1954 Mercury Convertible, W/ Continental Kit. Restored. Very Nice Western Car on 2040-cars

Auto blog

Ford recalls 300,000 Crown Vics over lighting module

The Basics: Ford is recalling 312,814 units of the Crown Victoria and Mercury Grand Marquis sedans from the 2003-2005 model years. They were built at the St. Thomas Assembly Plant between Oct. 3, 2001, and Aug. 2, 2005. Ford says 296,004 of those units are located in the United States, with another 14,714 in Canada and 2,096 in Mexico. The Problem: The solder joints on the lighting control module could crack, depriving the headlamps of the power they need to light the way ahead. That could increase the risk of a crash, particularly at night and in other low-visibility situations. Injuries/Deaths: Ford reports that it is aware of 11 accidents that resulted from the problem, leading to one injury described as "minor." The Fix: The manufacturer is instructing dealers to replace the entire lighting control module. If You Own One: Make sure your headlights are working before getting under way. If they're not, avoid driving under low-light conditions, including at night, in heavy precipitation, or in fog. Ford Issues Three Safety Recalls and One Safety Compliance Recall in North America DEARBORN, Mich., Dec. 22, 2015 – Ford Motor Company is issuing three safety recalls and one safety compliance recall in North America. Details are as follows: Ford Motor Company issues safety recall for certain 2003-2005 Ford Crown Victoria and Mercury Grand Marquis vehicles to replace lighting control module Ford Motor Company is issuing a safety recall for approximately 313,000 2003-2005 Ford Crown Victoria and Mercury Grand Marquis vehicles to replace a lighting control module. The solder joints on the module could crack and interrupt power to the headlamps – increasing the risk of crash at night. Ford is aware of 11 reports of accidents and one report of a minor injury related to this issue. Affected vehicles include certain 2003-2005 Ford Crown Victoria and Mercury Grand Marquis vehicles built at St. Thomas Assembly Plant, Oct. 3, 2001 through Aug. 2, 2005. There are a total of 312,814 vehicles that might be affected in North America, including 296,004 in the United States and federalized territories, 14,714 in Canada and 2,096 in Mexico. Dealers will replace the lighting control module at no cost to the customer. Ford issues safety recall for certain 2016 Ford F-650 and F-750 vehicles to replace rear air brake chamber Ford is issuing a safety recall for 177 2016 Ford F-650 and F-750 vehicles to replace the rear air brake chamber.

NHTSA investigating 725k Ford, Mercury vehicles for stalling issue

Owners of Ford Escape, Mercury Mariner, Ford Fusion and Mercury Milan models, listen up. According to a report on Automotive News, the National Highway Traffic Safety Administration has opened an investigation into these four vehicles totaling an estimated 725,000 units. The investigation appears to center around a malfunctioning throttle body on non-hybrid models of the 2005-2012 Escape and 2011-2012 Fusion. With Mercury dying off after the 2011 model year, this probe will also apply to the 2005 through 2011 Mariner and the 2011 Milan. There has been some discussion around the Escape stalling issue for some time now, but this investigation appears to be larger in scope than before.
Though not a recall yet, NHTSA's Office of Defects Investigation (ODI) has received 123 complaints of stalling or surging vehicles, while Ford itself has logged 1,472 complaints. The investigation report, which is posted below, seems to indicate that a faulty circuit board for the throttle body could cause the vehicle to go into limp mode, which, according to NHTSA, could cause complaints of both stalling and surging.

The 1965 Ford Mustang could have looked a lot different

The 1965 Ford Mustang is unquestionably an automotive design icon, and nearly every generation of Mustang has some connection to that original car. Because it's such a universally-known vehicle, we were amazed to see all the different designs that were being considered. Head of Ford's archives Ted Ryan recently shared photos of design proposals for the original Mustang on Twitter that he and Jamie Myler found, and we reached out to them to find out more. As Ryan initially noted, the photos were taken on August 19, 1962, and they are proposals for the Ford Mustang. Apparently Ford had committed to doing a Falcon-based youth-oriented car at this point, and it did have plans to launch the car in 1964 for the 1965 model year. But after having little success with early design proposals, the company asked all of its design studios — the Advanced Studio, Lincoln-Mercury Studio and Ford Studio — to submit proposals. With only about two years before the planned launch, Ford was understandably short on time, and it's believed that the studios only had a month to create and present these designs. Lincoln-Mercury design proposal View 8 Photos The majority of the designs, a total of five, came from the Advanced Studio, and part of this was because they already had a couple of concept designs in reserve it could present. Two other models representing three design possibilities came from Lincoln-Mercury, and just one model with two options came from Ford. The Advanced Studio proposals are shown in the gallery at the very top of this article, and the Lincoln-Mercury and Ford proposals are in the gallery directly above this paragraph. The Advanced Studio's most radical design is the one that was clearly related to the Mustang I concept that would be shown later that year with huge wraparound rear glass, turbine-inspired bumpers and enormous side scoops. The other proposals from the studio were more conservative, featuring simple lines, grilles reminiscent of the Falcon, and one even borrowing the jet-thruster-style taillights made famous on the Thunderbird. Lincoln-Mercury had some impressively bold designs, particularly its fastback that had buttresses to extend the shape all the way to the tail. This car had two different side trim possibilities. The other Lincoln-Mercury design was toned down a bit, but had two interesting possibilities for side detailing, as well as some crisp, low-profile tail fins.