1967 Mercury Cougar Base 6.4l on 2040-cars

Auto blog

Report: Last Mercury for retail business built on Sunday

Ford is already well into winding down its Mercury line, and the autoamker has announced that the very last of the soon-to-be dead brand's products built for retail sales was manufactured on Sunday, October 3. The final Mercury Mariner rolled off of the assembly line at the company's Kansas City facility, putting an end to a brand with over 70 years of history behind it.
Even after the Mariner heads off into the automotive sunset, Ford says that it will continue to manufacture a handful of Mercury models for fleet and government service for a while longer, though mum's the word on how long we can expect that practice to continue.
Interestingly enough, according to USA Today, most incentives on Mercury vehicles have all but dried up, even as the brand's August production increased by 120 percent compared to July's figures. Instead of cash on the hood, some areas are offering no-cost maintenance or similar programs. Even so, Mercury has continued to out-sell Lincoln right to the end - besting Ford's luxury arm's sales by nine percent in August.

NHTSA investigating Ford's solution to May 2014 power steering recall

The National Highway Traffic Safety Administration is investigating a complaint that Ford's response to a May 2014 recall of the 2008 to 2011 Ford Escape and Mercury Mariner doesn't quite go far enough to solve a troubling power-steering problem. Roughly a year ago, Ford recalled nearly a million vehicles after it was found that a problem with the torque sensor's communication with the power steering control module could cut steering assistance for drivers. While manual steering would still be available, the problem was enough to ask drivers to report in to have the PSCM inspected, and if necessary, replaced (along with the torque sensor, or in dramatic cases, the entire steering column). That would only happen, though, if trouble codes were being thrown. If there weren't any problems, dealers were told to simply update the PSCM's software so that any issues between it and the torque sensor would simply throw a visual and audio warning – power steering would still be maintained. The petitioner claimed that following the recall work, he still experienced a problem with the torque sensor. According to NHTSA, a claim was made that Ford didn't go far enough in its solution to the problem, and that "the software update itself may in fact cause further issues with the affected vehicle's power steering, causing it to fail, and ultimately requiring replacement of the torque sensor or entire steering column." The petition was filed in early February and is now officially being looked into by NHTSA.

Ford recalling 126,000 Fusions and Milans over wheel separation concern

Ford has announced a recall of certain Ford Fusion and Mercury Milan vehicles after an investigation by the National Highway Traffic Safety Administration. A total of 128,616 2010 and 2011 models equipped with steel wheels may have been manufactured with wheel studs that could crack and split over time. If that happens, the vehicle may experience a wheel separation.
According to The Detroit News, the company is aware of a total of 30 wheel separation incidents, one of which occurred on the front of the vehicle. Even so, no injuries have been reported as a result of the defect.
The problem apparently stems from the fact that the mounting pads on the vehicles' steel wheels may have been faulty from the factory. In addition, the wheel mounting face on rear disc brakes may not have been installed properly. Ford will inspect the rear disc face and replace them as necessary. In addition, the company will replace all of the vehicle's wheel studs free of charge. Head to the NHTSA website for more information, and click past the jump to view the full recall notice.