2007 Jeep Wrangler Sierra 4wd Unlimited on 2040-cars

Auto blog

Chrysler axes old V6s, goes all-Pentastar

Old technology has a way of lingering on, particularly at Chrysler headquarters in Auburn Hills. So while the Pentastar V6 has replaced the older engine architecture in just about every application, it still soldiered on in some export markets. But the introduction of a new 3.0-liter Pentastar V6, produced in Michigan and meant only for the Chinese market, has put the final nail in the old engine's coffin.
Fitted into the 2014 Jeep Grand Cherokee and Jeep Wrangler just introduced to China at the Chengdu Motor Show, the downsized six uses the same architecture as the larger 3.6-liter Pentastar V6. But because of its 2,997cc capacity, it can be exported to China without the increased duty the 3.6-liter or even 3.2-liter Pentastar engines would incur. The 3.0-liter V6 develops 230 horsepower at 6,350 rpm and 210 pound-feet at 4,400 rpm.
Admittedly, it's unlikely, but even though the engine was said to be created solely to undercut tax thresholds in China and Europe, the 3.0-liter Pentastar has recently surfaced in rumors of an application here: as the boosted heart of a potential Cherokee SRT with anywhere from 375 to 410 hp.

What's really going on with the 2014 Jeep Cherokee's transmission issues?

On September 23, Automotive News reported that Chrysler had idled the second shift workers it hired just five weeks prior at its Toledo Assembly Complex to build the 2014 Jeep Cherokee. At the time, Chrysler said it had "built the critical number of vehicles we need to stock dealerships once containment is released" and did not want "to put additional strain on our logistics partners ... upon release." That reasoning was not only unusual, it didn't seem to make sense.
It appears the center of the nine-speed issue is software, not hardware.
That same day, the Detroit News ran a piece claiming workers at the Toledo factory said the halt was due to issues with the Cherokee's transmission. It put the number of already-built Cherokees needing fixes at 1,000 and said that some of the workers not laid off had been instructed "to take the Jeep on long test-drives." That made more sense. Three days later, on September 26, Automotive News reported that the 500 workers laid off had been reinstated, with engineers "speeding repairs on the SUV's powertrain software." The AN piece didn't put a number on how many units are being fixed, but it did say that 12,000 have been built and are awaiting delivery to dealers. The best it could say about when dealers will get them, however, is that "progress on a fix is being made. It's unclear when shipments to dealers will start."

Chrysler recalls 468,700 Jeep Grand Cherokees, Commanders over rollaway risk

Chrysler has issued a recall covering a combined 469,000 units of the 2005-2010 Jeep Grand Cherokee and the 2006-2010 Jeep Commander (inset). Of that number, 295,000 are in the US, roughly 33,000 in Canada and Mexico and the remainder in other markets. It seems an electrical fault in the transfer case can allow the affected SUVs to shift into neutral on their own, while an Associated Press report says that Chrysler had "found cracks in a circuit board that turns the four-wheel-drive system on and off." The issue was discovered when an owner started his car remotely and it rolled away.
Chrysler is expected to begin notifying owners in June 2013, who can then take their cars to dealers. The dealer will reflash the final drive controller free of charge. There's a bulletin from the National Highway Traffic Safety Administration below with more information.