2007 Mercury Mountaineer Premier Sport Utility 4-door 4.6l on 2040-cars

Auto blog

Curtain officially comes down on Mercury as dealers remove signage

The process of shutting down the Mercury is complete. Ford officially made the decision to close its mid-level brand in June of 2010. In the months that followed, Ford offered its dealers money to stop selling the cars, with production shutting down in September. The last Mercury, a Mariner, rolled off the assembly line in the beginning of October and former spokesperson Jill Wagner said her good-byes to both the car and her job. Now the last piece of the brand has come down as dealers are removing any and all Mercury signage from their lots.
[Source: Detroit News]Read | Permalink | Email this | Comments

NHTSA probing 2000-2003 Ford Taurus and Mercury Sable models over throttle issue

A potential issue with the speed control cable collar has got the 2003-20003 Ford Taurus and Mercury Sable under the spotlight of the National Highway Traffic Safety Administration. If the collar breaks it can cause the throttle to be stuck open.
The issue is limited to vehicles with the 3.0-liter V6 Duratec. There are just 50 complaints so far out of 310,000 cars, but the NHTSA has begun an investigation into whether a recall should be issued.

NHTSA investigating Ford's solution to May 2014 power steering recall

The National Highway Traffic Safety Administration is investigating a complaint that Ford's response to a May 2014 recall of the 2008 to 2011 Ford Escape and Mercury Mariner doesn't quite go far enough to solve a troubling power-steering problem. Roughly a year ago, Ford recalled nearly a million vehicles after it was found that a problem with the torque sensor's communication with the power steering control module could cut steering assistance for drivers. While manual steering would still be available, the problem was enough to ask drivers to report in to have the PSCM inspected, and if necessary, replaced (along with the torque sensor, or in dramatic cases, the entire steering column). That would only happen, though, if trouble codes were being thrown. If there weren't any problems, dealers were told to simply update the PSCM's software so that any issues between it and the torque sensor would simply throw a visual and audio warning – power steering would still be maintained. The petitioner claimed that following the recall work, he still experienced a problem with the torque sensor. According to NHTSA, a claim was made that Ford didn't go far enough in its solution to the problem, and that "the software update itself may in fact cause further issues with the affected vehicle's power steering, causing it to fail, and ultimately requiring replacement of the torque sensor or entire steering column." The petition was filed in early February and is now officially being looked into by NHTSA.