1965 Mercury Comet Cylone Caliente on 2040-cars
Cape Coral, Florida, United States
a neat old unusual car hard to find REAL Cyclone model. bought from an owner since the 60's and left mostly un touched, has the usual rust issues, but reserved to mostly the rear lower quarters and trunk area. other areas are minor in my opinion! I have a rear section and trunk included that go with the buyer, the trim seems to be in boxes, not sure if all there? the seats and console, and all included with sale. no radio! it has a 289 with headers and an aftermarket 4 barrel. also an excel dual point distributor and coil. I did a compression check on the motor and it was high on all cylinders, 170 lbs +. I got the motor to start and run on a electric fuel pump and gas can. no knocks or noises. it has a ratchet floor shifter that is in neutral and I can not make it move to drive, so I did not move the car under it's own power. will try again if requested. I will have tires that hold air on it for shipping. the car needs total restoration! have clear Florida title. a personal inspection from buyer before sale is accepted. I bought the car with intensions of making a pro street car but it is too complete and original for that, so I have changed my intentions! this is a great find for the purist, and color combo. was unable to down load pictures, not sure why?? email me for pictures and I will also try to post pictures in the future. have several pictures to send you if desired!
|
Mercury Comet for Sale
- 1963 mercury comet custom 2.4l(US $9,500.00)
- Rare 1963-1/2 comet s-22 factory v-8 /at 2-dr hardtop console vintage muscle car(US $15,995.00)
- 1967 mercury comet caliante convertible,rust free,no title,big block project car
- 1964 mercury comet two door hardtop(US $11,000.00)
- 1965 mercury comet caliente
- 1966 mercury cyclone gt
Auto Services in Florida
Zych Certified Auto Repair ★★★★★
Xtreme Automotive Repairs Inc ★★★★★
World Auto Spot Inc ★★★★★
Winter Haven Honda ★★★★★
Wing Motors Inc ★★★★★
Walton`s Auto Repair Inc ★★★★★
Auto blog
Junkyard Gem: 1955 Mercury Montclair Coupe
Wed, Jul 20 2022I find plenty of 1950s Detroit vehicles in the big self-service car graveyards I frequent, but most of them are fairly ordinary sedans that never stood much chance of getting fixed up and put back on the road. Such is not the case with today's Junkyard Gem, which is a top-trim-level, heavily optioned hardtop coupe from one of the most desirable model years of the tailfins-and-chrome postwar era. Nearly every Mercury model ever made was a Ford model with some cosmetic changes applied, and the '55s looked very similar to their mechanically identical Ford brethren. In 1955, the new Mercury came in three trim levels: the entry-level Custom, the medium-zoot Monterey, and the glitzy Montclair. Each was available as a hardtop coupe and four-door sedan, with wagon versions of the Custom and Monterey. The Montclair could be purchased as a convertible or with the wild "Sun Valley" glass roof. The Montclair got its own line of hallucinogenic two-tone interiors, in order to make the daily lives of Europeans feel even more gray and penurious (the UK only dropped food rationing in 1954, and the two Germanies were still clearing the rubble of their blown-up cities). This car's upholstery has been bleached by decades of sitting outside in the harsh High Plains climate, but it started out as vivid red and white "Chromatex" fabric. The list price on this car was $2,631, or about $29,200 in 2022 dollars. The Sun Valley and convertible Montclair each cost $2,712 ($30,100 today). Ford didn't offer a corresponding hardtop coupe in 1955, though the Fairlane Crown Victoria two-door did look extremely snazzy (and cost a mere $2,302— $25,545 now— with the same V8 engine as the Monterey). Meanwhile, Oldsmobile offered the handsome 88 Super Holiday Coupe for $2,714, though the Montclair had the more powerful engine. Oldsmobile had been selling new cars with overhead-valve V8s since the 1949 model year, while Ford didn't ditch the Model A-era flathead V8 for new U.S.-market cars until the 1954 model year (you could buy a new Simca Esplanada in Brazil with an Ardun-headed Ford V8-60 all the way until 1969). GM's Chevrolet Division got all the press in 1955 with the introduction of the brand-new small-block V8 engine, but Ford's 292-cubic-inch (4.8-liter) Y-Block V8 made more power than the 265-cube (4.3-liter) Chevy and the 324ci Olds Rocket 88.
Feds open investigation into Chevy Express, Ford Freestar rust issues
Wed, 28 Dec 2011'Tis the season... for road salt. And with that, comes rust. And what does rust bring? Well, for Ford and General Motors, a National Highway Traffic Safety Administration investigation. According to The Detroit News, NHTSA is looking into potential recalls issues with Chevrolet Express vans and Ford Freestar minivans.
The feds have received five complaints that rust has caused leaking fuel filler pipes on 2003 Express vans. Separately, seven complaints have been filed over excessive rust in the rear wheel wells of 2004 Ford Freestar and Mercury Monterey minivans. The Freestar and Monterey went out of production in 2007. Neither issue has resulted in any crashes or injuries, according to the report.
NHTSA investigating Ford's solution to May 2014 power steering recall
Tue, Apr 7 2015The National Highway Traffic Safety Administration is investigating a complaint that Ford's response to a May 2014 recall of the 2008 to 2011 Ford Escape and Mercury Mariner doesn't quite go far enough to solve a troubling power-steering problem. Roughly a year ago, Ford recalled nearly a million vehicles after it was found that a problem with the torque sensor's communication with the power steering control module could cut steering assistance for drivers. While manual steering would still be available, the problem was enough to ask drivers to report in to have the PSCM inspected, and if necessary, replaced (along with the torque sensor, or in dramatic cases, the entire steering column). That would only happen, though, if trouble codes were being thrown. If there weren't any problems, dealers were told to simply update the PSCM's software so that any issues between it and the torque sensor would simply throw a visual and audio warning – power steering would still be maintained. The petitioner claimed that following the recall work, he still experienced a problem with the torque sensor. According to NHTSA, a claim was made that Ford didn't go far enough in its solution to the problem, and that "the software update itself may in fact cause further issues with the affected vehicle's power steering, causing it to fail, and ultimately requiring replacement of the torque sensor or entire steering column." The petition was filed in early February and is now officially being looked into by NHTSA.