1990 Mazda Miata With Hard Top on 2040-cars

Auto blog

Mazda spiders return, 42k Mazda6 sedans recalled for webby fuel tanks

It seems that Yellow Sac spiders really, really love Mazda. Three years after Mazda recalled 52,000 Mazda6 sedans over spider webs obstructing the evaporative canister vent lines of 2009 and 2010 Mazda6 models, another recall has been issued for 42,000 more of the models built between 2010 and 2012 and equipped with the 2.5-liter four-cylinder engine.
According to the automaker, there have been nine confirmed sightings of spiders in vent lines since the original recall. It seems that covers were applied at the factory to keep the arachnids from entering, but it hasn't quite exterminated the problem. A reflash of the ECU is required that "[changes] the logic behind how the car purges the charcoal canister during normal operation," says Jeremy Barnes, Director, Public Relations & Brand Experience at Mazda North American Operations.
So far, Mazda has not recorded any fires, accidents or injuries due to this tangled mess of webs. Recall notices will be mailed out to owners later this month. Scroll down below for the statement from Mazda, along with the official recall notice from the National Highway Traffic Safety Administration.

Mazda halts Mazda3 sales for fuel tank problem

Mazda is issuing a stop sale and recall on 14,406 examples of the 2015-2016 Mazda3 in the US with build dates between May 21, 2015, and August 24, 2015, due to a possible fuel leak. There are no reports or accidents or injuries from this problem. According to the company, a defective fuel shut-off valve can allow gasoline to move from the tank and fill the charcoal emissions canister. If it gets too full, there can be a leak, which obviously carries the risk of a possible fire. The engine might stall, as well. Affected owners will be notified to bring their Mazda3 in "as soon as possible." Dealers will inspect the vehicles, and if a problem is found, the fuel tank and charcoal emissions canister will be replaced. During the downtime, customers will get a free rental or loaner car, as well. Those who are particularly concerned can also call Mazda roadside assistance to have their vehicle delivered for the check and possible repair. Related Video: Mazda Issues Stop Sale and Stop Delivery for Mazda3 Fuel Tank Recall WASHINGTON, DC (October 2, 2015) – Mazda Motor Corporation will conduct a Safety and Emission Recall Campaign for certain 2015-2016 Mazda3 vehicles (built from May 21, 2015 through August 24, 2015), which could have a safety-related problem. A defect in the fuel shut-off valve may allow fuel to flow from the fuel tank into the charcoal emissions canister. With this condition, the check engine light may illuminate, and if the fuel exceeds the canister capacity, fuel leakage could occur, increasing the risk of a fire and/or engine stalling. Approximately 14,270 vehicles in the U.S. and 136 vehicles in Puerto Rico are affected. Owners of subject vehicles will be notified by mail in early October. They will be informed to bring their vehicle to the nearest Mazda dealer as soon as possible. Dealers will inspect the fuel tank to determine if the defect exists on the vehicle. If the defect exists, the dealer will replace the fuel tank and charcoal canister at no cost to the customer. A rental or loaner vehicle will be provided at no cost to the owner, until the vehicle is repaired for this concern. If there are no concerns, the vehicle will be returned to the customer. Should a customer not want to drive the vehicle to the dealership, they may contact Mazda's 24-hour Roadside Assistance service at 800-866-1998 and have the vehicle picked up and delivered to the dealership. There have been no reports of accidents or injury related to this issue.

Mazda 16X rotary engine two years away, will arrive in all-new model

We last reported on Mazda's next-generation rotary engine project in June of 2012 when the automaker built its last Renesis-powered RX-8, but rumors of this new engine's development had been around way before that final car left the production line in Japan, last year.
We now have enthusiastic confirmation that this next-gen rotary engine is really and truly going forward. It is still referred to as 16X and has several priorities. First is to lower fuel consumption compared to the RX-8's engine, while still making gains in terms of performance. The second is to reduce the burning of oil that was happening at the highest revs. And the third and final priority, and perhaps most key for enthusiasts, is to give the powertrain a big torque upgrade.
What we were told by a Mazda USA insider (while we are all here together at the festivities in Monterey) is that the first application of the new 16X engine will be happening in two years' time in an as yet undisclosed new model. Oh, the mind races to our eternal Mazda wish list...