4dr Sdn Ls P 3.0l Warranty Power Windows Power Door Locks Tilt Wheel Tachometer on 2040-cars

Auto blog

Ford recalls 382k vehicles across six campaigns

Ford needs to repair a total of 381,633 vehicles in North America across six newly announced campaigns, including five safety recalls and one compliance recall. By far the largest of these campaigns covers the 342,271 examples of the 1998-2003 Windstar to double check an earlier recall repair. Among these, 283,413 are in the US and 58,858 are in Canada. The combination of corrosion and stress can cause cracks in the rear axle and eventually lead to the part to snap completely. The company reports a small number of accidents might be connected to this, but there are no injuries. The minivans were recalled for this issue back in 2010, and it was investigated by NHTSA. According to Ford's latest announcement, the reinforcement brackets on some of these models might not have been installed correctly. This time, dealers will perform an inspection. Minivans with incorrectly installed brackets will get a new rear axle. The rest of the owners will be offered a deal to replace the part at a reduced cost. The next largest campaign covers 36,857 examples of the 2015 F-150 to fix a problem with the adaptive cruise control. Specifically, there are 33,481 affected trucks in the US, and 3,376 in Canada. According to Ford, "when passing a large, highly reflective truck" the radar in the system can misidentify a semi as being in the same lane as the pickup. The collision warning system would then activate, slowing the F-150. There's one report of an accident with this happening but no injuries. The fix is simply an update to the adaptive cruise control module software. Ford also has a recall for 1,477 examples of its 2016 F-53 and F-59 stripped chassis models, and they're all located in the US. A manufacturing issue might allow the trucks to shift into reverse without the driver first applying the brakes. There are no reports of any accidents from this, though. To repair the problem, the models get a new transmission shift control bracket and an adjustment to the shift cable. The Blue Oval's safety compliance recall covers 708 examples of the 2016 Fusion and Lincoln MKZ, including 658 of them in the US, 28 in Canada, and 22 in Mexico. On these models, a manufacturing problem with the fuel tank could allow it to crack in a crash, which isn't allowed under federal rules. There are no reports of accidents, injuries or fires. The fix will be a new fuel tank for all of them. The company is also repairing 251 units of the 2015 Taurus and Lincoln MKS, plus the 2016 Explorer.

Junkyard Gem: 1981 Mercury Cougar XR-7

The story of the Mercury Cougar involves more plot twists and unexpected digressions than that of just about any other Detroit car, with successive Cougar generations based on the Ford Mustang (1967-1973), the Ford Torino and/or Thunderbird (1974-1979), various Fox Fords including the Thunderbird (1980-1988), the MN12 Thunderbird/Lincoln Mark VIII (1989-1997), and the Ford Mondeo (1999-2002). There were wagon and sedan Cougars for brief periods, just to confuse everybody, and the rakish XR-7 Cougars sometimes lived on different platforms from their ordinary non-XR-7 counterparts. I think the Late Malaise Era Fox XR-7s are among the most interesting of the bunch, so I was quite excited to spot this tan-over-gold '81 in a Denver yard. I tried to count the number of screaming-cat badges on and in this car and gave up once I hit a dozen. The steering wheel, door panels, C pillars, center console, and — of course — the hood ornament all boast snarling felines. Earlier Cougars had emblems showing full side views of stalking catamounts, but the Cougar logo for the 1980s showed just the head. This car got the optional center console, which I hear is quite a rarity. You had to pay $174 extra (that's around $513 in 2020 dollars) for an AM/FM/cassette audio system in the '81 Cougar, but at least the air conditioning was standard equipment. Believe it or not, thieves used to steal these radios. Kumpf Lincoln-Mercury still exists in Englewood (as Landmark Lincoln), and the yard that now houses this car can be found just 15 miles up Broadway on the north side of Denver.  The padded landau roof hasn't fared so well beneath the fierce Colorado sun, but overall this car seems very solid. Sadly, only the Mustangs and (once in a long while) Fairmonts get much love from the Fox Ford crowd these days. Three Mercury "wire wheel" hubcaps and one from a Lincoln. The base engine in the 1981 XR-7 was the "Thriftmaster" 200-cubic-inch (3.3-liter) straight-six, but very few XR-7 buyers would have refrained from checking the box for one of the two optional Windsor V8s. I can't tell if we're looking at the 255-cubic-inch (4.2-liter) version or the 302-cubic-inch (5.0-liter) one here, but real-world drivers might not have noticed the difference between the 120-horse 255 and the 130-horse 302, anyway. The non-XR-7 Fox Cougars had five-speed manual transmissions as base equipment (which nobody wanted), but all 1981 XR-7s had automatics.

Ringbrothers shows off Coyote-powered 1968 Mercury Cougar

We'll openly admit that not every SEMA build is our cup of tea. But this? A tastefully resto-modded 1968 Mercury Cougar with a 460-horsepower Ford Mustang V8? Yeah, this is right in our wheelhouse. Sadly, there was no in-pwerson SEMA show in 2020, so we missed out on gems like this one. SEMA or no SEMA, the aftermarket carries on, and co-owners Jim and Mike Ring of Ringbrothers (get it?) saw no reason to let their time and effort go to waste.  When they're not building wild customs (see: 1,100-horsepower 1972 AMC Javelin AMX) or more subtle showcases (such as this Cougar or their 1971 K5 Chevy Blazer build from 2018), the folks at Ringbrothers crank out factory reproduction parts, whether for old-fashioned restoration or modification purposes. While '60s muscle cars are recurring build subjects for the two, the Cougar was the first of its kind they tackled.  Keeping it in the family, Ringbrothers sourced a Ford 5.0-liter "Coyote" V8 and a 10-Speed Automatic (lifted from an F-150 Raptor, incidentally) for the build. They didn't stop with the driveline, of course. The suspension was overhauled with a little help from DSE and a set of HRE Series C1 C103 Forged 3-Piece wheels were thrown over upgraded brakes.  "We put our heart into each car we build, and this Cougar is no exception," Jim said. "The finished product is mild and classy, yet any enthusiast instantly knows it's not stock. I imagine this is what Mercury designers would have come up with if they were building the Cougar today." "While we couldn't bring the car to the SEMA Show, we hope it can be shown to the public soon," Mike said. "We had never done a Cougar before, so this was a fun build. I love working with new shapes and coming up with new ideas." There's plenty to appreciate about this Cougar apart from the mechanicals, too. The finish is Augusta Green Metallic (courtesy of BASF), which was a factory color in 1968. You may know it by another name: Highland Green. There are a few custom exterior touches, but they're quite subtle and styled to be period-correct. The interior was also restored and updated, and it's where you'll find the only thing we're not fond of: that big, fat truck shifter. Gearbox choices notwithstanding, it's a bit of an eyesore. But considering how gorgeous the rest is, we'll give it a pass.  Related Video: