Free Shipping Cont Usa! Donohoo, Deluxe Touring, Navigation, Heated Seats on 2040-cars

Auto blog

F1-inspired, 563-horsepower Infiniti Q60 Project Black S details finally revealed

Despite being first revealed at the 2017 Geneva Motor Show, Infiniti has been quite coy concerning the details of its F1-inspired hybrid super coupe, the Q60 Black S. That ends at this year's Paris Motor Show, where the company has finally spilled specific information about the car. It's technologically fascinating, even if the on-paper performance doesn't sound all that shocking. Total power output of the concept, now called Q60 Project Black S, is 563 horsepower, with final torque figures yet to be announced. That power comes from a combination of the twin-turbocharged 3.0-liter V6 found in the Q60 Red Sport 400, along with a trio of motor-generator units that have similar functionality as those found in the Renault Sport F1 car's KERS (Kinetic Energy Recovery System). One large one is connected to the rear axle and generates electricity under deceleration like most hybrids, and it can deliver 160 horsepower under acceleration. The other two motor-generators are coupled to the turbochargers. They generate power under acceleration as the turbines spin. They also act as an electrical anti-lag system, spinning up the turbines when hitting the throttle again after it has been closed in order to provide maximum boost immediately. Power for and from these motor-generators is stored in a 4.4-kWh lithium-ion battery pack. All the powertrain's power goes through a seven-speed automatic transmission to the rear wheels via a mechanical limited-slip differential. The company claims it can hit 62 mph in under 4 seconds. One of the advantages of this powertrain is that electricity is generated both on acceleration and deceleration, which helps maintain battery charge so the motor assistance can be used more of the time. How aggressive the car is with the electrical boost is determined by which mode the vehicle is in, Road, Quali (for qualifying), or Race. Road is the most conservative, whereas Quali is the most aggressive. The reason for this is that if you're qualifying, you have to go the fastest you can in a short amount of time. A digital simulation of the car running a lap in Quali mode at Circuit de Catalunya estimated it would use 15 percent of the battery charge. That means it could do a little over six laps in that mode and maintain full use of its electrical assists. Race mode conserves battery life more, since you'll want that power over the course of the race. A downside to the Project Black S hybrid system is that it's really heavy.

Infiniti Q50 Eau Rouge Concept bows again, now with more GT-R [w/video]

Think back to the 2014 Detroit Auto Show and you'll remember the Infiniti Q50 Eau Rouge concept - a sedan that showed the potential design direction for a seriously high-performance take on the Japanese automaker's new entry-level luxury sedan. And while the show car we saw in Detroit was all well and good, it lacked something. Specifically, an engine. Kind of an important thing for a performance concept, right?
Here in Geneva, Infiniti rolled out that same Q50 Eau Rouge, but with one major modification: the sedan now boasts a twin-turbocharged 3.8-liter V6 under its hood - the same engine that's found in the Nissan GT-R supercar. In the Eau Rouge, this V6 is tuned to produce 560 horsepower and 443 pound-feet of torque, sent to the ground via the GT-R's all-wheel-drive system. Of course, this super-hot Q50 is still purely a concept, but Infiniti says that the potent engine underhood will allow the sedan to sprint to 60 miles per hour in less than four seconds, on its way to a top speed of over 180 mph.
The oft-fabled "four-door GT-R" still isn't confirmed for production, so for now, all we can do is cross our fingers (and toes). Check out the Q50 and its new beating heart in the gallery, above, and scroll below to hear what that potent Eau Rouge sounds like.

Nissan recalls Rogue, Pathfinder, Infiniti QX60 for seat issue

Nissan and Infiniti are recalling their 2023 Rogue, Pathfinder and QX60 SUVs and CUVs to address a potential defect in their seat frame welds that can allow the frames to fail in the event of a collision. The number of vehicles that potentially shipped with weak welds is rather small — just over 12,000 — but the issue could nonetheless lead to injury if a failure occurs during a collision.  "The driverÂ’s powered seat may not be fully secured to the seat frame on certain Nissan Rogue, Pathfinder, and INFINTI QX60 vehicles," Nissan's report to NHTSA said. "As a result of this issue, the seat frame welds may detach from the rear inboard seat bracket. If this condition occurs, it may increase the risk of injury to the occupant in the event of a crash. In addition, the seat frame assembly may not meet certain FMVSS 207 and FMVSS 210 requirements because of this condition," Nissan said.  Nissan says there's no easy way for customers to detect the issue ahead of time, and that its seats need to be inspected by a service tech to see whether it is properly secured. Dealers will be instructed to check the driverÂ’s seat rail clearance to the inboard seat bracket, and if necessary, the dealer will remove and replace the affected driverÂ’s seat cushion frame, NIssan said. The entire procedure should take less than two hours.  Owners of affected vehicles should look for notices to be delivered no later than June.  Related video: This content is hosted by a third party. To view it, please update your privacy preferences. Manage Settings. Recalls Infiniti Nissan Crossover SUV Luxury