1964 Jaguar E Type 3.8 Fixed Head Coupe ... Rare Opalescent Sand on 2040-cars

Auto blog

Driving Jaguar's Continuation Lightweight E-Type

Something has happened to sports cars over the past 15-20 years. While reaching ever-higher levels of quantitative dominance the driving experience continues to become more sterile. Stability control, torque vectoring, variable electronic steering racks, lightning-quick dual-clutch automatic transmissions – all these make it easier to harness more power and drive faster than ever before. And yet too often it feels like something is missing. There is a growing divide between the capabilities of the modern performance car and the driver's sense of connection to the experience. In an era like the one we're in now, the Jaguar Lightweight E-Type hits you like a slap in the face. The story of the Lightweight E-Type goes back to 1963, when Jaguar set aside eighteen chassis numbers for a run of "Special GT E-Type" cars. These were factory-built racers with aluminum bodies, powered by the aluminum-block, 3.8-liter inline-six found in Jaguar's C- and D-Type LeMans racecars of the 1950s. Of the eighteen cars slated for production, only twelve were built and delivered to customers in 1964. For the next fifty years, those last six chassis numbers lay dormant, until their rediscovery a couple of years ago in a book in Jaguar's archives. In an era like the one we're in now, the Jaguar Lightweight E-Type hits you like a slap in the face. Jaguar Heritage, a section of Jaguar Land Rover's new Special Vehicle Operations (SVO) division, took on the task of researching the original Lightweight E-Types and developing the methods to create new ones. Every aspect of the continuation Lightweight E-Type, from the development of the tools and molds used to build the cars, to the hand-craftsmanship, reflects doing things the hard way. They may not build them like they used to, but with these six special E-Types, Jaguar comes awfuly close, if not better. Working alongside the design team, Jaguar Heritage made a CAD scan of one side of an original Lightweight E-Type body. That scan was flipped to create a full car's worth of measurements. That ensured greater symmetry and better fit than on the original Lightweight E-Types (which could see five to ten millimeter variance, left-to-right). The scan was also used to perfect the frame, while Jaguar looked through notes in its crash repair books to reverse-engineer the Lightweight E-Type's suspension. The team repurposed a lot of existing tooling for the continuation cars, and developed the rest from analysis of the CAD scan.

2014 Jaguar XFR-S super sedan is 550-HP worth of cool

The 2014 Jaguar XFR-S was considered last year, teased last week and now has been totally let loose. The most powerful sedan the company has ever made and the newest addition to its line of R-S performance cars - following the XKR-S - and we'll be getting even fewer of them than we thought. 200 had been the rumored allotment for the US, but the official word now is that we'll see just 100.
Each XFR-S will use the same 5.0-liter supercharged V8 that powers the XKR-S, meaning a 40-horsepower and 41-pound-foot bump over the XFR for 550 hp and 502 lb-ft in total. Shifting through the adaptive, eight-speed ZF transmission gets it from standstill to 60 mph in 4.4 seconds, but for all that, it gets the same gas mileage as the XFR, aided by its stop/start system, and so doesn't get hit with a gas guzzler tax.
Other XKR-S bits have made the jump, including an upgraded suspension front and rear, the near-straight pipes for the cracking exhaust note we drank up like ambrosia and twenty-inch, six-spoke lightweight wheels that are an inch wider than on the XFR. Lateral stiffness is up 30 percent, the electronic systems have been recalibrated to handle the extra oomph, throttle response has been sharpened and can be made even sharper by going into Dynamic Mode.

Jaguar Land Rover offers (some) detail about new Ingenium engine

Jaguar Land Rover officially announced its Ingenium family of engines with the unveiling of the 2.0-liter version in the Jaguar XE concept at the 2014 Geneva Motor Show, but it kept details very thin at the time. All we knew was that the new turbocharged mills could be configured to use gasoline or diesel, and be positioned longitudinally or transversely. Months later, JLR is finally letting some more info slip about its new baby, but there are still some big questions to be answered.
For the Ingenium project, Jaguar Land Rover gave its engineers a clean sheet of paper and told them not to worry about using any previous parts or machinery. In the end, the designers came up with a family of turbocharged, aluminum-block engines based around modular, 500cc cylinders to allow it to grow or shrink as the market demanded. The layout was also made adaptable enough to incorporate hybrid drivetrains, if needed. "Being configurable and flexible are the two key strands of Ingenium's DNA because we have future-proofed our new engines from the outset," said said Ron Lee, the company's director of Powertrain Engineering.
To maximize efficiency, Jaguar promises that all versions of the Ingenium engines come with computer-controlled, variable oil pumps and water pumps to use only as much energy as needed. They also get direct injection, roller bearings for the cams and stop/start. The diesel version alone has 17 percent less internal friction than the mill it replaces, the company claims. JLR is also promising class-leading figures for Ingenium's torque and horsepower too, but it's not giving away those specs just yet.