2009 Infiniti G37 Base Sedan 4-door 3.7l on 2040-cars

Auto blog

Infiniti Prototype 9 is a wonderfully beautiful EV grand prix car

Few automobiles are as elegantly beautiful as the open-wheel grand prix cars of the 1940s, '50s and '60s. The simple, slender shapes of these cars bear no extravagant flourishes or adornments. The purposeful design is what gave these cars their beauty, and it's these classic machines that inspired the new Infiniti Prototype 9. Teased earlier this week, this concept blends old and new, with classic lines hiding a modern all-electric powertrain. The Prototype 9 will make its full debut next week at the 2017 Pebble Beach Concours d'Elegance. Infiniti says the car was built around a simple idea: what would a 1940s Infiniti grand prix car look like? While the silver paint may be more German than Japanese, the design could easily be mistaken for an actual '40s grand prix car. Only the Infiniti-styled grille gives it away. Everything about it, from the thin bias-ply tires wrapped over center-locking wire wheels to the bulging screws around the driver's seat, is pitch perfect. Underneath that achingly long hood rests a prototype electric motor and battery from Nissan's Advanced Powertrain Department. The combo sends 148 horsepower and 236 pound-feet of torque straight to the rear wheels. That's good enough to send the svelte 1,962 lb car to 62 mph in just 5.5 seconds. Top speed is right at 106 mph. While speed may die off towards the top end, all that torque and a 43/57 front to rear weight distribution should make the Prototype 9 a riot on a small, tight circuit. There's only enough juice in the battery for about 20 minutes of flat-out racing. The handmade steel body rests on a steel ladder-frame chassis. The front suspension uses a leading-arm rigid axle with transverse leaf spring while the rear uses a De Dion axle, also with a transverse leaf spring. The Prototype 9 also uses old-school hydraulic rotary type dampers. There's no power steering and no brake booster for the four-wheel disc brakes. The car was designed and built by a number of different departments within Infiniti and Nissan. A simple sketch expanded as more and more designers and engineers wanted to have a hand in the project. The steel body panels were all shaped and hammered by hand. The bare cockpit is only adorned with a thin seat, three gauges, a few switches, a gear selector and the steering wheel. The gauges are set into a fixed aluminum hub in the center of the steering wheel.

NHTSA opens investigation into Nissan's handling of airbag recall

In March of 2014, Nissan recalled eight models among its Nissan and Infiniti brands, totaling more than one million vehicles, over faulty occupant classification system software controlling the passenger airbag. The company discovered a variety of factors that would interfere with the system's ability to detect an adult passenger in the shotgun seat, resulting in an illuminated warning on on the dashboard and the passenger airbag not deploying in an accident. Yet 124 complaints submitted to the National Highway Traffic Safety Administration since the recall allege that the dealer-installed fix hasn't actually fixed the problem; some consumers say the problem persists after multiple trips to the dealer. The Detroit News reports that NHTSA is opening an investigation into the matter to determine whether a new recall is needed. The occupant sensor has been a bugbear for Nissan over the past couple of years; a much smaller recall for the issue in 2013 covered five of the eight vehicles that were recalled in 2014, and that earlier recall also continued to generate complaints after the issue had supposedly been fixed. At the same time, the company learned that in two instances there was another twist, where the dashboard warning wasn't illuminated but the passenger airbag still didn't go off in an accident. Nissan isn't alone, though, with airbag recalls on a steep upswing across the industry even before the Takata debacle.

Nissan recalls 226k vehicles over airbag inflators

Nissan and Infiniti are the latest automakers to issue recalls involving faulty airbag inflators from Takata. The Japanese automakers have announced campaigns covering about 226,326 units from seven models built in the early 2000s because they contain the bad part in the passenger-side, front airbag. The affected vehicles include the 2002-2004 Nissan Sentra, 2002-2003 Pathfinder and 2002-2003 Maxima, and it also covers the 2002-2003 Infiniti QX4, 2002-2003 I35, 2003 FX45 and 2003 FX35.
Like the other vehicles with the faulty inflators, it's possible for the part to rupture during airbag deployment and spray metal shrapnel at occupants. Nissan and Infiniti have even included vehicles with replacement airbags in this campaign because those parts also could have been defective. Both companies were also part of the earlier regional campaign to fix cars in high-humidity climates where the problem has been found to be the worst.
As is the usual response, Nissan and Infiniti will notify owners of the affected vehicles and will make the repair at no charge. According to the filing with the National Highway Traffic Safety Administration, these fixes will commence around August 11. Scroll down to read the report from NHTSA, or read the full defect notice as a PDF, here.