2006 Infiniti G35 Sport Coupe Navigation 6speed Ext Warranty on 2040-cars

Auto blog

Infiniti Q60 Project Black S packs F1-derived hybrid twin-turbo V6

At the 2017 Geneva Motor Show, Infiniti unveiled the Project Black S, a souped-up version of the Q60 coupe that packed technology derived from the Renault Sport Formula 1 Team's race cars. Details were scarce. Aside from some F1-inspired bodywork, all we knew was that the twin-turbo V6 would be paired with a kinetic energy recovery system, or KERS for short. At next week's Paris Motor Show, Infiniti is bringing a new concept that's a bit more polished as well as some additional details about what rests under the hood. The car is still dubbed the Infiniti Project Black S. The car still packs a twin-turbocharged 3.0-liter V6 paired with an energy recovery system. Infiniti claims the car makes 563 horsepower, up from 400 in the Q60 Red Sport 400. The Project Black S should hit 60 mph in fewer than four seconds. The powertrain uses three motor generator units (MGU) and a single MGU-K that harvests brake energy. Two electric turbochargers harvest heat energy from the exhaust, meaning the car can gain energy both under braking and acceleration. Visually, there's not much that's changed from last year's Geneva concept. We only have one new photo, but to our eyes the only difference is a few yellow accents on the front bumper. We'll have to wait until next week's reveal for more photos. Related Video:

2022 Infiniti QX60 spied running around post-Monograph Concept reveal

Infiniti recently revealed the QX60 Monograph Concept, a concept crossover meant to preview the next generation QX60. Today, the first spy shots of the QX60 in production form hit our desks. There’s a whole lot we canÂ’t see under the camouflage, but it looks fairly representative of what we expect a production version of the Monograph Concept would look like. The headlights, grille design, lower opening and side air intakes all look like they were pulled straight off the concept. It also has the same hood design with raised outer edges that lead right into the A-pillar. Its droopy side camouflage does a good job of disguising its curvaceous profile and pronounced rear fenders. We can see a hint of widening at the rear fenders, and we hope that the MonographÂ’s look is translated over to production there. The mirrors were moved further down onto the doors, and the flush door handles are done away with. This tester appears much less flamboyant with normal-size wheels replacing the giant and dramatic spinners on the Concept (gallery of the concept below). Infiniti QX60 Monograph View 36 Photos Infiniti is copying the shape of the rear over to production. We can clearly make out the raked rear window, overhanging spoiler and rounded shape of the back end. The taillights are a bit difficult to see, but their general design matches up to the Concept. As for the fancy chromed exhaust area on the concept, those spots appear flat and barren on this preproduction model. ItÂ’s still heavily covered in camo, though, so we donÂ’t yet know what the rear bumper design will look like in its final form. The production QX60 is set to be revealed next year where it will likely go on sale as a 2022 model year car. ItÂ’s unclear what powertrain(s) will be lurking under the hood, but at least we know the production version wonÂ’t stray terribly far from the concept now. Related Video:

The yin and yang of the 2017 Infiniti Q50 Red Sport 400

When we first drove the Q50 Red Sport 400, Infiniti had the car out at a prepared slalom-and-cone course in a large, open parking lot. The car was stacked up against another Q50 without the Direct Adaptive Steer steer-by-wire system, and the course was designed to show that the DAS-equipped Red Sport 400 (it's a $1,000 option) required less steering input to master the same course. With all due respect to Infiniti, which is invested in this unfortunate system and has been working hard to revise it, the comparison doesn't make a lot of sense. The non-DAS Red Sport 400 has a steering ratio of 15:1 in RWD and 16.7:1 in AWD forms. The DAS system can vary between 12:1 and 32.9:1 in RWD and 11.8:1 to 32.3:1 in AWD flavors. At its extremes, the DAS system's ratio is vastly different than the fixed-ratio cars. So sure, with a super-quick steering ratio available, the DAS driver's going to do less work. It's all in the gearing. Does this mean it's better, that the steering feel is more natural, that it's easier to hustle quickly? The amount the driver saws at the wheel isn't an indication of that, necessarily. After a few days in a rear-drive Red Sport 400, I'm saying that the spooky disconnection between the driver and the front wheels would be a severe deficit to a driver on a real autocross course. It's not like the DAS system is choosing bad ratios within its range, it's just not supplying the feedback to make it enjoyable. Knowing what your front tires are up to is critical. I can hear you saying right now, "But what Q50 Red Sport 400 owners are going to autocross their cars?" Sure, but it was just a means to an end: showing off the DAS in a good light. And in that case, it probably did. The thing is, in isolation, not back-to-back with a non-DAS car with a slow steering ratio, the DAS system has the same issues it's always had: It simply doesn't feel natural. It doesn't feel intuitive. There doesn't seem to be any real advantage over a slightly quicker rack. I don't hear about people making buying decisions based on how much work they have to do sawing at the wheel, do you? So, that's one side of the Q50 coin – one that's hard to ignore if you're an enthusiast and steering feel is an important connection between you and the vehicle you just dropped a large hunk of change on, and will be spending a lot of your time in. The other is that there's a really compelling reason to drive a Red Sport 400: The 3.0-liter, twin-turbocharged V6 is a monster.