2001 Nissan Sentra, No Reserve on 2040-cars

Auto blog

Did Nissan send a ringer GT-R to run the 'Ring? [w/video]

It turns out that after toting a 7:08 time around the fearsome Nürburgring Nordschleife for the new Nismo-tuned GT-R, Nissan might not have been entirely honest about the car it was using. From what we've been hearing from a few different publications, the GT-R featured in the video isn't what we're going to see on the production model.
PistonHeads reported on the so-called "Time Attack" GT-R while it was in Japan for the Tokyo Motor Show, going so far as to detail the differences between it and the standard GT-R Nismo. And friends, this isn't just a matter of swapping tires. The mods made to the Time Attack car are far more comprehensive.
For a start, the TA produces more downforce thanks to larger aerodynamic pieces. It's some 110 pounds lighter than the standard car, thanks to new bucket seats. The ECU and dampers have been swapped for new units, and the brake pads are different as well. If you've read this far, you might be feeling slightly angry or betrayed that Nissan is toting numbers for a modified car. Don't be.

DC fast charging not as damaging to EV batteries as expected

As convenient as DC fast charging is, there have been lots of warnings that repeated dumping of so many electrons into an electric vehicle's battery pack in such a short time would reduce the battery's life. While everyone agrees that DC fast charging does have some effect on battery life, it may not be as bad as previously expected. Over on SimanaitisSays, Dennis Simanaitis, writes about a recent presentation by Matt Shirk of the Idaho National Laboratory (INL) called DC Fast, Wireless, And Conductive Charging Evaluation Projects (PDF) that describes an ongoing test of four 2012 Nissan Leaf EVs that are being charged in two pairs of two. One pair only recharges from 50-kW DC fast chargers, which the other two sip from 3.3-kW Level 2 chargers exclusively. Otherwise, the cars are operated pretty much the same: climate is automatically set to 72 degrees, are driven on public roads around Phoenix, AZ and have the same set of dedicated drivers is rotated through the four cars. "Degradation depends more on the miles traveled than on the nature of recharging." What's most interesting are the charts on page seven of Shirk's presentation (click the image above to enlarge), which show the energy capacity of each of the four vehicles. When they were new, the four batteries were each tested to measure their energy capacity and given a 0 capacity loss baseline. They were then tested at 10,000, 20,000, 30,000 and 40,000 miles, and at each point, the DC-only EVs had roughly the same amount of battery loss as the Level 2 test subjects. The DC cars did lose a bit more at each test, but only around a 25-percent overall loss after 40k, compared to 23 percent for the Level 2 cars. Simanaitis' takeaway is that, "INL data suggest that the amount of degradation depends more on the miles traveled than on the nature of recharging." The tests are part of the INLs' Advanced Vehicle Testing Activity work and a final report is forthcoming. These initial numbers from IPL do mesh with other research into DC fast charging, though. Mitsubishi said daily fast charging wouldn't really hurt the battery in the i-MiEV and MIT tests of a Fisker Karma battery showed just 10-percent loss over 1,500 rapid charge-discharge cycles.

Asian automakers still reluctant to use more aluminum

There's a logical progression of technology in the auto industry. We've seen it with things like carbon-ceramic brakes, which use to be the sole domain of six-figure sports cars, where they often cost as much as an entry level Toyota Corolla. Now, you can get them on a BMW M3 (they're still pricey, at $8,150). Who knows, maybe in the next four a five years, they'll be available on something like a muscle car or hot hatchback. Aluminum has had a similar progression, although it's further along, moving from the realm of Audi and Jaguar luxury sedans to Ford's most important product, the F-150. With the stuff set to arrive in such a big way on the market, we should logically expect an all-aluminum Toyota Camry or Honda Accord soon, right? Um, wrong. Reuters has a great report on what's keeping Asian manufacturers away from aluminum, and it demonstrates yet another stark philosophical difference between automakers in the east and those in the west. Of course, there's a pricing argument at play. But it's more than just the cost of aluminum sheet (shown above) versus steel. Manufacturing an aluminum car requires extensive retooling of existing factories, not to mention new relationships with suppliers and other logistical and financial nightmares. Factor that in with what Reuters calls Asian automaker's preference towards "evolutionary upgrades," and the case for an all-aluminum Accord is a difficult one. Instead, manufacturers in the east are focusing on developing even stronger steel as a means of trimming fat, although analysts question how long that practice can continue. Jeff Wang, the automotive sales director for aluminum supplier Novelis, predicts that we'll see a bump in aluminum usage from Japanese and Korean brands in the next two to three years, and that it will be driven by an influx of aluminum-based vehicles from western automakers into China. Only time will tell if he's proven right. News Source: ReutersImage Credit: Sean Gallup / Getty Images Plants/Manufacturing Honda Hyundai Mazda Nissan Toyota Technology aluminum