test subjects. The DC cars did lose a bit more at each test, but only around a 25-percent overall loss after 40k, compared to 23 percent for the Level 2 cars. Simanaitis' takeaway is that, "INL data suggest that the amount of degradation depends more on the miles traveled than on the nature of recharging." The tests are part of the INLs' Advanced Vehicle Testing Activity work and a final report is forthcoming. These initial numbers from IPL do mesh with other research into DC fast charging, though. Mitsubishi said daily fast charging wouldn't really hurt the battery in the i-MiEV and MIT tests of a Fisker Karma battery showed just 10-percent loss over 1,500 rapid charge-discharge cycles.

Daimler and Nissan to build luxury cars at new plant in Mexico

A few years back, when Daimler was looking for a partner to spread the cost of development of small cars, it agreed to collaborate with Nissan on future products, such as vehicle platforms and drivetrains. The latest development in the collaboration concerns the assembly of small luxury cars for Infiniti and Mercedes-Benz at a Nissan plant in Mexico, two unnamed sources told Reuters.
The plant in question, Aguascalientes, is a $2 billion project that will open later this year next to an existing Nissan factory. The upcoming Infiniti Q30 four-door hatchback is expected to be built there, possibly alongside the Mercedes GLA-Class, which is one of several candidates Mercedes is considering to build at this facility, Reuters reports. The GLA will debut at the Frankfurt Motor Show this month, and initial production of the model will take place in Germany. The Q30 could follow a similar path, with assembly starting at Nissan's Sunderland plant in the UK, and then expanding to Aguascalientes later on.
The underlying platform of the Q30 and GLA, codenamed New Generation Compact Car (NGCC), was developed by Daimler. The Q30 would be the first Infiniti produced under the automakers' agreement. Last year, Nissan agreed to make engines that would find their way into Mercedes and Infiniti vehicles.