1998 Mercury Tracer Immaculate One Owner! 35,000 Original Miles! One Of A Kind! on 2040-cars

Auto blog

Junkyard Gem: 1991 Mercury Capri

Ford has gotten a lot of use out of the Capri name in the United States. First, there was the Lincoln Capri in the 1950s, followed by the Ford Capri Mk1 (which was sold by Mercury dealers in the USA but never actually badged as a Mercury). Then came the 1979-1986 Mercury Capri, built on the very successful Fox Platform and essentially a clone of the Mustang. Finally, in 1991, the Australian Ford Capri came to the United States. Here is an example of this rare car that I spotted in a Northern California self-service yard not long ago. Mechanically speaking, the 1991-1994 Capri was a Mazda 323 under the skin, complete with a member of the same B-series engine family that went into such cars as the Miata and Ford Escort. So, for a few years in the early 1990s, car shoppers who wanted a sporty Mazda convertible could choose between a Miata and a Capri. The Capri had front-wheel-drive, but could be had with factory turbocharging. These cars were reliable and fun, but had a tough time competing with the Miata in the showroom battles. You'll see the occasional example now and then, but most of the 1991-1994 Capris have met the same fate that awaits this one. Related Video:

NHTSA upgrades Ford floor mat unintended acceleration probe

According to a Bloomberg report, the National Highway Traffic Safety Administration has upgraded an investigation into complaints of unintended acceleration lodged against Ford vehicles. The investigation began in June of 2010 when just three complaints had been received and it only concerned the Ford Fusion and Mercury Milan, but this was at a time when the phrase "unintended acceleration" made grown men go pale. With 49 additional complaints received since then, the investigation has been reclassified as an engineering analysis - the last phase before a recall - and it has been expanded to include the Lincoln MKZ, making for a total of "around 480,000" units affected between the three sedans from the 2008 to 2010 model years.
The ostensible cause is that floor mats are trapping the accelerator pedal, but according to a Ford statement at the time, the entrapment is due to owners placing the optional all-weather floor mats, or aftermarket floor mats, on top of the car's standard floor mats. NHTSA has backed up that assessment, pinning the blame on "unsecured or double stacked floor mats."
On the face of it, it would appear that NHTSA has upgraded the status not because of Ford's error, but owner error, and Ford has stated publicly that it is "disappointed" in NHTSA's move. On top of NHTSA still being skittish after that other unintended acceleration debacle, it could be seen to be taking its time investigating all of the variables: it's reported that Ford changed its accelerator pedal design in 2010, a "heel blocker" in the floorpan has been considered a potential culprit in how the floor mats could be trapping the pedal, some drivers have said the floor mats weren't anywhere near the pedal, and according to a report in the LA Times, in "a letter sent by Ford to NHTSA in August 2010, the automaker said it found three injuries and one fatality that 'may have resulted from the alleged defect.'"

NHTSA investigating Ford's solution to May 2014 power steering recall

The National Highway Traffic Safety Administration is investigating a complaint that Ford's response to a May 2014 recall of the 2008 to 2011 Ford Escape and Mercury Mariner doesn't quite go far enough to solve a troubling power-steering problem. Roughly a year ago, Ford recalled nearly a million vehicles after it was found that a problem with the torque sensor's communication with the power steering control module could cut steering assistance for drivers. While manual steering would still be available, the problem was enough to ask drivers to report in to have the PSCM inspected, and if necessary, replaced (along with the torque sensor, or in dramatic cases, the entire steering column). That would only happen, though, if trouble codes were being thrown. If there weren't any problems, dealers were told to simply update the PSCM's software so that any issues between it and the torque sensor would simply throw a visual and audio warning – power steering would still be maintained. The petitioner claimed that following the recall work, he still experienced a problem with the torque sensor. According to NHTSA, a claim was made that Ford didn't go far enough in its solution to the problem, and that "the software update itself may in fact cause further issues with the affected vehicle's power steering, causing it to fail, and ultimately requiring replacement of the torque sensor or entire steering column." The petition was filed in early February and is now officially being looked into by NHTSA.