Damaged Mazda Rx8 (clean Title) on 2040-cars

Auto blog

Mazda3 Skyactiv-Hybrid and CNG Concept shown in Japan

Mazda has received a tremendous amount of public and industry praise in the last few years, following up the successful introduction of its Skyactiv technology (powertrain and otherwise), with strong products like CX-5, Mazda6 and most recently, the Mazda3. At the Tokyo Motor Show, Mazda has taken yet another step forward with Skyactiv and the 3, showing the compact (called "Axela" in Japan) with an all-new compressed natural gas engine in the Skyactiv-CNG Concept.
The end result of the Skyactiv-Hybrid is fuel consumption estimated at something like 74 miles per gallon.
Mazda thinks that CNG-powered vehicles are due for an uptick in demand, and the company believes this new powertrain will add valuable breadth to the Mazda3 range. The CNG Concept is actually a duel-fuel vehicle, capable of running on either natural gas or gasoline. In fact, we're told that the high compression ratio (14:1) inherent in Skyactiv-technology gasoline engines makes conversion to CNG particularly simple.

Mazda G-Vectoring Control makes driving better without you knowing

Mazda has just spent eight years developing a new technology that will make its new cars a lot more fun to drive, even if you have absolutely no idea that it's working. And subtlety's the point, Mazda engineers told us at a press event at Mazda Raceway Laguna Seca. In fact, the effects of what they've dubbed G-Vectoring Control are so fine that the marketing and PR teams are at a loss for how to do their jobs with it. "The engineers have done their work," said Mazda Director of Communications Jeremy Barnes, "But how do we get the message across?" The basic premise is this: G-Vectoring activates only when the car's on-board computer reads simultaneous steering and throttle input. The data — including throttle position, steering angle, and, crucially, how quickly you're adjusting the steering angle — are then funneled through an algorithm to reduce engine torque, which transfers vehicle weight, adding more grip to the wheels that need it. The system will appear first on 2017 Mazda6 sedans arriving in showrooms later this year, followed by the 2017 Mazda3. Actually, "subtle" does not even begin to describe the effect. G-Vectoring Control can detect as much as one tenth of one degree of steering angle, and changes the cornering forces only 0.1 to 0.5 g as a result. "That's less than the human body can feel," explained Vehicle Development Engineer Dave Coleman. In practice, G-Vectoring reduces the steering angle at turn-in, as well as the rate at which one turns the wheel. To demonstrate, Director of R&D Kelvin Hiraishi rode shotgun with us in a specially equipped Mazda6 that allowed him to turn G-Vectoring on or off at the push of a button (production cars will always have it on). Hiraishi had us drive a number of courses, including Mazda Raceway Laguna Seca itself, while an engineer measured our steering inputs with a laptop Matrix'd into the car's electronic brain. I drove the same course several times with the same car in the same conditions, with cruise control locked and the system turned on or off. Lo and behold, with G-Vectoring activated, the engineer's output graph showed that my steering inputs were indeed reduced ever so slightly. There were two times that G-Vectoring was markedly noticeable. The first on a turn with a minor banking toward the outside, and the second was during cornering over an artificially wet section of the course — in other words, when the car was at the limits of adhesion.

This is what a 1,200-hp twin-turbo 4-rotor looks like in a Miata

We've seen the diminutive Mazda MX-5 Miata swallow plenty of big engines, but New Zealand drifting ace "Mad Mike" Whiddett is roaring into where-no-man-has-gone-before territory. Wanting to replace his 515-horsepower "MADBUL" RX-7 and its twin-turbocharged, three-rotor 20B engine, his new ride is an NC-series Miata with four rotors and twin Garrett turbochargers courtesy of Pulse Performance Race Engineering. It is called "RADBUL," and expected power at standard boost is 1,200 hp, but the builders at Pulse Performance think it will get up to 1,500 hp at full boost. And yes, that exhaust exits through the hood. Four-rotor engines are actually popular - builds are detailed on forums like this one from 2007 and this one from 2008, this UK company or this Canadian company will sell you one complete - but they're usually being prepped for an RX-7. Mad Mike's choice of a Miata for this enterprise makes this about as extreme as you can get, short of throwing it into a Mazda R360. You can watch Mad Mike tell the story of the build in the video, and check out the first and second installments about the build on the Red Bull site.