2022 Jeep Wagoneer Series Iii 4x4 on 2040-cars

Auto blog

100,000 Jeep Cherokee models subject to further 9-speed recalibration

It seems that the software problems with the nine-speed automatic gearbox in the Jeep Cherokee continue to mount. The programming already caused multiple development delays and even postponed the Cherokee's market launch by roughly two months. Now, Jeep has issued another recalibration to hopefully assuage unhappy drivers.
According to Automotive News, this reflash for the allegedly jerky transmission covers over 100,000 Cherokees built before May 5, but it's not technically a recall. If owners are having problems and complain to the dealer, they get the new software. Otherwise, they continue with the current version. New vehicles on dealer lots also receive the latest revision to the programming. It takes only around five minutes to install, but technicians need to take the Cherokee on a test drive to adapt the gearbox to the changes.
The Cherokee's transmission software has been problematic practically since the beginning. The Jeep plant in Toledo, OH, briefly idled its second-shift workers last year to take care of the issue. Since the launch issues for the crossover, demand has been strong. Jeep added another 1,000 temporary workers to the Toledo factory to keep up, and sales were on par with the Wrangler in just its first two months.

Chrysler recalls small number of 2013-2014 cars and trucks over engine debris

Chrysler is recalling a small number cars over issues with their 2.4-liter four-cylinder engines. The recall, which affects 522 examples of its 2013 Dodge Avenger and Chrysler 200 models, as well as 2014 Jeep Compass and Patriot CUVs has to do with potential debris in the balance shaft bearings.
The abrasive stuff can cause the oil pressure to drop, which could lead to the engine stalling or outright failure. This situation could at best leave drivers stranded and at worst lead to a crash.
Chrysler will begin notifying owners, who will need to report in to have the balance shaft module replaced. All repairs are naturally free of charge. Scroll down for the bulletin from NHTSA.

FCA's Pentastar V6 gets more power, efficiency for 2016

Already a vital member of FCA's powertrain lineup, the 3.6-liter Pentastar V6 is receiving major efficiency improvements for 2016. Thanks to a massive amount of new tech attached to the mill, fuel economy is up six percent, and torque below 3,000 rpm jumps nearly 15 percent. The updates arrive first in the 2016 Jeep Grand Cherokee, but they should proliferate to other models eventually. At least in the Grand Cherokee, the tweaks push power up five horsepower to 295 ponies. FCA's engineers went through the Pentastar from top to bottom to eke out as much efficiency as possible. For example, there's now a two-speed variable-valve lift system that can run in low- or high-lift modes. This upgrade is responsible for 2.7-percent better economy, the company claims. A new intake manifold with longer runners and updated variable-valve times also helps boost the torque output. Further improvements come from pushing the compression ratio to 11.3:1, from 10.2:1 before. Perhaps most impressive is that despite all of the innovations, the latest Pentastar actually weighs four pounds less than the current version. Beyond the Pentastar improvements, all of the FCA US gasoline engines, except for the Viper's 8.4-liter V10, will be E15-compatible for 2016. The company says that it wants to be ready for the higher ethanol content fuel's greater use in the near future.