2006 Mercury Montego Premier on 2040-cars

Auto blog

NHTSA investigating 500k Ford and Mercury cars for lighting failures

The Ford Crown Victoria and Mercury Grand Marquis might be long gone as new models in showrooms, but the National Highway Traffic Safety Administration might check them out yet again for a potential problem. At the urging of North Carolina Consumers Council, the agency may open another investigation into the front lighting control module on vehicles from the 2003-2005 model years, and NHTSA estimates the issue could affect 517,945 vehicles. If the module stops working, it can cause a complete failure of all forward lighting, including the headlights. NHTSA previously investigated the issue in 2008 and 2009 but found no need for a recall, according to Bloomberg. Ford also extended the warranty on the part to 15 years or 250,000 miles. To prompt this new request, the North Carolina Consumers Council received a letter from a woman experiencing the module's failure. Upon further investigation, the council found 604 complaints of this problem on NHTSA's website, including seven crashes. Furthermore, the group has alleged that dealers told customers that the parts to perform the replacement weren't available, despite the extended warranty. According to the government agency, "A defect petition has been opened to evaluate the issue and make a grant or deny decision." Ford spokesperson Kelli Felker tells Autoblog via email, "We will cooperate with NHTSA, as we always do." You can read the council's complete letter to the Feds in PDF format, here. INVESTIGATION Subject : Loss of headlamp/exterior lighting Date Investigation Opened: APR 01, 2015 Date Investigation Closed: Open NHTSA Action Number: DP15002 Component(s): EXTERIOR LIGHTING All Products Associated with this Investigation Vehicle Make Model Model Year(s) FORD CROWN VICTORIA 2003-2005 MERCURY GRAND MARQUIS 2003-2005 Details Manufacturer: Ford Motor Company SUMMARY: The Office of Defects Investigation (ODI) has received a petition from the North Carolina Consumers Council, Inc. requesting a defect investigation of an alleged defect condition resulting in headlight and/or exterior lighting failure on 2003-2005 Ford Crown Victoria and Mercury Grand Marquis vehicles. The petition letter is attached for review. The petitioner alleges a defect in the lighting control module that powers the headlights which can result in the loss of vehicle headlights and/or all exterior lighting while driving. ODI has previously investigated this issue under PE08-066 which was closed without a defect finding.

Junkyard Gem: 1972 Mercury Cougar XR-7

Starting with the 1939 model year and continuing through 2011, the rule in Dearborn was that most Ford models would get a dressed-up sibling wearing Mercury badges (and Canadians even got Mercury F-100s and Econolines). When the Mustang first hit showrooms in 1964, the countdown for a Mercurized version began. That car, the Cougar, debuted as a 1967 model marketed as "the man's car." Today's Junkyard Gem is a much-abused example of the early-1970s Cougar, found in a San Francisco Bay Area car graveyard a while back. Just as the Mustang packed on weight and price as the 1960s became the 1970s, the even more heavily gingerbreaded Cougar did the same. For 1971 through 1973, the Cougar was still based on the Mustang chassis but weighed several hundred additional pounds and was more than seven inches longer. The curb weight for this car was 3,298 pounds, versus 2,941 pounds for the lightest '72 Mustang coupe. Yes, there's a Mustang underneath all that chrome! When the Mustang went to a modified Pinto chassis starting in the 1974 model year, the Cougar moved over to the midsize Torino platform and stayed there until it rejoined the Mustang on the Fox platform for 1980 (though the honor of being the Mustang's near-twin went to the Mercury Capri at that point). For 1989, the Cougar became an MN12 Thunderbird sibling, where it remained through its 30th anniversary … and then the Cougar got the axe. The Cougar story wasn't done at that point, however, because the name got revived in 1999 with a Mondeo-based version that lasted through 2002 and bears the distinction of being one of the few Mercury models with no corresponding Ford-badged counterpart. Along the way, there were Cougar sedans and even station wagons, with the curb weight of the heaviest-ever Cougar bloating to well over two tons (the winner of that honor is the 1977 Cougar Villager wagon, scaling in at an astounding 4,482 pounds). In 1972, though, all new Cougars were coupes or convertibles, and all of them came with factory V8 power. The build tag on this one tells us that it was assembled at the River Rouge compound in Dearborn and sold via the Kansas City sales office. That tells us that someone drove this car to California after buying it in the Midwest; Ford also built 1972 Cougars in San Jose, so California Mercury shoppers would have bought locally-produced ones. It's a top-end XR-7 in Medium Bright Yellow paint, with the interior in Medium Ginger.

Ringbrothers shows off Coyote-powered 1968 Mercury Cougar

We'll openly admit that not every SEMA build is our cup of tea. But this? A tastefully resto-modded 1968 Mercury Cougar with a 460-horsepower Ford Mustang V8? Yeah, this is right in our wheelhouse. Sadly, there was no in-pwerson SEMA show in 2020, so we missed out on gems like this one. SEMA or no SEMA, the aftermarket carries on, and co-owners Jim and Mike Ring of Ringbrothers (get it?) saw no reason to let their time and effort go to waste.  When they're not building wild customs (see: 1,100-horsepower 1972 AMC Javelin AMX) or more subtle showcases (such as this Cougar or their 1971 K5 Chevy Blazer build from 2018), the folks at Ringbrothers crank out factory reproduction parts, whether for old-fashioned restoration or modification purposes. While '60s muscle cars are recurring build subjects for the two, the Cougar was the first of its kind they tackled.  Keeping it in the family, Ringbrothers sourced a Ford 5.0-liter "Coyote" V8 and a 10-Speed Automatic (lifted from an F-150 Raptor, incidentally) for the build. They didn't stop with the driveline, of course. The suspension was overhauled with a little help from DSE and a set of HRE Series C1 C103 Forged 3-Piece wheels were thrown over upgraded brakes.  "We put our heart into each car we build, and this Cougar is no exception," Jim said. "The finished product is mild and classy, yet any enthusiast instantly knows it's not stock. I imagine this is what Mercury designers would have come up with if they were building the Cougar today." "While we couldn't bring the car to the SEMA Show, we hope it can be shown to the public soon," Mike said. "We had never done a Cougar before, so this was a fun build. I love working with new shapes and coming up with new ideas." There's plenty to appreciate about this Cougar apart from the mechanicals, too. The finish is Augusta Green Metallic (courtesy of BASF), which was a factory color in 1968. You may know it by another name: Highland Green. There are a few custom exterior touches, but they're quite subtle and styled to be period-correct. The interior was also restored and updated, and it's where you'll find the only thing we're not fond of: that big, fat truck shifter. Gearbox choices notwithstanding, it's a bit of an eyesore. But considering how gorgeous the rest is, we'll give it a pass.  Related Video: