1967 Mercury Cougar on 2040-cars

Auto blog

Junkyard Gem: 1991 Mercury Grand Marquis LS

Ford's now-defunct Mercury Division first began using the Marquis name in 1967, on a sporty full-size hardtop based on the Ford LTD, then began offering the Grand Marquis beginning in the 1979 model year. These big, boxy luxury sedans were replaced by big, curvy luxury sedans (on the same platform) starting with the 1992 model year, so today's Junkyard Gem is one of the very last squared-off Grand Marquises ever built. The 1991 Grand Marquis (or "Grandma Keith," as many refer to it today) looks nearly identical to its 1979 predecessor at a glance, just as the 2011 model doesn't differ much from the 1992 model. Ford saw no reason to follow short-lived fashion trends with its simple, sturdy rear-wheel-drive sedan. Only two Grand Marquis trim levels were available for 1991: the base GS and the (somewhat) upscale LS. The former listed at $18,741 and the latter at $19,241, which comes to about $41,494 and $42,601, respectively, in inflated 2022 dollars). This interior would have seemed comfortingly familiar to a 1968 (or even 1958) Mercury owner time-traveling to 1991.  This is the optional "full grain leather seating surface," which cost an extra $489 (about $1,083 today). Dig those opera lights! Air conditioning was standard equipment in the 1991 Grand Marquis and its wagon counterpart, the Colony Park. The engine is the good old pushrod 5.0-liter Windsor V8, which would be replaced by a far more modern 4.6-liter SOHC mill in the '92 Grand Marquis. This engine was rated at 180 horsepower. A four-speed automatic was the only transmission available. The early 1990s ended up being the last gasp for padded vinyl roofs being considered mainstream equipment on new Detroit cars; this one was called the "Formal Coach" roof and cost an additional 725 bucks ($1,605 now). Such roofs were still available on a few cars later in the decade, but their time had passed. Why would such a clean Grandma Keith end up in a place like this? That's easy: it got T-boned directly into the right front wheel, mangling the body and bending up the suspension. This damage might have been worth fixing when the car was five years old, but it's a write-off when it happens to a 31-year-old Ford Panther. 1991 Mercury Grand Marquis Commercial - Savings Ad The granddaddy of them all, and on sale in South Texas! Related video: 2008 Mercury Mariner Hybrid test drive Autoblog

NHTSA investigating 725k Ford, Mercury vehicles for stalling issue

Owners of Ford Escape, Mercury Mariner, Ford Fusion and Mercury Milan models, listen up. According to a report on Automotive News, the National Highway Traffic Safety Administration has opened an investigation into these four vehicles totaling an estimated 725,000 units. The investigation appears to center around a malfunctioning throttle body on non-hybrid models of the 2005-2012 Escape and 2011-2012 Fusion. With Mercury dying off after the 2011 model year, this probe will also apply to the 2005 through 2011 Mariner and the 2011 Milan. There has been some discussion around the Escape stalling issue for some time now, but this investigation appears to be larger in scope than before.
Though not a recall yet, NHTSA's Office of Defects Investigation (ODI) has received 123 complaints of stalling or surging vehicles, while Ford itself has logged 1,472 complaints. The investigation report, which is posted below, seems to indicate that a faulty circuit board for the throttle body could cause the vehicle to go into limp mode, which, according to NHTSA, could cause complaints of both stalling and surging.

Ringbrothers shows off Coyote-powered 1968 Mercury Cougar

We'll openly admit that not every SEMA build is our cup of tea. But this? A tastefully resto-modded 1968 Mercury Cougar with a 460-horsepower Ford Mustang V8? Yeah, this is right in our wheelhouse. Sadly, there was no in-pwerson SEMA show in 2020, so we missed out on gems like this one. SEMA or no SEMA, the aftermarket carries on, and co-owners Jim and Mike Ring of Ringbrothers (get it?) saw no reason to let their time and effort go to waste.  When they're not building wild customs (see: 1,100-horsepower 1972 AMC Javelin AMX) or more subtle showcases (such as this Cougar or their 1971 K5 Chevy Blazer build from 2018), the folks at Ringbrothers crank out factory reproduction parts, whether for old-fashioned restoration or modification purposes. While '60s muscle cars are recurring build subjects for the two, the Cougar was the first of its kind they tackled.  Keeping it in the family, Ringbrothers sourced a Ford 5.0-liter "Coyote" V8 and a 10-Speed Automatic (lifted from an F-150 Raptor, incidentally) for the build. They didn't stop with the driveline, of course. The suspension was overhauled with a little help from DSE and a set of HRE Series C1 C103 Forged 3-Piece wheels were thrown over upgraded brakes.  "We put our heart into each car we build, and this Cougar is no exception," Jim said. "The finished product is mild and classy, yet any enthusiast instantly knows it's not stock. I imagine this is what Mercury designers would have come up with if they were building the Cougar today." "While we couldn't bring the car to the SEMA Show, we hope it can be shown to the public soon," Mike said. "We had never done a Cougar before, so this was a fun build. I love working with new shapes and coming up with new ideas." There's plenty to appreciate about this Cougar apart from the mechanicals, too. The finish is Augusta Green Metallic (courtesy of BASF), which was a factory color in 1968. You may know it by another name: Highland Green. There are a few custom exterior touches, but they're quite subtle and styled to be period-correct. The interior was also restored and updated, and it's where you'll find the only thing we're not fond of: that big, fat truck shifter. Gearbox choices notwithstanding, it's a bit of an eyesore. But considering how gorgeous the rest is, we'll give it a pass.  Related Video: