Find or Sell Used Cars, Trucks, and SUVs in USA

1984 Mazda Rx-7 S Coupe 2-door 1.1l on 2040-cars

Year:1984 Mileage:203000
Location:

Ephrata, Pennsylvania, United States

Ephrata, Pennsylvania, United States
Advertising:

I have an 1984 Mazda RX7 THE GOOD: Street ported 12A 5spd. RUNS AND SHIFTS 100%!Holley Red pump, TFIDFIS ignition,GSL rear, Header with full NEW exhaust, New rear caliper, New tires, Enkei 92's black mesh wheels, full new tune up, even has a fresh oil change! Many new parts. 100% RUST FREE!!! VERY CLEAN! THE BAD:The front caliper hangs up on it from sitting and it needs a steering part as it wanders once in awhile. Needs inspection. I ran out of money and my Wife says SELL IT! NOTE: The mileage stopped at 203,482 miles but the motor had to be swapped out or rebuilt somewhere along the way because it runs great with no oil consumption or overheating issues. It must be towed due to the caliper locking up on it.

Auto Services in Pennsylvania

YBJ Auto Sales ★★★★★

New Car Dealers, Used Car Dealers
Address: 715 Walnut St, Bethlehem
Phone: (610) 438-5300

West View Auto Body ★★★★★

Automobile Body Repairing & Painting
Address: 420 Perry Hwy, Mount-Lebanon
Phone: (412) 931-0600

Wengert`s Automotive ★★★★★

Auto Repair & Service, Automobile Diagnostic Service, Automobile Inspection Stations & Services
Address: 5118 Old Route 22, Shartlesville
Phone: (610) 488-6624

University Collision Center ★★★★★

Auto Repair & Service, Automobile Body Repairing & Painting
Address: 1103 S 31st St, Crum-Lynne
Phone: (215) 755-5957

Ultimate Auto Body Inc ★★★★★

Automobile Body Repairing & Painting, Towing
Address: Castle-Shannon
Phone: (412) 481-7110

Stewart Collision Service ★★★★★

Auto Repair & Service, Automobile Body Repairing & Painting, Automobile Parts & Supplies
Address: 73 E Fayette St, Brownfield
Phone: (724) 437-9381

Auto blog

Mazda, Suzuki, Yamaha — more vehicle data fabrication found in Japan

Thu, Aug 9 2018

TOKYO — Mazda, Suzuki and Yamaha improperly tested vehicles for fuel economy and emissions, the Japanese government said on Thursday, revealing fresh cases of compliance failures by manufacturers. The results came to light after the Japanese government had ordered the automakers to check their operations after revelations of improper testing at Subaru and Nissan last year. The conduct of automakers globally has come under intense scrutiny after Germany's Volkswagen AG admitted in 2015 to installing secret software in hundreds of thousands of U.S. diesel cars to cheat exhaust emissions tests, and that as many as 11 million vehicles could have similar software installed worldwide. In the Japanese cases, the carmakers have not broken any laws or prompted massive recalls. But a growing list of improprieties has tarnished the image of the country's manufacturing industry for high-quality products and efficiency. Suzuki, Mazda and Yamaha cleared vehicles for emissions or fuel efficiency even in cases where they were tested under invalid conditions, the ministry said in a statement. The errors related to slight deviations in the speed of the vehicles during testing that should have invalidated the test results. The automakers examined tests they had conducted over different periods of time, and in Suzuki's case they stretched back to 2012. None of the automakers found significant problems with actual emissions and fuel economy performance of the vehicles, which were destined for sale in Japan, and do not plan any recalls. Suzuki, Japan's fourth-largest automaker, said that of 12,819 sample vehicles tested for fuel economy and emissions since June 2012, around 50 percent of them had been inspected improperly. "I deeply apologize and will lead efforts to prevent recurrence," Suzuki Chief Executive Toshihiro Suzuki told a news conference. Mazda said there were irregularities in 4 percent of similar inspections on its cars, or just over 70 vehicles. In Yamaha's case, irregularities were found in 2 percent of inspections, or just a handful of vehicles. Both Mazda and Yamaha apologized. Suzuki and Yamaha shares fell 6 and 5 percent, respectively, and Mazda shares were down 1 percent, underperforming a steady benchmark Nikkei average. In July this year, Nissan admitted it had improperly measured exhaust emissions and fuel economy for 19 vehicle models sold in Japan.

