2012 Jeep Grand Cherokee~overland~summit~4wd~nav~cam~htd/cld Lea~pano~we Finance on 2040-cars

Auto blog

Land Rover Defender V8 vs. Jeep Wrangler Rubicon 392 | V8 4x4s square off on paper

Land Rover pulled the sheet off its 2022 Defender on Wednesday, introducing another high-performance V8 to the off-road segment. This time, it's a 5.0-liter, supercharged V8 boasting 518 horsepower. It will be available in both the Defender 90 and 110 models. In the former, Land Rover says it can crack off a 0-60 run in just 4.9 seconds on its way to a top speed of 149 mph. The long-wheelbase 110 will be a bit slower, but "slow" probably isn't the right adjective to use here at all.  But Land Rover isn't the only automaker offering a high-performance variant of its off-road SUV. While Jeep may have been sneered at for presenting the 2021 Wrangler Rubicon 392 on the heels of the 2021 Ford Bronco's introduction, it starts to make a lot more sense in this context. There's reportedly a high-output Bronco on the way, too, so call Jeep the dinosaur of the group all you want, but you can't put a price on being first. Well, you can, actually, but that's not the point.  Thankfully, both Land Rover and Jeep have provided enough specs for us to rough out a comparison chart. Since the Rubicon 392 is offered only in four-door guise, we're looking at the long-wheelbase Defender 110 as its direct competitor here. Have a look: There are a few caveats to mention off the top. For starters, we don't have an official curb weight for the V8-powered Defender yet, as Land Rover has not finalized its U.S. specs. We used the European figures (as provided by a spokesperson), which we expect to be accurate within about 50 pounds. The 0-60 time provided by Land Rover was for the Defender 90, which is smaller and somewhat lighter than the 110. When equipped with the inline-6, the Defender 110 is about a tenth of a second slower to 60 than the Defender 90, so we figure it should be roughly the same for the V8.  While the Defender has nearly 50 horsepower on the Wrangler, that advantage disappears thanks to the Land Rover V8's monster weight penalty, which will fall somewhere between 600 and 700 pounds depending on equipment. Yikes. On the flip side, however, the Land Rover has the edge in top speed, and it's not even close. Chalk that up to the tires, we suspect. We know for a fact that the Rubicon 392's all-terrains dictate its speed limiter; Jeep's own engineers told us as much. This could make for a (hypothetically) interesting drag race, as the Jeep's advantage off the line may evaporate once triple digits come into play.

FCA's Pentastar V6 gets more power, efficiency for 2016

Already a vital member of FCA's powertrain lineup, the 3.6-liter Pentastar V6 is receiving major efficiency improvements for 2016. Thanks to a massive amount of new tech attached to the mill, fuel economy is up six percent, and torque below 3,000 rpm jumps nearly 15 percent. The updates arrive first in the 2016 Jeep Grand Cherokee, but they should proliferate to other models eventually. At least in the Grand Cherokee, the tweaks push power up five horsepower to 295 ponies. FCA's engineers went through the Pentastar from top to bottom to eke out as much efficiency as possible. For example, there's now a two-speed variable-valve lift system that can run in low- or high-lift modes. This upgrade is responsible for 2.7-percent better economy, the company claims. A new intake manifold with longer runners and updated variable-valve times also helps boost the torque output. Further improvements come from pushing the compression ratio to 11.3:1, from 10.2:1 before. Perhaps most impressive is that despite all of the innovations, the latest Pentastar actually weighs four pounds less than the current version. Beyond the Pentastar improvements, all of the FCA US gasoline engines, except for the Viper's 8.4-liter V10, will be E15-compatible for 2016. The company says that it wants to be ready for the higher ethanol content fuel's greater use in the near future.

NHTSA investigating why Jeep recall fix is taking so long

Jeep's saga with the National Traffic Safety Administration and the voluntary campaign to repair 1.56 million vehicles for allegedly unsafe trailer hitches, is getting yet another chapter. The controversy appeared to finally be over in January when the automaker found a supplier for the replacement parts. Nothing is ever that easy, though, and the government regulator is now requesting documents from the company to clarify why the repairs are taking so long to begin.
Jeep parent company Chrysler has until July 16 to submit documents and answers to NHTSA explaining the situation. The regulator claims that despite its compromise to inspect and repair the models with improper hitches in June 2013, Chrysler didn't find a part supplier until December and didn't order the replacements until January. The government agency believes that the first components weren't manufactured until May of this year and vehicles may not actually be repaired until as late as August. According to the report, if the Chrysler doesn't supply what NHTSA is asking for, the agency could "take additional appropriate action as warranted."
Throughout this entire process, Chrysler has asserted that the vehicles met the applicable crash test standards of the time, and it has kept NHTSA abreast of the repair activity. In a recently released statement it said that the regulator analyzed eight rear impact reconstruction tests and found the replacement hitch to be safe. To keep up with the high demand for replacements, Chrysler is working with multiple suppliers, and they are running three shifts, six days a week to get the parts ready as soon as possible.