1967 Mercury Cougar Dan Gurney Special Marti Report Arizona Car No Reserve on 2040-cars
Palm Desert, California, United States
Mercury Cougar for Sale
2002 mercury cougar 2 dr, hatcback # runs & drive very good! low reserve!!
1970 mercury cougar xr-7 tubbed pro street hot rod(US $9,650.00)
1976 mercury cougar xr7 blue landau 2 door 94,700 mi. clean all original
No reserve!!! bid 2 win 4.6 mercury cougar xr7!! same engine as mustang gt
1969 mercury cougar boss 302 eliminator
1968 mercury cougar xr7 no reserve
Auto Services in California
Z Best Body & Paint ★★★★★
Woodman & Oxnard 76 ★★★★★
Windshield Repair Pro ★★★★★
Wholesale Tube Bending ★★★★★
Whitney Auto Service ★★★★★
Wheel Enhancement ★★★★★
Auto blog
Junkyard Gem: 1996 Nissan Quest XE with 338,549 miles
Sun, Jul 9 2023When I hit the junkyard, I always look for vehicles with impressive final figures showing on their odometers. I find so many Hondas and Toyotas with better than 300,000 miles that I don't consider them especially noteworthy (the exception being super-low-spec cheap models, such as a Tercel or Civic VX), and it goes without saying that the bar is quite high for Mercedes-Benzes as well. It has been surprisingly difficult to find discarded Nissans that made it past the 300k mark; today's Junkyard Gem is just the fourth I've documented. The highest-mile junked Nissan I'd found prior to today's minivan is a 1994 Maxima with 364,238 miles, followed by a 1987 Maxima with 341,176 miles and a 1986 200SX with 309,222 miles. Keep in mind that Nissan didn't go to six-digit odometers on most of its US-market cars until the early 1980s, and then went to tough-to-read-in-the-junkyard electronic odometers in the early 2000s; this means the pool of potential high-mile Nissans is limited to about the 1983-2000 range of model years. Ford has just as much right to claim credit to this van's impressive mile total as does Nissan, since the Quest was a collaboration between Ford and Nissan that also produced the Mercury Villager; this van was built by Ford at the Ohio Assembly plant. The Quest/Villager platform was derived from the Maxima's, and the engine is pure Nissan: a 3.0-liter VG30 V6 rated at 151 horsepower. The only transmission available in the first-generation (1993-1999) Quest/Villager was a four-speed automatic. This one appears to have been sold new at Landrum Nissan in Pueblo. The rear glass has been painted flat black, possibly to keep prying eyes from seeing valuable cargo. The rear seats are long gone, so this van probably hauled cargo for much of its long life. The front interior seems to be in good shape. Why is this van here? There's body damage on the left rear and right front, suggesting a crash that may have bent the suspension past the worth-fixing threshold. Perhaps the crinkled metal just made this van too unsightly, or maybe some powertrain problem was the culprit. This content is hosted by a third party. To view it, please update your privacy preferences. Manage Settings. It's time to expect more from a minivan. This content is hosted by a third party. To view it, please update your privacy preferences. Manage Settings. It's all fun and games until the toddler takes the wheel.
NHTSA upgrades Ford floor mat unintended acceleration probe
Mon, 17 Dec 2012According to a Bloomberg report, the National Highway Traffic Safety Administration has upgraded an investigation into complaints of unintended acceleration lodged against Ford vehicles. The investigation began in June of 2010 when just three complaints had been received and it only concerned the Ford Fusion and Mercury Milan, but this was at a time when the phrase "unintended acceleration" made grown men go pale. With 49 additional complaints received since then, the investigation has been reclassified as an engineering analysis - the last phase before a recall - and it has been expanded to include the Lincoln MKZ, making for a total of "around 480,000" units affected between the three sedans from the 2008 to 2010 model years.
The ostensible cause is that floor mats are trapping the accelerator pedal, but according to a Ford statement at the time, the entrapment is due to owners placing the optional all-weather floor mats, or aftermarket floor mats, on top of the car's standard floor mats. NHTSA has backed up that assessment, pinning the blame on "unsecured or double stacked floor mats."
On the face of it, it would appear that NHTSA has upgraded the status not because of Ford's error, but owner error, and Ford has stated publicly that it is "disappointed" in NHTSA's move. On top of NHTSA still being skittish after that other unintended acceleration debacle, it could be seen to be taking its time investigating all of the variables: it's reported that Ford changed its accelerator pedal design in 2010, a "heel blocker" in the floorpan has been considered a potential culprit in how the floor mats could be trapping the pedal, some drivers have said the floor mats weren't anywhere near the pedal, and according to a report in the LA Times, in "a letter sent by Ford to NHTSA in August 2010, the automaker said it found three injuries and one fatality that 'may have resulted from the alleged defect.'"
NHTSA investigating Ford's solution to May 2014 power steering recall
Tue, Apr 7 2015The National Highway Traffic Safety Administration is investigating a complaint that Ford's response to a May 2014 recall of the 2008 to 2011 Ford Escape and Mercury Mariner doesn't quite go far enough to solve a troubling power-steering problem. Roughly a year ago, Ford recalled nearly a million vehicles after it was found that a problem with the torque sensor's communication with the power steering control module could cut steering assistance for drivers. While manual steering would still be available, the problem was enough to ask drivers to report in to have the PSCM inspected, and if necessary, replaced (along with the torque sensor, or in dramatic cases, the entire steering column). That would only happen, though, if trouble codes were being thrown. If there weren't any problems, dealers were told to simply update the PSCM's software so that any issues between it and the torque sensor would simply throw a visual and audio warning – power steering would still be maintained. The petitioner claimed that following the recall work, he still experienced a problem with the torque sensor. According to NHTSA, a claim was made that Ford didn't go far enough in its solution to the problem, and that "the software update itself may in fact cause further issues with the affected vehicle's power steering, causing it to fail, and ultimately requiring replacement of the torque sensor or entire steering column." The petition was filed in early February and is now officially being looked into by NHTSA.