Our Mazda MX-5 Miata has the best engine bay in the business

Wed, Mar 29 2017

One of the things that's really disappointing about modern cars is how they all hide their technology under a proverbial bushel. You pop the hood, and nine times out of 10, you're faced with some amount of black plastic hiding the functional bits. On some cars the plastic covers the bare minimum to have a "presentable" engine. Others have every tank, hose, wire and screw buried under a layer of smooth plastic. Few exemplify this practice better than engine bay of the current Lexus LS 460, seen below. If Lexus was this embarrassed about its engine, maybe it should have simply bolted the hood shut. However, like with weight gain and power creep, our fourth-generation Mazda MX-5 Miata bucks the plastic trend. Lift the aluminum hood of the little roadster, and you travel back in time more than a decade. (See the gallery up top.) Only one bit of decorative plastic is in sight, and it proclaims the car's Skyactiv technology and hides some of the wires leading to the ignition coils. Otherwise, nothing else is obscured. The shock tower braces, manifolds, battery terminals, the whole shebang is all right there for you to see. What's particularly amazing is that it all looks good. Even in some cars that eschew plastic covers, it's no guarantee of an attractive engine bay. We just had a new Honda Civic Sport hatchback (seen immediately above), and while it doesn't sport a plastic engine cover, you can see from the photo that it's not particularly attractive with tubes and cables snaking every which way. But in the Miata, the hoses and wires are kept to a minimum, and the ones that are there are arranged in a way that isn't haphazard or tangled. Then, in the middle, there's the clean, simple aluminum cam cover as the gleaming centerpiece, similar to those of the first- and second-generation cars. As the owner of a '99 Miata, this detail in particular gives me the warm fuzzies. The fully exposed engine bay fits with the Miata's personality. The car is very straightforward, it features just the absolute minimum of style and comfort additions, and is highly accessible. I would say the Miata's engine bay is the window to its soul, if driving it didn't offer a clearer picture. Related Video:

Patent application suggests Mazda rotary return

Mon, Apr 4 2016

A recent patent application by Mazda reveals that the Japanese automaker is still working on the rotary engine. This could in fact be the Skyactiv-R engine found in the RX-Vision concept from the 2015 Tokyo Motor Show. As with anything Wankel-related, nothing is certain until Mazda makes a production commitment. But this filing suggests that serious development is happening in Hiroshima. The 2011 Mazda RX-8 was the last rotary-powered car you could buy in America. Slow sales, poor fuel economy, and tighter emissions standards prevented Mazda from committing to a follow-up. But the fundamental principles of the rotary - compact size and light weight - perfectly fit Mazda's Skyactiv ethos. (For an explanation of how rotaries work, click here.) In this new engine the intake port sits at the bottom of the engine with the exhaust port on top instead of the other way around. That allows for lower mounting, which improves a car's center of gravity. This rotary is also turbocharged. Putting the turbo up high helps ensure it doesn't get in the way of any body or chassis crossmembers. The implication of those claims is that somebody is thinking about how to put this engine in a car. There are other benefits as well. The short path from the exhaust port to the turbo ensures minimal turbo lag. It also allows for a close-mounted catalyst on top of the enigne, which will help emissions. Another innovation in this new engine is a triangle-shaped rotor that covers part of the exhaust port. This allows for different exhaust flow characteristics. The filing claims that that two of the four orientations allow for less airflow resistance in the exhaust port. As in previous Mazda rotaries, there are two spark plugs to manage ignition timing and combustion. But unlike in the 16X concept, Mazda's last public display of such an engine, the new rotary uses port fuel injection. Keep in mind this is only a patent application. A Mazda spokesperson refused to comment on future product, but commented "As we stated at the Tokyo motor show, Mazda is doing all that it can to bring a rotary to the market." In the meantime, keep your RX-7 prayer candles lit and hope for the return of the rotary before the end of the decade. You can bide your time by reading the entire application here. Related Video: Related Gallery Mazda RX-Vision Concept: Tokyo 2015 View 11 Photos News Source: USPTO via autoevolution Rumormill Mazda Performance rotary mazda rx7