Leather Alloy Wheels Power Windows Door Locks Mirrors Woodgrain Dash Cruise Conl on 2040-cars

Auto blog

Curtain officially comes down on Mercury as dealers remove signage

The process of shutting down the Mercury is complete. Ford officially made the decision to close its mid-level brand in June of 2010. In the months that followed, Ford offered its dealers money to stop selling the cars, with production shutting down in September. The last Mercury, a Mariner, rolled off the assembly line in the beginning of October and former spokesperson Jill Wagner said her good-byes to both the car and her job. Now the last piece of the brand has come down as dealers are removing any and all Mercury signage from their lots.
[Source: Detroit News]Read | Permalink | Email this | Comments

NHTSA will investigate some Ford Fusion, Lincoln MKZ models for power steering issue

The National Highway Traffic Safety Administration is opening an investigation into the 2010-2012 Ford Fusion, Fusion Hybrid and Lincoln MKZ, the 2012 MKZ Hybrid and 2011 Mercury Milan because the agency has hundreds of complaints of electric power steering failure in these models.
According to NHTSA's data, it has received 508 complaints of the power steering allegedly suddenly malfunctioning and resulting in increased effort to turn the wheel. In four incidents, these failures resulted in loss of control and crashes. According to the reports, in some cases a power steering warning message came on as the fault occurred, and other times the system restored itself by turning off and then restarting the vehicle. NHTSA said it has also received further field report data from Ford, but that information hasn't been publicly released yet.
For the moment, there isn't a recall for this failure on these models. NHTSA is just investigating them to "assess the scope, frequency and safety consequences of the alleged defect," and the agency says an estimated 938,000 vehicles could potentially be affected.

Ford finds flex-fuel engine design plays big role in emissions output

How bad is ethanol for your engine? There's been a lot of debate on this issue as the US considers upping the biofuel content in the national gasoline supply from 10 percent (E10) to 15 percent (E15). The ethanol industry and some scientists say higher ethanol blends show no "meaningful differences" in new engines while the oil industry says ethanol creates health risks. Researchers working at the Ford Research and Innovation Center decided to take a closer look at how a wide range of gas-ethanol blends - E0, E10, E20, E30, E40, E55 and E80 - affected the emissions coming out of a flex-fuel 2006 Mercury Grand Marquis. To see the full report, printed in the journal Environmental Science & Technology, requires payment, but there is an abstract and Green Car Congress has some more details. The gist is that, "with increasing ethanol content in the fuel, the tailpipe emissions of ethanol, acetaldehyde, formaldehyde, methane, and ammonia increased." At least NOx and NMHC emissions decreased. The researchers say that the effects are due to the fuel and "are expected for all FFVs," but that the way that a manufacturer calibrates the engine will affect NOx, THC, and NMOG emissions. It's this last bit that's important, since the researchers found, "Higher ethanol content in gasoline affects several fundamental fuel properties that can impact emissions. ... These changes can have positive or negative effects that can depend on engine design, hardware, and control strategy. In addition to direct emissions impacts, higher ethanol content fuel can also provide more efficient combustion and overall engine operation under part-load conditions and under knock-limited higher-load conditions." So, as we head towards more ethanol in our fuel supply (maybe), manufacturers are going to need to learn how to burn it most efficiently.