1980 Jeep Wagoneer on 2040-cars

Auto blog

Chrysler resolves recall issue with NHTSA, will inspect, upgrade affected Jeeps

Chrysler made big news earlier in the month by refusing a recall request from the National Highway Traffic Safety Administration for the 1993-2004 Jeep Grand Cherokee and 2002-2007 Jeep Liberty. Last week, NHTSA boss David Strickland countered by defending his agency's request for the recall of 2.7 million Jeep SUVs. Today marked the deadline for Chrysler to formally respond to NHTSA, and it seems that both parties have met in the middle with Chrysler inspecting and upgrading some of the affected vehicles without using the word "recall," which would constitute the admission of a defect; instead, Chrysler said that it is conducting a "voluntary campaign."
At issue on these vehicles is the positioning of the fuel tank behind the rear axle that could get damaged during a rear-end collision. NHTSA has stated that at least 51 people have been killed in rear-end collisions involving these Jeeps after the vehicles caught fire, to which Chrysler countered by pointing out that both models "met and exceeded" the requirements for fuel-system integrity.
As a compromise on the situation, Chrysler says that it will inspect all pre-2004 Grand Cherokees and pre-2007 Liberty models and, "if necessary, provide an upgrade to the rear structure of the vehicle." According to Automotive News, this upgrade will consist of adding a trailer hitch that will presumably better protect the rear-mounted gas tank. Vehicles already equipped with a factory or Mopar hitch will not be modified. Chrysler's official statement on the matter is posted below, but no additional information has been released, such as when the campaign will begin and how many vehicles could be affected.

Chrysler axes old V6s, goes all-Pentastar

Old technology has a way of lingering on, particularly at Chrysler headquarters in Auburn Hills. So while the Pentastar V6 has replaced the older engine architecture in just about every application, it still soldiered on in some export markets. But the introduction of a new 3.0-liter Pentastar V6, produced in Michigan and meant only for the Chinese market, has put the final nail in the old engine's coffin.
Fitted into the 2014 Jeep Grand Cherokee and Jeep Wrangler just introduced to China at the Chengdu Motor Show, the downsized six uses the same architecture as the larger 3.6-liter Pentastar V6. But because of its 2,997cc capacity, it can be exported to China without the increased duty the 3.6-liter or even 3.2-liter Pentastar engines would incur. The 3.0-liter V6 develops 230 horsepower at 6,350 rpm and 210 pound-feet at 4,400 rpm.
Admittedly, it's unlikely, but even though the engine was said to be created solely to undercut tax thresholds in China and Europe, the 3.0-liter Pentastar has recently surfaced in rumors of an application here: as the boosted heart of a potential Cherokee SRT with anywhere from 375 to 410 hp.

Jeep reveals annual Moab Easter Jeep Safari concepts

Jeep has unveiled its annual spate of concepts before the Easter Jeep Safari. Those start with the Grand Cherokee Trailhawk Concept (below left), complete with the company's EcoDiesel V6 engine. Designers threw in a set of 35-inch Mickey Thompson tires wrapped around 17-inch Rubicon wheels, and a set of custom fender flares help keep all that rubber under wraps.
Meanwhile, the Wrangler Mopar Recon (below right) packs a 6.4-liter Hemi V8 good for 470 horsepower. All that grunt gets to the ground via a five-speed automatic transmission and a set of a Dana 60 axles frond and rear with 4.10 gears. The Recon also makes use of a 4.5-inch prototype long-arm kit and a set of prototype eight-lug bead lock wheels.
The Wrangler Stitch (below left) builds on the momentum of the Wrangler Pork Chop Concept. Engineers once again set out to strike as much weight as possible from the vehicle, and actually managed to trim the curb weight down to 3,000 pounds. That effort has given the machine the same power to weight ratio as the Grand Cherokee SRT8. Plenty of carbon fiber, door deletes and a chrome moly roll cage all help trim those pounds, and a set of DanyTrac Pro Rock 44 axles with 4.88 gears and ARB lockers front and rear let this machine scramble over whatever is in its path.